Page 47 of 302
1
45
Instruments and controls
Instrument panel
1.
Energy consumption/generation indicator (power available as a percentage) For more information refer to the "Hybrid system" section. 2.Ready lamp.
Indicates that the vehicle is ready to drive. 3.Engine oil temperature gauge. 4. Fuel gauge.
5. Engine coolant temperature gauge.
6.Speedometer (mph or km/h).
7. Cruise control or speed limiter settings.
A.Main lighting dimmer. B.
Display of aler t log.
Recall of the service information.
C. Reset the trip distance recorder.
8. Gear lever position and gear for anelectronic gear control gearbox.
9. Display zone: hybrid flow, alert messages
or state of functions, trip computer.
10.Trip distance recorder (miles or km). 11.Automatic wipersSer vice indicator (miles or km) then,
total distance recorder.
These two functions are displayedsuccessively when switching on
the ignition.
Dials and screens
Control buttons
Page 48 of 302
46
!
Instruments and controls
Indicator and warning lamps
Visual indicators informing the driver that a system is in operation, switched off or has a fault.
When the ignition is switched on
Certain warning lamps come on for a few seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to
the information on the warning lamp concerned.
Associated warnings
The switching on of cer tain warning lamps maybe accompanied by an audible signal and a message in the instrument panel screen.
The warning lamps may come on continuously(fixed) or flash.
Certain warning lamps may come on inone of two modes. Only by relating thetype of lighting to the operating status
of the vehicle can it be ascertainedwhether the situation is normal or whether a fault has occurred.
1
2
2
2
3
3
3
2
3
3
With the vehicle stationar y
, use the left handythumb wheel to move through the menus, so as to configure the vehicle settings (driving andcomfort systems, ...).
- Rotation (other than menu): scroll through
the list of active functions available,
- Press: main menu, confirm the selection,
- Rotation (in a menu): move up or down in
the menu.
Main menu
Vehicle parameters Screen settin
gs
Preheatin
g/Preventilation
Driving position setting
Unlocking boot only
Driving assistance
Speeds memorised
Rear wipe in reverse
gear
Automatic parkin
g brake
Lighting
Welcome lighting
Guide-me-home headlamps
Directional headlamps
Parameters
Language
Units
Fuel consumption
Te m p e r a t u r e
Colours
3
1
2
2
3
2
3
1
2
Page 49 of 302
1
47
i
Instruments and controls
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.
Warning/indicator lampStateCauseAction/Observations
Left-hand direction indicator
flashing with buzzer. The lighting stalk is pushed down.
Right-handdirection indicator flashing with buzzer.The lighting stalk is pushed up.
Sidelamps
fixed. The lighting stalk is in the
"Sidelamps" position.
Dipped beamheadlamps fixed. The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlamps
fixed. The lighting stalk is pulled towardsyou. Pull the stalk to return to dipped beam headlamps.
Ready
fixed. The vehicle is ready to move off; you can press the accelerator. It comes on once high voltage is established in the
vehicle.
Rear foglamps
fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
For more information on the lighting controls, refer to the "Visibility" section.
Page 60 of 302
58
i
Instruments and controls
*
According to country.
CHECK (vehicle autotest)
Automatic CHECK
With the key in the ignition on position, all of the
warning lamps for the functions tested are displayed.
They are switched off after a few seconds. At the same time, an automatic CHECK(vehicle autotest) is carried out.
In the presence of a fault
A "minor" fault has been detected: the warning
lamp(s) are displayed then go off.You can star t your vehicle; however, contact a
PEUGEOT dealer or a qualified workshop assoon as possible.
A "major" fault has been detected: theassociated warning lamps(s) remain onaccompanied by the STOP or SERVICE
warning lamp.
Do not star t your vehicle. Call a PEUGEOT dealer or a qualified
wor
kshop without delay.
Manual CHECK
Pressing the "CHECK"
button on theinstrument panel star ts the manual CHECK(vehicle autotest).
This function enables you to recall at any time(with the key in the ignition on position or with
the engine running), the aler ts present.
The passenger's airbag deactivated warning lamp * remains on while theairbag is deactivated. With the en
gine running and the vehiclemoving, the instrument panel displays the
warning lamps (in the event of a fault). I
f no "major" fault is found, you can star t your
vehicle.
Lighting dimmer control
With the headlamps on, press button Bto
increase the brightness of the instruments
and controls and the interior mood lighting or button Ato reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
Page 70 of 302
68
i
!
i
i
Access
As a safety measure (children on board), never leave the vehicle without taking your key, even for a shor t period.
