Page 67 of 332
65
2
Access
Locking the vehicle
Locking
)With the key in one of the defined zones A , press one of the buttons Bor C.
Deadlocking
Locking is confirmed by an audiblesignal and the direction indicators, which flash once
.
The door mirrors fold at the same time.
)
With the electronic key in one of the defined zones A
, press button B
or Cto
lock the vehicle. ) Within five seconds, press button Bor Cagain to deadlock the vehicle.
Locking is confirmed by two audible signals and by the direction indicators which flash three times
.
The door mirrors unfold at the sametime.
Always ensure that you have theelectronic key on your personbefore locking the vehicle: in some circumstances, it is possible to lock the vehicle without the presence of the electronic key having been detectedinside the vehicle.
The operating mode must be "OFF".
With Stop & Star t, if the engine is in Stop mode, the vehicle cannot belocked.
Page 68 of 332
66
Access
Switching on the lighting
remotely
This only operates with the ignition offand theflighting control in the "OFF" or "AUTO
" position.
Remote operation of the li
ghting will be switched off:
- on switching on the ignition,
- if the lighting control is not in the " OFF " or
"AUTO
" position,
- when activating manual guide-me-home
lighting.
Pr
ess this button to switch on
the lighting remotely (illumination
of the sidelamps and dipped
beam headlamps) for a period of 30 seconds.
A second press switches off the lighting.
Deadlocking renders the exterior and interior door controls inoperative.
It also deactivates the manual central control button.
Therefore, never leave anyone insidethe vehicle when it is deadlocked.
The means by which locking/unlocking the vehicle and automatic folding/unfolding of the mirrors is confirmed
can be configured in the colour screen "Equipment" menu.
Page 69 of 332
67
2
Access
Emergency procedure with the Keyless Entry and Starting
system
Unlocking
) Turn the key towards the front in thedriver's door lock to unlock the vehicle.
Emergency unlocking/locking
using the integral key
The integral key is used to lock and unlock the
vehicle when the electronic key cannot operate:
- cell batter
y flat, vehicle battery discharged
or disconnected, ...
- vehicle located in an area with stron
gelectro-magnetic signals. )Pull and hold button 1 , to extract the integral key 2.
Locking
)
Turn the key towards the rear in the driver's door lock to lock the vehicle.
The emergency key allows you to lock or unlock the driver's door only. To lock or unlock the other doors, usethe interior controls (see "Locking / unlocking from inside").
Page 71 of 332
69
2
Access
Visit a PEUGEOT dealer with the vehicle's registration document and your personal identification documents and if possible the key code label.
The PEUGEOT dealer will be able to retrieve the key code and the transponder code required to order a new key.
Electronic key
The electronic key is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.Do not repeatedly press the buttons of your electronic key out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reinitialised.The electronic key cannot operate as a remote control when it is in the reader or even when the ignition is switched on.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by the emergency ser vices more difficult in an emergency.
As a safety precaution (with children on board), take the Keyless Entry and Star ting electronic key when you leave the vehicle, even for a shor ttime.
Electrical interference
The Keyless Entry and Starting electronic key may not operate if close to certain electronic devices: telephone, laptop computer, strong magnetic fields, ...
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.Don't forget to turn the steering to engage the steering lock.
When purchasing a second-hand vehicle
Have all of the keys in your possession paired by a PEUGEOT dealer, to ensure that only your keys allow your vehicle to be unlocked and started.
Page 72 of 332
70
Access
Doors
From out side
)After unlocking the vehicle using theremote control or the key, pull the door handle.
Closing
From inside
)
Pull the front or rear door lever to open thedoor. If a door is not closed correctl
y, this warning
lamp comes on in the instrument panel screen
until the door concerned is closed.
On the driver's side, this action on the door lever unlocks the door if it was locked.
On the passenger's side or for the rear doors,
the door must first be unlocked manually (see "Individual controls") if it was locked.
Page 73 of 332
71
2
Access
Boot
Opening
)After unlocking the vehicle, press the handle Aand raise the tailgate.
)
Pull the handle Bdownwards to guide the
tailgate. ) Release the handle and press gently on theexterior surface of the tailgate to close it.
ClosingManual release
This enables the boot to be unlocked in the event of a central locking fault.
- Fold back the rear seats to
gain access to
the tailgate release from inside the boot.
- Remove the plastic cover from the
opening A in the tailgate interior pillar.
- Move the control B
to the right to unlock
and open the boot.
If the tail
gate is not fully closed, this warning lamp comes on in the instrument panel screen until it is closed.
Page 74 of 332
72
Access
Locking / unlocking from inside
Central locking control
Locking
)Press the front of button Ato lock the
vehicle.
Unlocking
)Press the rear of button A to unlock the
vehicle.
Individual controls
This control can also be used to lock the front
passen
ger's door and the rear doors in the event of a failure with the central locking. To do this: ) Open the door in question. )
Pivot the interior control Btowards thefront, then close the door.
Locking the front and rear doors
)
Pivot the interior control Btowards thefront.
System which provides full manual locking or
unlockin
g of the doors and boot from the inside.
Unlocking the front and rear doors
)Pivot the interior control B
towards the rear.
It is possible to lock the vehicle with a passenger door open, using using the individual locking controls: ensure that you have the key before closing thepassenger door.
Page 75 of 332
73
2
Access
For all work on the alarm system, contact a PEUGEOT dealer or a qualified workshop.
Alarm * System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:
- perimeter
The system checks for any opening of the vehicle.
The alarm is triggered if anyone tries to open adoor, the boot, the bonnet...
- volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
- tilt
The system checks for any change in theattitude of the vehicle.
The alarm is triggered if the vehicle is lifted,moved or knocked.
Self-protection function
The system checks for the putting out of service of its components.
The alarm is triggered if the battery, the centralcontrol or the siren wiring are put out of service
or damaged.
Locking the vehicle with full
alarm system
Activation
)
Switch off the ignition (OFF mode if your
vehicle has the Keyless Entry and Star ting system). ) Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
Entry and Starting" system. ) Leave the vehicle, and close all the doorsand the bonnet. )
Press the locking button on the remote control or one of the door or boot buttons
if your vehicle has the "Keyless Entry and Starting" system.
Deactivation
Do one of the the following to deactivate thealarm: )
Press the unlocking button on the remotecontrol or one of the door or boot buttonsif your vehicle has the "Keyless Entry andStarting" system.
)
Switch on the ignition (ON mode if your
vehicle has the "Keyless Entry andStarting" system). ) Open a door or the boot while the system is being activated.
The alarm system is deactivated: the indicator
lamp A
goes off.
The alarm is bein
g activated: the indicator
lamp A flashes rapidly accompanied byan intermittent audible signal for about
20 seconds.
Once the 20 seconds have expired, the
system is active . The audible signal stops and
the indicator lamp in the button flashes slowly.
*
According to equipment.
