Page 71 of 340
3
69
!
Comfort
Rear seats
Bench seat the left-hand (1/3) or right-hand (2/3) section of which can be folded to adapt the boot load space.
Outer rear seat head restraints
These have a high position (comfort and safety), a low position (rear visibility) and can also be removed.
T
o remove a head restraint: )pull the head restraint fully upwards, )then, press the lug A .
Never drive with rear passengers when the head restraints are removed; thehead restraints must be in place and in the high position.
Folding the seat from
the boot
)
Check that nothing is preventing the seat back from folding (head restraint, seat belts, ...), )
check also that no object on or under theseat could hinder its movement,
)
pull the control from the boot and push the seat backrest.
(SW)
Each section of the bench seat (1/3 or 2/3) hasits own control to release the seat back and its
seat cushion from the boot.
Page 80 of 340
78
Comfort
Boot fi ttings (SW)
1.Boot lamps2.Rear seats folding controls3.Retractable hooks
4.12 V accessory socket (120 W max)5.StoragepocketsWith towing eye, a wheel chock and a
temporary puncture repair kit (according to
destination country and equipment).
6.Stowing rings7.Load space cover(see following page) .
8.Boot floorFor access to the storage compar tmentsor the spare wheel (according to destinationcountry), position the floor ver tically in its guide.
Page 83 of 340
3
81
i
Comfort
High load retaining net
Hooked onto the special upper and lower fixings, this allows the use of the entire loading
volume up to the roof:
- behind the front seats (row 1) when the rear seats are folded.
- behind the rear seats (row 2).
Never reposition the rear seats if thenet's roller is attached to the backs of the folded seats. )
position the net's roller above the two rails (located on the back of the folded rear seats), )
the two grooves Amust be placed above
the two rails B
. Slide the two rails B
in thegrooves Aand push the roller (lengthwise)from right to left to secure it,
)
check that the net is hooked and tightened correctly,
)
fold the rear seats, )
unroll the high load retaining net without stretching it, )
position one of the ends of the net's metal
bar in the corresponding upper fixing 1, ) pull the net's metal bar to position the other end in the other upper fixing 1.
Row 1
(SW)
Page 142 of 340
140
i
!
Visibility
Manual adjustment
of halogen
headlamps
Automatic adjustment of xenon headlamps
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle.0 1 or 2 people in the front seats. -
5 people.1
Intermediate setting. -
5 people + a load in the boot. 2
Driver + a load in the boot. -
Not used.3
Not used.If a fault occurs
, this warning lamp is displayedin the instrument panel,
accompanied by an audible signal and a
message in the instrument panel screen.
The s
ystem then places your headlamps in the lowest position.
In order to avoid causing a nuisance to other road users, this system corrects the height of the
xenon headlamps beam automatically and when
stationary, in relation to the load in the vehicle.
If a fault occurs, do not touch the xenonbulbs. Contact a PEUGEOT dealer or a qualified workshop.
The initial setting is position "0".
Page 151 of 340
6
149
i
Child safety
General points relating to child seats
For maximum safety, please obser ve the following recommendations:
- in accordance with European regulations,
all children under the age of 12 or less
than one and a half metres tall must
travel in a
pproved child seats suited to
their weight , on seats fitted with a seat
belt or ISOFIX mountings * ,-statistically, the safest seats in your
vehicle for carrying children are the rear seats, -
a child weighing less than 9 kg must
travel in the "rearwards-facing" position both in the front and in the rear.
PEUGEOT recommends that childrenshould travel in the outerrear seatsof your vehicle: -"rearwards-facing"
up to the age of 2, -
"forwards-facing"
over the age of 2.
Although one of PEUGEOT's main criteria when designing your vehicle, the safety of your children
also depends on you.
*
The rules for carrying children are specific to each country. Refer to the legislation in force
in
your country.
Page 154 of 340
152
Child safety
Child seats recommended by PEUGEOT
Group 1: from 9 to 18 kg
L1"RÖMER/BRITAX Baby-Safe Plus". Installed in the rear wards-facing position.
L2"RÖMER Duo Plus ISOFIX".
Groups 2 and 3: from 15 to 36 kg
L4"RECARO Start''.
L5"KLIPPAN Optima".
From the age of 6 years (approximately 22 kg), the booster
is used on its own. PEU
GEOT offers a complete range of recommended child seats which are secured using a three point seat belt
:
Page 155 of 340
6
153./..
Child safety
Installing child seats attached using the seat belt
In accordance with European regulations, this table indicates the options for installing child seats secured using a seat belt and universally approved (a)in accordance with the weight of the child and the seat in the vehicle.
Weight of the child and indicative age
SeatUnder 13 kg
(groups 0(
b )and 0+)Up to approx 1 year
From 9 to 18 kg(group 1)1 to 3 years approx
From 15 to 25 kg
(group 2)3 to 6 years approx
From 22 to 36 kg(group 3) 6 to 10 years approx
Front passenger seat(
c )with height adjuster U (R)U (R)U (R)U (R)
Front passenger seat (c)without height adjuster UUUU
Saloon
Outer rear seats UUUU
Centre rear seat XXXX
SW
Outer rear seats UUUU
Centre rear seat XXXX
Page 156 of 340
154
Child safety
a: universal child seat, child seat that can be installed in all vehicles using a seat belt. b:
group 0, from bir th to 10 kg. Shells seats and baby carriers cannot be installed in the front passenger seat.
c:
consult the legislation in force in your country before installing your child on this seat.U:
seat suitable for the installation of a child seat secured using a seat belt and universally approved, "rear wards-facing" and/or "for wards-facing". U (R):idem U, with the vehicle's seat adjusted to the highest position and as far back as possible. X:
seat position not suitable for installation of a child seat for the weight class indicated.