Guard against theft when the electronickey is in the defined zone with thevehicle unlocked.
Locking is confirmed by fixedlighting of the direction indicators for approximately two seconds. According to version, the door mirrors fold at the same time.
It is not possible to lock the vehicle if an electronic key is left inside the vehicleor if the ignition is on.
If one of the doors or the boot is stillopen or if an electronic key has been left inside the vehicle, the centrallocking does not take place.
When the vehicle is locked, if it isunlocked inadvertently, it will relock automatically after about thir ty seconds unless a door is opened.
The folding and unfolding of the door mirrors by the remote control can be deactivated by a PEUGEOT dealer.
Locking the vehicle
Normal locking
Using the key
)Turn the key towards the rear of the vehicle
to lock the vehicle completely.
Using the remote control
)Press the closed padlock to lock
the vehicle completely.
Using the electronic key
)
With the electronic key in the defined zone,
press with a finger on the door handle(at the markings) to lock the vehicle. ) From the boot, with the electronic key in
the defined zone, press a button to lock the
v
ehicle.
Maintaining the locking action (remotecontrol or manual key) automaticallycloses the windows and sunroof.
Page 71 of 302
2
69
i
!
Access
Deadlocking is confirmed by fixedlighting of the direction indicators for approximately two seconds.
Using the remote control
)
Press the closed padlock to lock
the vehicle completely or press
the closed padlock for more
t
han two seconds to close thewindows automatically in addition
to locking.
Using the electronic key
By the doors: ) With the electronic key in the defined zone,
press a finger on the door handle (at the
markings) to lock the vehicle. ) Within five seconds, press the door handle
again to deadlock the vehicle. B
y the tailgate: )
With the electronic key in the defined zone, press the button to lock the vehicle. )
Within five seconds, press the button todeadlock the vehicle.
)
Press the closed padlock again within fiveseconds to deadlock the vehicle.
Deadlocking
Deadlocking renders the exterior andinterior door controls inoperative.
It also deactivates the manual central
control button.
Therefore, never leave anyone insidethe vehicle when it is deadlocked.
Using the key
)Turn the key to the rear in the driver's door lock to lock the vehicle completely. )Turn the key to the rear again withinfive seconds to deadlock the vehicle.
Page 72 of 302
70
!
!
i
Access
Locking/unlocking from the inside
Automatic central locking
of the doors
The doors can lock automatically while driving (speed above 6 mph (10 km/h)).
To activate or deactivate this function, press
and hold the button until a message appears in
the screen.
If the vehicle is deadlocked, the button is not active. In this case, use the key or the remote control to unlock.
Driving with the doors locked may makeaccess to the passenger compartmentby the emergency services moredifficult in an emergency.
Folding the key
)First press this button to fold the key.
If you do not press the button when foldingthe key, there is a risk of damage to the mechanism.
)
Press the closed padlock to
locate your locked vehicle in acar park.
Locating your vehicle
)
Press the button.
This allows the doors and the boot to be lockedor unlocked.
This is indicated b
y lighting of the cour tesylamps and flashing of the direction indicators for a few seconds.
When carrying large objects with theboot open, you can press this button to inhibit the boot open aler t signal. Whenlocking from inside, the door mirrors donot fold.
Page 82 of 302
80
!
Access
) Press this button C
to close thetailgate electrically.
Do not hinder closin
g of the tailgate: any
obstacle to closing causes the tailgate to stopand rise a few centimetres automatically.
To close the tailgate manually: move the
tailgate slightly up then down to disengage it
from its drive then lower it until closed.
To avoid the risk of injury, ensurethat no one is close to the rear of thevehicle when opening or closing the tailgate.
While electric opening or closing of the tailgate
is in progress, you can stop its movement at
any time: ) press the interior button or button A
on
the remote control or button Bor C on thetailgate.
Stopping the opening
or closing
Ad
justing the opening
hei
ght
"Boot open" warning
With the hybrid system active or when the
vehicle is moving, if the tailgate is not properly closed, a message accompanied by an audiblesignal (from 6 mph (10 km/h)) is displayed in the
instrument panel screen.
The maximum openin
g height of the tailgate can be set and memorised (restricted overheadclearance, ...).
This memorisation is done in two steps,
b
y successive presses on button C:
- during opening, a first press stops the
tailgate at the desired height,
- a second maintained press memorises theposition of the tailgate; an audible signal confirms the memorisation.
To delete this memorisation, make a new
maintained press until the audible signal isheard.
