2012 Peugeot 508 RXH fuel

30
i
i
Hybrid system

Auto mode
It automatically manages the operation of the
Diesel engine and the electric motor, according
to inherent vehicle parameters, traffic
conditions and driving style so as to optimise
the vehicle's fuel consumption.In par ticular, this mode activates "zero emissions" electric runningwhen theconditions allow.
In auto mode, the electric motor
:
- can drive the vehicle on its own up
to around 36 mph
(60 km/h) in "zero
emissions" electric running, dependingon the state of charge of the battery, if the conditions specific to the vehicle are metand if acceleration is moderate, -supplements the Diesel enginewhen moving off and changing gear, during acceleration and when traction from thefront wheels is inadequate (it automaticallyadds4 wheel drive ),
- is no longer active above 70 mph (120 km / h).

ZEV mode *
(all electric)

Zero emissions vehicle operation is assured
10 0 % by electric drive.
This mode forces silent runningat moderatespeeds.
If the conditions do not allow this mode
, amessage that the ZEV mode is not available
appears in the screen, the ZEV warning lamp flashes for a few seconds then goes off and theselector comes on in AUTO.
In ZEV mode:


- The accelerator control is progressive.

- Range and acceleration capacity are
limited. The maximum speed possible is
around 36 mph (60 km/h).

- Under high load or a priority requirement causing the star t of the Diesel engine, thesystem changes automatically to AUTO mode.


This standard
mode to use inpreferenceis activated automaticallyon star ting the hybrid system.


For more information on "Automaticrestarting of the Diesel engine", refer tothe corresponding section.

*
ZEV: Z
ero Emissions Vehicle.
It can be activated when the
required conditions are met,
particularly if the state of charge of high voltage battery issufficient (4 bars minimum).

.
31
i
!
Hybrid system

Sport mode
(Diesel and
electric)

This mode allows more dynamic driving byproviding additional performance. Vehicle acceleration and pick-up aremaximised by using the capacity of the electricmotor, supplementing the power of the Dieselengine.
This mode manages the progressiveness of the
accelerator, the electronic gear control gearbox and the use of the electric motor.
In Spor t mode:


-
The electric motor can be used up to
70 mph (120 km/h).
4WD mode **
(Diesel and
electric)
This mode provides additional traction*** at low speed by driving all 4 wheels of the vehiclecontinuously: the Diesel engine (front wheel
drive) and the electric motor (rear wheel drive)
operate simultaneously and permanently.
Their couplin
g is managed electronically to
optimise traction on slippery surfaces.
In 4WD mode:
- Power for the electric motor is provided,
if needed, b
y the alternator-star ter motor
of the front engine. The Diesel engine
operates continuously.
- The additional traction from the electric
motor is available up to 75 mph (120 km/h).
This mode should be used on snowcovered roads or difficult ground (mud, sand, ...).


**
4WD: 4 Wheel Drive.
***

This mode will be even more effective if suitable tyres are fitted (winter tyres in
particular).
Be aware of the ground clearance of your vehicle: around 184 mm (with the vehicle in working order: driver only and
the fuel tank full) in ideal conditions. This value will vary with vehicle load,the nature of the ground surface and the surroundings.
If the driver considers that the vehiclecan traverse an obstacle, they assumeentire responsibility for this.

.
35
ii
Hybrid system
Automatic restarting of the Diesel engine or NON
access to ZEV mode
The main conditions are:


- if the gear lever is in position M,


- if the steering mounted gear change control paddles are operated,

- if the high voltage battery is not sufficiently charged. At least 4 bars in ZEV mode so asto provide a cer tain distance (in AUTO mode, electric operation is available more brieflywith a lower state of charge),

- at 18 mph (30 km/h) after setting off (if the internal combustion engine has not alreadystar ted since setting off),

- when the vehicle is on a slope, to retain engine braking from the internal combustion engine when the battery is fully charged,

- when using engine braking from the internal combustion engine,

- when the fuel level enters the reser ve zone (in the event of high consumption of thisreser ve, inhibition of ZEV can continue for some time after refuelling).

- when maintaining a comfor table temperature in the passenger compar tment (air conditioning, ...),

- when using the vehicle after prolonged parking in a sunny area,

- when demisting,

- during sustained and sharp acceleration

- in mountainous conditions (altitude),

- when using the vehicle on a steep slope (car park ramp, ...),

- when regenerating the par ticle emissions filter, for around 5 to 10 minutes every300 miles (500 km)(or less for extended urban running.

- in cer tain engine temperature conditions or requirements, such as an enginetemperature that is too low for the ambient conditions.
In ZEV mode, these conditions lead to an immediate change to AUTO mode. The Diesel engine is switched off automatically as soon as these conditions are lifted.


