2012 Peugeot 208 stop start

97
4
Driving
The system is reactivated automatically at every new star t using the key.


Reactivation

Press the "ECO OFF"switch again.
The s
ystem is active again; this is confirmed
by the switch warning lamp going off,
accompanied by a message in the screen.
Operating fault
In the event of a fault with the system, the
"ECO OFF"
switch warning lamp flashes thencomes on continuously.
Have it checked by a PEUGEOT dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle ma
y stall. All of the warning lamps come on. It is then necessary to switch off
the ignition and star t the engine again using
the key.

Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting fromautomatic operation of STA R T m o d e .

This s
ystem requires a battery with a specialspecification and technology (reference
numbers available from a PEUGEOT dealer or
a qualified workshop).
Fitting a battery not listed byPEUGEOT introduces the risk of malfunction of
the system.



Maintenance

The Stop & Start system makes use of advanced technology. All work onthis type of battery must be done by a PEUGEOT dealer or a qualifiedworkshop.

169
7
Practical information




Battery
The presence of this label indicates the use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting the battery.
Failure to observe this recommendation may cause premature wear of the battery.

After refitting the battery, the Stop & Start system will only be active after several hours depending on the climaticconditions and the state of charge of the battery (up to about 8 hours).
)
Raise the locking tab fully.




Disconnecting the cables

Reconnectin
g the cables
)
Position the open clip 1of the cable on thepositive terminal (+) of the battery.
)
Press ver tically on the clip 1
to position it correctly against the battery.)
Lock the clip by spreading the positioning
lug and then lowering the tab 2.
Do not force the tab as locking will not
be possible if the clip is not positionedcorrectly; star t the procedure again.

Procedure for char
ging your battery when it is flat or for star ting the engine using another battery.
The battery is located under the bonnet.To gain access to it:)
open the bonnet using the interior releaselever, then the exterior safety catch,)
secure the bonnet stay, )
remove the plastic cover on the (+)
terminal.
Access to the battery

170
Practical information

The Stop & Start battery does not haveto be disconnected for charging.
Starting using another
battery
)Connect the red cable to the positive
terminal (+) of the flat battery A , then to the positive terminal (+) of the slave battery B.)Connect one end of the green or blackcable to the negative terminal (-) of the
slave battery B.
) Connect the other end of the green or blackcable to the ear th point C
on your vehicle (engine mounting).)
Operate the star ter, let the engine run.)
Wait until the engine returns to idle and disconnect the cables.

Charging the battery using
a battery charger
)Disconnect the battery from the vehicle.)Follow the instructions for use provided by
the manufacturer of the charger.)Connect the battery starting with thenegative terminal (-).)Check that the terminals and connectorsare clean. If they are covered with sulphate (whitish or greenish deposit), remove themand clean them.

172
Practical information
System which manages the duration of use of certain functions to retain a sufficient level of charge in the battery.

After the engine has stopped, you can still usefunctions such as the audio and telematics system, windscreen wipers, dipped beam headlamps, cour tesy lamps, etc. for amaximum combined duration of about thir tyminutes.








Electrical energy economy mode


Switching to economy mode
Once this time has elapsed, a message
appears in the screen indicating that the vehicle
has switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time, it
will
be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.


Exiting economy mode

These functions are reactivated automaticallynext time the vehicle is driven.
)To restore these functions immediately,start the engine and let it run for at least five minutes.

A flat battery prevents the engine from starting (refer to the corresponding section).

183
8
Checks











Bonnet
)Open the left hand front door.


Before doing anything under the bonnet,switch off the Stop & Start system toavoid any risk of injury resulting from anautomatic change to STA R T m o d e .


Closing
)
Take the stay out of its suppor t slot. )
Clip the stay back into its housing. )
Lower the bonnet and release it at the endof its travel. )
Pull on the bonnet to check that it has
latched correctly.
)
Unclip the stay from its housing and place itin the suppor t slot to hold the bonnet open.

