2012 Peugeot 301 ignition

1
31
Instruments and controls
Warning / indicator lampStateCauseAction / Observations
Airbags

on temporarily. This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a qualified workshop.

fix
ed. One of the airbag or seat belt pretensioner systems has a fault. Have it checked by a PEUGEOT dealer or a qualified
workshop.
Power steering fixed. The power steering has a fault. Drive carefully at reduced speed.
Have it checked by a PEUGEOT dealer or a qualified
workshop.
Driver's seat belt not fastened or unfastened / Frontpassenger's seatbelt unfastened
fixed or flashin
gaccompanied by an increasing audiblesignal.Th
e driver has not fastened or hasunfastened their seat belt.
The front passenger has unfastened
their seat belt. Pull the strap then inser t the ton
gue in the buckle.

32
Instruments and controls





Service indicator


More than 1800 miles (3000 km) remain before the next service is due

When the ignition is switched on, no ser vice
information appears in the screen. S
ystem which informs the driver when the next ser vice is due, in accordance with the manufacturer's servicing schedule.The point at which the ser vice is due is calculated from the last indicator zero reset.
It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last ser vice.

Between 600 miles (1 000 km)and 1800 miles (3 000 km) remainbefore the next service is due

For a few seconds after the ignition is switched
on, the spanner symbolising the service
operations comes on. The distance recorder
display line indicates the distance remainingbefore the next service is due.Example: 1 700 miles (2 800 km) remainbefore the next service is due.
For a few seconds after the ignition is switched
on, the screen indicates:
A
few seconds after the ignition is switched on, the spanner goes off; the distance recorder fresumes its normal operation. The screen then
indicates the total and trip distances.


Less than 600 miles (1 000 km)
remain before the next service is due
Example:560 miles (900 km) remain before
the next service is due.
For a few seconds after the i
gnition is switched
on, the display indicates:

A few seconds after the ignition is switched
on, the distance recorder resumes its normaloperation. The spanner remains on
to indicatethat a service must be carried out soon.

1
33
Instruments and controls
For a few seconds after the ignition is switchedon, the spanner flashes
to indicate that the ser vice must be carried out as soon as possible.
Example:the ser vice is overdue by 18 0 miles(300 km).
For a few seconds after the ignition is switched
on, the display indicates:
The distance remaining may be weighted by the time factor, depending on the driver's driving habits.
Therefore, the spanner may also come
on if you have exceeded the two year service interval.

Following this operation, if you wish to disconnect the battery, lock the vehicleand wait at least five minutes for the zero reset to be taken into account.
Service indicator zero reset

After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is as
follows:) switch off the ignition, )
press and hold the trip distance recorder zero reset button,
)
switch on the ignition; the distance recorder
display begins a countdown,
) when the display indicates "=0"
, release
the button; the spanner disappears.

Retrieving the serviceinformation

You can access the ser vice information at any
time.
) Press the trip distance recorder zero reset button.
The ser vice information is displayed for a
few seconds, then disappears.

A few seconds after the ignition is switched
on, the distance recorder resumes its normal
operation. The spanner remains on.

34
Instruments and controls
travelled by the vehicle during its life.
The total and trip distances are displayed for
thir ty seconds when the ignition is switched off,
when the driver's door is opened and when the
v
ehicle is locked or unlocked.
Total distance recorder
System which measures a distance travelledduring a day or other period since it was reset
to zero by the driver. ) With the ignition on, press the button until
zeros appear.



Tr ip distance recorder












Distance recorders

43
2
Access

If one of the doors or the boot is stillopen, the central locking does not take place; the vehicle locks then immediately unlocks, identifiable by thesound of the locks rebounding.
When the vehicle is locked, if it isunlocked inadvertently, it will lockagain automatically after thir ty seconds unless a door or the boot is open.


Locking using the remote control
)Press the closed padlock to lockthe vehicle.
Locking the vehicle

Locking is confirmed by fixed lighting of
the direction indicators for approximatelytwo seconds.

Locking using the key
)Turn the key in the driver's door lock,
towards the rear of the vehicle to lock it.This
function allows you to identify your vehiclefrom a distance, par ticularly in poor light. Your
vehicle must be locked.
Locating your vehicle Anti-theft protection

Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for starting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstarting of the engine by anyone who does not have the key.
In the event of a fault,
you are
informed by illumination of this
warning lamp, an audible signal and a messagein the screen.
In this case, your vehicle will not start; contact
a PEU
GEOT dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.
) Press the closed padlock on the
remote control.
This will switch on the cour tes
y lamps and the direction indicators will flash for a few seconds.

Check that the doors and boot are fully
closed.

44
Access
PEUGEOT dealer as soon as possible.
If the batter
y is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.

Changing the battery
)Remove the flat battery from its location. )Fit the new battery into its location
observing the original direction of fitment. )Clip the cover onto the casing.
In the event of a fault with the remote control,
you can no longer unlock, lock or locate your
vehicle.)First of all, use the key in the lock to unlock
or lock your vehicle.)Then, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
)Switch off the ignition and remove the ignition key.)Press the closed padlock immediately for afew seconds.)Turn the key to position 2 (Ignition on).)Switch off the ignition and remove the keyfrom the ignition switch.
The remote control is fully operational again. Battery re
f.: CR2032 / 3 volts.
)
Unclip the cover using a small screwdriver
at the cutout. )
Lift off the cover.

45
2
Access
Lost keys
Visit a PEUGEOT dealer with the vehicle's registration document, your personalidentification documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder coderequired to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it. Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would haveto be reinitialised. No remote control can operate when the key is in the ignition switch, even when the ignitionis switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by theemergency services more difficult in an emergency. However, the vehicle unlocks automatically in the event of a serious impact causing airbag deployment.
As a safety precaution, never leave children alone in the vehicle, except for a very shortperiod.In all cases, it is essential to remove the key from the ignition switch when leaving the vehicle.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could causemalfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a PEUGEOT dealer,to ensure that only your keys can be used to open and star t the vehicle.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.

46
Access
System which protects and provides a deterrentagainst theft and break-ins. It provides perimeter protection as well as a self-protection
function.






Alarm
Perimeter protection
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...


Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery, the central control or the wires of the siren are put out of ser vice or damaged.


Locking the vehicle with
alarm


Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on the
remote control.
The perimeter protection is activated 5 seconds
after pressin
g the locking button on the remotecontrol.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the alarm isactivated.
)
Press the unlocking button on
the remote control.

Deactivation

The alarm is deactivated: the
indicator lamp goes off. Th
e alarm is activated: a indicator lamp in the switch panel to the left
of the steering wheel flashes once
per second.

For all work on the alarm system, contact a PEUGEOT dealer or aqualified workshop.