Your vehicle is fitted with the most effective emissions control systems, inparticular the Particle Emissions Filter (PEF).
At regular intervals your Diesel engine will produce energy for the self-cleaningof this filter.
During this PEF regeneration phase,electric running is purposely madeunavailable.

.
37
Hybrid system












































Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your
gearbox
Use automatic mode Aas much as possible as this optimises gear changes to suit the
circumstances.

Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather than the brake pedal, and press the accelerator progressively. These practices contribute towards a reduction in fuel consumption and CO2 emissions and also helps reduce thebackground traffic noise.
If your vehicle has cruise control, make use of the system at speeds above 25 mph (40 km/h) when the traffic is flowing well.



Control the use of your
electrical equipment
Before moving off, if the passenger compartment is too warm, ventilate it byopening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windowsand leave the air vents open. Remember to make use of equipment that canhelp keep the temperature in the passenger compartment down (sun roof and window blinds...).Switch off the air conditioning, unless it has automatic digital regulation, as soon as the desired temperature is attained.Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.

Switch off the headlamps and front foglampswhen the level of light does not require their use.

Avoid running the Diesel engine when stationary, par ticularly in winter; your vehiclewill warm up much faster while driving.

As a passenger, if you avoid connecting your multimedia devices (film, music, video game...), you will contribute towards limitingthe consumption of electrical energy, and soof fuel.
Disconnect your por table devices beforeleaving the vehicle.

38
Hybrid system
Limit the causes of excess
consumption
Spread loads throughout the vehicle; placethe heaviest items in the bottom of the boot,as close as possible to the rear seats.Limit the loads carried in the vehicle andreduce wind resistance (roof bars, roof rack,bicycle carrier, trailer...). Use a roof box in preference.Remove roof bars and roof racks after use.


At the end of winter, remove snow tyres and refit your summer tyres.


Observe the recommendations
on maintenance


Check the tyre pressures regularly, when cold, referring to the label in the door aper ture, driver's side. Carry out this check in par ticular:


- before a long journey,

- at each change of season,

- after a long period out of use.



Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) and obser ve the schedule of operations recommended by the
manufacturer.


When refuelling, do not continue after the 3rd
cut-off of the nozzle to avoid any overflow.

At the wheel of your new vehicle, it is onlyafter the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settle down to a consistent average.

.
41
!
!
Hybrid system
High voltage
Before doing any work on
the vehicle, switch off the
ignition ( Readylamp off). y
High voltage cables
High voltage cables are routed under the
vehicle (sills); take care not to damage them when the vehicle is used for off-road activity (such as covering rough ground).

Battery precautions

The high voltage battery must not in any
circumstances be charged from an externalsource and must only be handled by a
workshop technician.
There is the risk of serious burns, as well as electric arcs that could cause serious injury or even death.
A used Ni-MH (Nickel Metal Hydride) type
high voltage battery must be removed in an
appropriate manner by a repair workshop,so that its recycling presents no risk to the environment.

Take care to position lifting equipment(jack, hoist, ...) at the locations provided to avoid damaging the cables.
The volta
ge used for the operation of theelectric motor is in the range 150 to 270 Volts.
Be sure to take account of the warning labels
fitted to the vehicle.
Ta k e great care regarding the high voltage and high temperatures of components carrying thecurrent.


Emergency cut-off

In the event of an accident, a cut-off system
blocks the high voltage current and cuts off
the fuel pump; your vehicle can no longer bestarted.
To restar t the hybrid system, contact a
PE
UGEOT dealer.
Never touch, dismantle, remove or replace the high voltage par ts, orange cables or connectors, even in the event of an accident.

.
43
!
Hybrid system





Underbonnet precautions/warnings

Always ensure that
the ignition is switched
off (Ready lamp off)
before opening thebonnet.
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Also ensure that the ignition is switched off when refuelling to avoid the enginerestarting.

1
45
Instruments and controls








Instrument panel
1.
Energy consumption/generation indicator (power available as a percentage) For more information refer to the "Hybrid system" section. 2.Ready lamp.
Indicates that the vehicle is ready to drive. 3.Engine oil temperature gauge. 4. Fuel gauge.
5. Engine coolant temperature gauge.
6.Speedometer (mph or km/h).
7. Cruise control or speed limiter settings.
A.Main lighting dimmer. B.
Display of aler t log.
Recall of the service information.
C. Reset the trip distance recorder.

8. Gear lever position and gear for anelectronic gear control gearbox.
9. Display zone: hybrid flow, alert messages
or state of functions, trip computer.
10.Trip distance recorder (miles or km). 11.Automatic wipersSer vice indicator (miles or km) then,
total distance recorder.
These two functions are displayedsuccessively when switching on
the ignition.

Dials and screens
Control buttons