Information Center, Vehicle ................. 203
Inside Rearview Mirror .................... 87
Instrument Cluster .................... 187,189
Instrument Panel and Controls .............. 186
Instrument Panel Lens Cleaning ............. 435
Integrated Power Module (Fuses) ............ 435
Integrated Trailer Brake Controls ............. 354
Interior Appearance Care .................. 433
Interior Lights .......................... 150
Intermittent Wipers (Delay Wipers) ........... 155
Introduction ............................. 4
Inverter Outlet (115V) ..................... 170
Jack Location ........................... 376
Jump Starting .......................... 388
Key-In Reminder ......................... 16
Key, Programming ........................ 18
Key, Replacement ........................ 17 Key, Sentry (Immobilizer) ................... 16
Keyless Entry System ...................... 21
Keys ................................. 12
Lane Change and Turn Signals .............. 153
Lane Change Assist ...................... 154
Lap Belts .............................. 48
Lap/Shoulder Belts ....................... 39
LATCH
(Lower Anchors and Tether for CHildren) ....... 68
Latches ................................ 81
Leaks, Fluid ............................ 81
Life of Tires ............................ 328
Light Bulbs ............................. 81
Lights .............................. 81,147
Airbag ...................... 58,62,79,200
Alarm ............................ 192
Anti-Lock .......................... 200
Anti-Lock Warning ................... 308
10 INDEX 489
INSTALLATION OF RADIO TRA
NSMITTING
EQUIPMENT
Special design considerations are incorporated into this vehi-
cle’s electronic system to provide immunity to radio frequency
signals. Mobile two-way radios and telephone equipment must
be installed properly by trained personnel. The following must
be observed during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The
negative power connection should be made to body sheet
metal adjacent to the negative battery connection. This con-
nection should not be fused.
Antennas for two-way radios should be mounted on the roof or
the rear area of the vehicle. Care should be used in mounting
antennas with magnet bases. Magnets may affect the accu-
racy or operation of the compass on vehicles so equipped.
The antenna cable should be as short as practical and routed
away from the vehicle wiring when possible. Use only fully
shielded coaxial cable.
Carefully match the antenna and cable to the radio to ensure a
low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than nor-
mal may require special precautions.
All installations should be checked for possible interference
between the communications equipment and the vehicle’s
electronic systems.
