Practical information
96
Changing a wheel
To o l s r equired
- A jack: for lifting the vehicle.
- A wheelbrace: for removin
g and refitting
the wheel bolts.
- A handle: for operating the jack.
These tools are not supplied with your vehicle.
Parking the vehicle
Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the ignition and put the drive selector
in position Pto lock the wheels.
If necessary, place a chock under thewheel diagonally opposite the wheel to be changed.
You must ensure that the occupants get out of the vehicle and wait where they are safe. Never go underneath a vehicle raised using a jack; use an axle stand.
Wheel with wheel trim
When removing the wheel , firstremove the wheel trim using the wheelbrace, by pulling at the valve hole.When fitting the wheel, refit the wheeltrim star ting by aligning the valve hole
with the valve, and then press on theedge of the trim with the palm of your hand.
8
Practical information
97
FSlacken the bolts using the wheelbrace.FPlace the jack in contact with one of the
two front A or rear B
locations provided on
the underbody, whichever is closest to the
wheel to be changed.
Removing the wheel
F
Using the handle, extend the jack until its base plate is in contact with the ground.
Ensure that the centreline of the jack base
plate is directly below the location A or Bused.F
Raise the vehicle until there is sufficientspace between the wheel and the ground.
F
Remove the bolts and store them in a clean place. F
Remove the wheel.
Practical information
98
Fitting the wheel
FPut the wheel in place on the hub. FScrew in the bolts by hand.FPre-tighten the bolts using the wheelbrace.
F
Lower the vehicle fully. F
Fold the jack and detach it.FTighten the bolts using the wheelbrace.
After changing a wheel
Have the tightening of the bolts andthe pressure of the new wheel checked by a PEUGEOT dealer or a qualifiedworkshop without delay.
8
Practical information
113
Accessories
A wide range of accessories and genuine par ts is available from the PEUGEOT dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from PEUGEOT's recommendation and warranty.
Conversion kits
You can obtain an "Enterprise" kit to conver t a
trade vehicle to a private car and vice-versa.
"Comfort":
black armrest, reading lamp, insulated
modules, rear parking sensors, cigarette lighter,ashtray with base, head restraint mounted coathanger...
"Transport solutions":
boot liner, boot carpet, rear parcel shelf, boot dividers...
"Security and safety":
alarm, wheel security bolts, child seats,
breathalyzer, warning triangle, high visibility
vest, first aid kit, snow chains, non-slip covers,
pet transpor t ca
ge, pet safety belt...
Precautions for
washing
To avoid damaging the electrical components, the use of a high pressure jet wash is strictly prohibited:
- in the front compar tment (under thebonnet),
- under the body.
For washing the body, do not use a pressure greater than 80 bars.
Check - before washing the vehicle -that the charging flaps and the charging socket covers (normal and fast charge) are properly closed.
Do not wash the vehicle while the
battery is being recharged.
