2012 Peugeot 208 warning

130
Safety
Deactivation
This warning lamp comes on in the instrument panel when the ignition is
on and until the airbag is reactivated.
To assure the safety of your child,the passenger's front airbag must be deactivated when you install a "rear facing" child seat on the front passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.

If even one of the two airbag warning lamps comes on continuously, donot install a child seat on the frontpassenger seat.
Have it checked by a PEUGEOT dealer or qualified workshop.



Reactivation

When you remove the child seat, with the
ignition on , turn the switch to the "ON"
position to reactivate the airbag and so assure
the safety of your front passenger in the event
of an impact.


Operating fault

If this warning lamp comes on in the instrument panel, accompanied by
an audible warning and a message
in the screen, contact a PEUGEOT
dealer or a qualified workshop to have thesystem checked. The airbags may no longer be
deployed in the event of a serious impact.
If this warnin
g lamp flashes, contact
a PEUGEOT dealer or a qualified workshop. The passenger's front
airbag may no longer be deployed in
the event of a serious impact.
Only the passenger's front airbag can be deactivated:)Inser t the key into the passenger airbagdeactivation switch, )turn it to the "OFF"position,)then, remove the key keeping the switch in
the new position.

152
Practical information
Removing a wheel

Parking the vehicle

Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the
ignition and engage first gear *
to blockthe wheels. Check that the parking brake warninglamps in the instrument panel come on.
The occupants must get out of the vehicle and wait where they are safe.
Never go underneath a vehicle raised using a jack; use an axle stand.


List of operations
)
Remove the bolt cover from each of
the bolts using the tool 3(according toequipment). ) Fit the security socket 4on the wheelbrace 1to slacken the security bolt (if fitted).)
Slacken the other bolts using the
wheelbrace 1 only.
*
position R
for an electronic
gearbox; P
for an automatic gearbox.

157
7
Practical information
Changing dipped beam headlampbulbs
) Remove the protective cover by pulling on
the tab. ) Disconnect the bulb connector.)
Spread the spring to release the bulb(model A
). A)
Extract the bulb and change it.

Amber coloured bulbs, such as thedirection indicators, must be replacedwith bulbs of identical specificationsand colour.
When refitting, close the protective cover carefully to preser ve the sealingof the headlamp.

Rapid flashing of the direction indicator warning lamp (right or left) indicates the failure of a bulb on that side.
Changing direction indicator bulbs
)Turn the bulb holder a quarter of a turn andextract it. )Pull out the bulb and change it.
To reassemble, carry out these operations in
r
everse order.
To reassemble, carry out these operations in
reverse order, positionin
g the alignment lug at
the bottom (model A ) or at the top (model AB ).

175
7
Practical information

To w i ng your vehicle
To w i ng another vehicle
)On the front bumper, unclip the cover bypressing at the bottom. )Screw the towing eye in fully. )Install the towing bar.
)
On the rear bumper, unclip the cover bypressing at the bottom. )
Screw the towing eye in fully. )
Install the towing bar. )
Switch on the hazard warning lamps on
both vehicles.)
Move off gently, drive slowly and for a shor t distance.
)Place the gear lever in neutral(position N
on an electronicgearbox or automatic gearbox).Failure to observe this instructioncould result in damage to certain components (braking, transmission...) and the absenceof braking assistance the next time the engine is star ted.
)
Unlock the steering by turning the key
in the ignition one notch and release the
parking brake. ) Switch on the hazard warning lamps onboth vehicles.
)
Move off gently, drive slowly and for a shor tdistance.

177
7
Practical information

Driving advice


Distribution of loads
)Distribute the load in the trailer so that theheaviest items are as close as possible to
the axle and the nose weight approaches the maximum permitted without exceeding it.

Air density decreases with altitude, thus
reducing engine performance. Above
1 000 metres, the maximum towed load must
be reduced b
y 10 % for every 1 000 metres of altitude.

Side wind
)Take into account the increased sensitivity
to side wind.
Cooling
To w i ng a trailer on a slope increases the
temperature of the coolant.
As the fan is electricall
y controlled, its cooling capacity is not dependent on the engine speed.
)
To lower the engine speed, reduce your speed.
The maximum towed load on a long incline
depends on the
gradient and the ambient
temperature.
In all cases, keep a check on the coolant
temperature.
) If the warning lamp and the
STOPwarning lamp come on, stop the vehicle and switch off
the engine as soon as possible.