Do not open the bonnet under very windy conditions.When the engine is hot, handle the exterior safety catch and the stay with care (risk of burns).


Opening
)
Lift the safety catch and raise the bonnet.


)Pull the release lever, located at the bottom
of the door aper ture, towards you.

194
Checks






Checks
12 V battery

The battery does not require any maintenance.
However, check that the terminals are clean
and correctl
y tightened, particularly in summer and winter.
When carrying out work on the battery, refer to the
"Practical information" section for details of the precautions
to be taken before disconnecting the battery and following its reconnection.
The presence of this label, in particular with
the Stop & Star t system, indicates the use of a specific 12 V lead-acid battery with special
technology and specification. The involvement
of a PEUGEOT dealer or a qualified workshop
is essential when replacing or disconnecting
the battery.
Par ticle emissions filter (Diesel)

The start of saturation of thepar ticle filter is indicated by the
temporary illumination of this warning lamp
accompanied by a warning message in the screen.
As soon as the traffic conditions permit,
regenerate the filter by driving at a speed of at
least 40 mph (60 km/h) until the warning lamp
goes off.
If the warning lamp stays on, this indicates a
low additive level.

On a new vehicle, the first par ticlefilter regeneration operations may be accompanied by a "burning" smell,
which is perfectly normal.
Following prolonged operation of the vehicle at very low speed or at idle, you may, in exceptional circumstances,notice the emission of water vapour at the exhaust on acceleration. This does not affect the behaviour of the vehicle or the environment. Unless other wise indicated, check these components in accordance with the ser vicin
g booklet and according to your engine.Other wise, have them checked by a PEUGEOT dealer or a qualified workshop.
Air filter and passenger compartment filter

Refer to the ser vicing booklet for
details of the replacement inter vals
for these components.
Depending on the environment (e.g.
dusty atmosphere) and the use of the vehicle(e.g. city driving), replace them twice as oftenif necessary.y A clogged passenger compar tment filter may
have an adverse effect on the performance
of the air conditioning system and generateundesirable odours.
Oil filter
Replace the oil filter each time theengine oil is changed.
Refer to the servicing booklet for
details of the replacement inter val for
this component.

202
Technical data
ENGINES AND GEARBOXES
Diesel engines1.6 litree-HDi 92 hp1.6 litre e- HDi115 h p
GearboxesElectronic
(6-speed)Manual (6-speed)

Model codes: CC... CA...
9HPP - 9HP8/PS9HD8/S - 9HR8/S
Cubic capacity (cc) 1 560

1 560

Bore x stroke (mm)

75 x 88.3

75 x 88.3

Max power: EU standard
(kW) 6884
Max power en
gine speed (rpm)
4 000 3 600
Max torque: EU standard
(Nm)
230270

Max torque engine speed (rpm) 1 750

1 750

F
uel
Diesel Diesel

Catalytic conver ter yesyes

P
article emission filter yesyes

OIL CAPACITIES
(in litres)
Engine (with filter replacement) -3.75
...
/S: e-HDi model fitted with Stop & Start.

04
220

TOWARDS A NEW DESTINATION


CHOOSING A DESTINATION
Select "Navigation GPS
".


Select "Save
" to save the address entered as a contact entry.
The s
ystem allows up to 200 entries.
Select "Confi rm" or press the screen (blue
arrow) to start navigation guidance.
Select "Address
".


Select the " Country
" from the list offered then in the same way:
th
e " City" or its post code, the "Street",
the " N°". Confi rm each time.
Select "Guide ".


Choose the restriction criteria: "Tollroads",
" Ferries", " Near".
r

Choose the navigation criteria: " Fastest
" or the
"Shortest
" or " Time/Distance compromise".The route is displayed in the map (on the right).

To delete navi
gation information, press on
" Settings
" then " Stop navigation
".

To restore the navi
gation information press on
"Settings
" then " Restart navigation".
Press MENUto display the " MAIN MENU " then select " Navigation".
NAVIGATION - GUIDANCE