152
!
Visibility
Rear wiper 
  If a significant accumulation of snow or ice is present, or when using a bicyclecarrier on the boot, deactivate theautomatic rear wiper via the instrument panel screen configuration menu.  Rear wiper selection rin
g: 
park, 
intermittent wipe,
wash-wipe 
(set duration).  
 
 Reverse gear 
 When reverse gear is engaged, the rear wiper 
will come into operation if the windscreen 
wipers are operating.  
  Th
e function is activated or 
deactivated via the instrument panel 
screen confi
guration menu. 
  This function is activated by default.  
 
 
 Programming
 )Pull the windscreen wiper stalk towards you. The windscreen wash then the 
windscreen wipers operate for a fixed period.
  The headlamp washers only operate when  the 
dipped beam headlamps are on . 
 
Windscreen and headlamp 
wash 
Screenwash/headlamp washlevel low
  In the case of vehicles fittedwith headlamp washers, when 
the fluid reservoir low level 
is reached this warning lamp comes on in the
instrument panel, accompanied by an audible signaland a message in the instrument panel screen.  The warning lamp comes on when the ignition
is switched on, or every time the stalk is 
operated, until the reser voir is refilled.
  Next time 
you stop, refill the screenwash/headlamp wash reser voir. 
9
219
Checks
Coolant level 
The coolant level should be closeto the "MA X" mark but should never exceed it.When the engine is warm, the 
temperature of the coolant is regulated by the fan. This can operate with the ignition off.
On vehicles which are fitted with a par ticle 
emission filter, the fan may operate after the vehicle has been switched off, even if the engine is cold.
  In addition, as the cooling system is pressurised, 
wait at least one hour after switching off 
the engine before carrying out any work. 
  To avoid any risk of scalding, unscrew the cap 
b
y two turns to allow the pressure to drop.
When the pressure has dropped, remove the
cap and top up the level.
Changing the coolant 
The coolant does not have to be changed.  
Fluid specifi cation 
The coolant must conform to the 
manufacturer's recommendations.  
  
 
Fluid specifi cation
 
For optimum cleaning and to avoid freezing, 
this fluid must not be topped up with or 
replaced with plain water.
Screenwash and headlamp 
wash fluid 
   
In the case of vehicles fitted with
headlamp washers, the low fluid level is indicated by an audible signal anda message in the instrument panelscreen. 
  Top up the reser voir when you next stop the
vehicle.