Braking

To w i ng a trailer increases the braking distance.
To avoid overheating of the brakes on a long
mountain type of descent, the use of enginebraking is recommended.

Tyres
)
Check the tyre pressures of the towingvehicle and of the trailer, obser ving the
recommended pressures.



Lighting
)
Check the electrical lighting and signalling on the trailer.



The rear parking sensors will be deactivated automatically if a genuinePEUGEOT towbar is used.

R
efer to the "Technical Data" section for detailsof the weights and towed loads which apply to your vehicle.

180
Practical information




Accessories
A wide range of accessories and genuine par ts is available from the PEUGEOT dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from PEUGEOT's recommendation and warranty.
Conversion kits
You can obtain an "Enterprise" kit to conver t a
tra
de vehicle to a private car and vice-versa.

"Comfort":
door deflectors, side blinds and rear blind,cigarette lighter, boot dividers, coat hanger fixed to head restraint, front centre armrest,
under shelf storage, front and rear parking sensors...

"Transport solutions":

boot liner, luggage net, cigarette lighter, roof
bars, bicycle carrier on roof bars, ski carrier,roof box....

*
To avoid an
y risk of jamming of the pedals:
- ensure that the mat is positioned and
secured correctl
y,
- never fit one mat on top of another.


"Styling":

aluminium gear lever knob, spoiler, stylingstrips, alloy wheels, trims, chromed mirror
shells, body kit...


"Security":

anti-theft alarm, window engraving, wheel
security bolts, child seats and booster cushions, breathalyzer, first aid kit, warning
triangle, high visibility jacket, stolen vehicle
tracking system, temporary puncture repair kit,snow chains, non-slip covers, front foglamps
kit...
"Protection":

mats *
, seat covers compatible with lateral
airbags, mud flaps, side rubbing strips,
aluminium or PVC door aperture finishers...
Tow bar, which mst be fitted byPEUGEOT dealer or a qualified workshop.

181
7
Practical information
The fitting of electrical equipment or accessories which are not recommended by PEUGEOT may resultin a failure of your vehicle's electronicsystem and excessive electrical consumption. Please note this precaution. Youare advised to contact a PEUGEOTrepresentative to be shown the range of recommended equipment and accessories.


Installation of radio communication transmitters

Before installing any after-market radio communication transmitter, you can contact a PEUGEOT dealer for the specification of transmitters which canbe fitted (frequency, maximum power, aerial position, specific installationrequirements), in line with the VehicleElectromagnetic Compatibility Directive(2004/104/EC).




Depending on the legislation in forcein the country, it may be compulsory to have a high visibility safety vest,warning triangle and spare bulbs andfuses available in the vehicle. B
y visiting a PEUGEOT dealer, you can also
obtain products for cleaning and maintenance (exterior and interior) - including ecological products in the "TECHNATURE" range, toppingup products (screenwash...), touch-up pens and paint aerosols for the exact colour of your
vehicle, refills (cartridge for the temporary puncture repair kit...), ...



"Multimedia":

audio systems, por table satellite navigationsystems, semi-integral suppor t for por tablesatellite navigation system, hands-free kit, CDchanger, speakers, DVD player, connection
kit for MP3 or CD player, USB Box, Wi-Fi on-board...

186
Checks
Low fuel level
When the fuel tank minimum level isreached this warning lamp comes on on the instrument panel. When it firstcomes on there remains approximately
5 litres of fuel in the tank.You must refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer to the
"Running out of fuel - Diesel" section.
The key cannot be removed from the lock until the cap is refitted. Removing the filler cap may cause an inrush of air. This vacuum is per fectly normal and results from the sealing of
the system.



























Fuel tank
Fuel tank capacity: approximately 50 litres.

A self-adhesive label on the inner face of thefiller flap reminds you of the type of fuel to use
depending on your engine.
Additions of fuel must be of at least 5 litres to be registered by the fuel gauge.


Filling


To fill the tank safely: )the engine must be switched off,)open the fuel filler flap, )inser t the key in the cap, then turn it to the
left,
With Stop & Star t, never refuel with the system in STOP mode; you must switch off the ignition with the key.
)remove the cap and hook it onto the clip
located on the inside of the flap,
)fill the tank, but do not continue after the
3rd cut- off of the pump ; this could causemalfunctions.