33
2
READY TO SET OFF
Instruments and controls
   
Warning lamp    
is    
indicates    
Solution - action  
 
  
Water in Diesel 
filter   on, accompanied 
by a message on 
the screen.   that there is water in the Diesel 
fuel filter.   Have the filter bled by a PEUGEOT dealer. 
 Refer to the "Checks" section of chapter 7. 
    
Low fuel level   on with the 
gauge needle in 
zone E.   that the fuel reserved is being 
used.   Fill up with fuel without delay. The calculation of the 
remaining fuel depends on the style of driving, the profile 
of the road, the time elapsed and the distance travelled 
since the warning lamp first came on. 
  flashing.  a malfunction.   Consult a PEUGEOT dealer. 
 
  
Diesel 
pre-heating   on.   that the weather conditions 
impose pre-heating.   Wait for the warning lamp to switch off before operating 
the starter. 
    
Sidelamps   on, accompanied 
by a message on 
the screen.   manual selection.   Turn the ring on the lighting stalk to the first position. 
  automatic illumination of 
headlamps, ring in position A.   Adjust the sensitivity of the sunshine sensor via the 
MODE menu. Refer to the "Mode" section of chapter 4. 
   
 
Dipped beam 
headlamps 
  on.   manual selection.   Turn the ring on the lighting stalk to the second position. 
  Main beam 
headlamps   pulling of the stalk towards you.   Pull the stalk to return to dipped beam headlamps.  
34
   
 
Instruments and controls  
 
   
Warning lamp    
is    
indicates    
Solution - action  
 
  
Direction 
indicators   flashing with 
buzzer.   a change of direction using the 
lighting stalk, to the left of the 
steering wheel.   To the Right: press the stalk upwards.  
To the Left: press the stalk downwards. 
    
Front foglamps   on.   that the button on the centre 
console has been pressed.   Manual selection.  
The foglamps only operate if the sidelamps or dipped 
beam headlamps are on. 
    
Rear foglamps   on.   that the button on the centre 
console has been pressed.   Manual selection. The foglamps only operate if the 
sidelamps or dipped beam headlamps are on. When 
visibility is normal, please switch the foglamps off. 
    
Cruise control   on.   that the cruise control has been 
selected.   Manual selection.  
Refer to the "Steering mounted controls" section of 
chapter 3. 
    
Faulty bulb   on accompanied 
by a message 
on the screen.   that one or more bulbs have 
blown.   Have the bulb changed.  
Refer to the "Changing a bulb" section of chapter 8 or 
contact a PEUGEOT dealer. 
    
Rear parking 
sensors   on.  failure of the system.   The audible assistance is no longer active.  
Have the system checked by a PEUGEOT dealer 
without delay.  
45
3
EASE OF USE AND COMFOR
T
Steering mounted controls
WIPER STALK  Slow continuous wiping: 2 notches downwards. 
 
Do not cover the rain sensor, located at 
the top centre of the windscreen. 
  When washing the vehicle, switch off the 
ignition or deactivate the automatic rain 
sensitive wipers.  
Screenwash  
 and headlamp wash  
 
Pull the stalk towards you, the wash-wipe 
is accompanied by a timed operation the 
wipers. 
  The headlamp wash is linked with the 
screenwash, it is triggered if the dipped 
beam headlamps are on. 
Windscreen wipers
  Wiping is only active when the ignition key is 
in the  RUNNING 
 position. 
  The stalk has five different positions: 
  Wipers off. 
  Intermittent wiping: 
  1 notch downwards. 
  In this position, four speeds can be 
selected by turning the ring: 
   
 
-   very slow intermittent, 
   
-  slow intermittent, 
   
-  intermittent, 
   
-  fast intermittent.  
 
 
Automatic rain sensitive windscreen
wipers
  If your vehicle is fitted with this system, the 
wiping speed is adapted automatically to the 
intensity of the rainfall. 
  Automatic wiping: 1 notch downwards. 
This is confirmed by one wipe. Must be 
reactivated each time the ignition is 
switched on. 
  In this position, the sensitivity of the rain 
sensor can be increased by turning the ring. 
Good practice
  Check that the windscreen wiper blades can 
operate freely when using the wipers in icy 
weather. 
  Use the step in the front bumper, to remove 
any accumulation of snow at the base of 
the windscreen and on the blades. 
   
To change the blades, refer to the 
"Changing a wiper blade" section of 
chapter 8.  
  To top up the levels, refer to the 
"Levels" section of chapter 7.     Fast continuous wiping: 3 notches 
downwards. 
  Single wipe, pull the control towards the 
steering wheel.