Page 209 of 304
8
207
Practical information
Recovering the vehicle on a fl at-bed
From the front Access to the tools
The towing eye is located behind the rear seats. )For access to it, fold the 2/3 par t of the rear seats.
)
On the front bumper, unclip the cover bypressing at the bottom to disengage the securing lugs. )
Screw the towing eye in fully. )
Install the towing system. )
Switch on the hazard warning lamps.
Always recover the vehicle on a flat bed lorry or trailer.Never tow the vehicle with the four wheels on the ground (or the front or rear wheels only), you risk damaging the transmission.Place the gear selector in position Nand switch off the engine (Readylamp off). )
Place the gear selector in neutral - position N .
Failure to obser ve this special condition could result in damage to cer tainbraking components and the absence of braking assistance the next time the engine is star ted.
Procedure for havin
g your vehicle recovered on a flat bed lorry or trailer.
Page 255 of 304
253
04
Press NAVto display the " Navigation - guidance" menu.
ADJUSTING THE GUIDANCE SPEECH SYNTHESIS
Select " Guidance options
" and confi rm.
ADJUSTING THE VOLUME/DEACTIVATION
Select " Set speech synthesis" andconfi rm.
Select the volume graph and confi rm.
Select "Deactivate
" to deactivate voice messages.
Select " OK " and press the dial
to confi rm.
Adjust the volume to the desired level and confi rm.
The volume o
f messages can be adjusted during the transmissionof the message using the volume adjustment control.The volume settin
g of guidance messages is also accessible via the "SETUP" / " Voice synthesis " menu.
Page 259 of 304
257
05TRAFFIC INFORMATION
PRINCIPAL TMC SYMBOLS
Red and yellow triangle: traffi c information, for example:
Black and blue trian
gle: general information, for example:
RECEIVING TA MESSAGES
The TA (Traffi c Announcement) function gives priority to TA alert messages. To operate, this function needs good reception of a radio station transmitting this type of message. When a traffi c report is
transmitted, the current audio source (Radio, CD, USB, ...) is interrupted
automatically to play the TA message. Normal playback of the audiosource resumes at the end of the transmission of the message.
Press RADIO
to display the menu.
Select " Guidance options"then confi rm.
Select " Activate / Deactivate TA"
then confi rm.
The volume settin
g for TA messages can be adjusted only during the
transmission of this type of alert.
Activate or deactivate the function at an
y time by pressing
the button.
During a message, press the button to interrupt it.
