2012 NISSAN XTERRA reset

2
essential information
0201
03
01
loosE fuEl C aP
A loos E fuEl CaP warning message will appear
in the odometer

01 when the fuel-filler cap is not
tightened correctly.

To tighten, turn the cap clockwise until a single click
is heard.

The warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button

02 is pressed for more than 1 second.


if the cap is not properly tightened the Malfunction
indicator Light
may illuminate.f
or more information, refer to the “instruments and controls (section 2)” and the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
tirE Pr Essur E monitorin G systEm (tPms)
A CHECK tir E PrEs warning message will
display in the odometer
01 and the low tire pressure

warning light 02 will illuminate when one

or more tires are low on pressure and air
is needed.
• The tire pressures should be checked
when the tires are cold. The tires are considered
cold after the vehicle has been parked for 3 hours
or more or driven less than 1 mile (1.6km) at
moderate speeds.

After tire pressures are adjusted, press the reset
button
03 for more than 1 second. drive the vehicle

at speeds above 16 MPH (25km/h). The CHECK
tirE P rEs warning message and low tire pressure warning light will disappear.

When the low tire pressure warning light flashes for approximately 1 minute and then remains on,
the TPMS is not functioning properly. Have the system checked by a NISSAN dealer.

Tire pressure rises and falls depending on the heat caused by the vehicle’s operation and the
outside temperature. Low outside temperature can lower the temperature o\
f the air inside the
tire, which can cause a lower tire inflation pressure. This may cause the low tire pressure
warning light to illuminate. If the warning light illuminates in low ambient temperature, check
the tire pressure in your tires.
• Check the tire pressures (including the spare tire) often and always prior to long distance trips.

The Tire and Loading Information label contains valuable information. Please refer to section 9,
“Technical and consumer information”, in your Owner’s Manual for the location of the Tire and
Loading Information label.
for more information, refer to the “instruments and controls (section 2)”, the “starting and driving (section 5)” and the
“maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
CHECK
TIRE
PRE S
02

CruisE Control
The cruise control system enables you to set a constant
cruising speed once the vehicle has reached 25 mph.

The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.

To activate the cruise control, push the ON•OFF
switch

01 . The C
ruisE indicator light in the
instrument panel will illuminate.

To set cruising speed, accelerate the vehicle to the
desired speed, push the Coast/ sEt switch

02
and release. The s
Et indicator light in the instrument panel will illuminate. Take your foot off
the accelerator pedal. Your vehicle will maintain the set speed.

To reset at a faster cruising speed, push and hold the a CCEl/rEs switch
03 . When the
vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the Coast/ sEt switch
02 . Release

the switch when the vehicle slows to the desired speed.

To cancel the preset speed, tap the brake pedal or push the C anCEl switch
04 .

To turn off cruise control, push the ON•OFF switch
01 . Both the C
ruisE
indicator light and s Et indicator light in the instrument panel will turn off.
for more information, refer to the “starting and driving (section 5)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
03 s
EEK/tra CK Button

To scan quickly through each broadcasting station, press the s EEK/traCK button.

To skip from one track to another on a cd, press the s EEK/traCK button. Each
time the button is pressed, the CD will advance or skip back one track.
04 station an
D CD sElEC t Buttons

Eighteen stations can be set in any combination of FM, AM and XM® satellite radio stations.

To store a station in a preset you must first select the A, B, or C memory bank by pressing
the PrEs Et a·B·C button

05 .

Then tune to the desired f M, AM or XM station.

Next press and hold the desired station select button (1 -6 ) for at least 2 seconds. When
the preset indicator illuminates, a beep will sound, indicating memorization is complete.

To retrieve a previously set station, select the memory bank where the preset was set,
then press the corresponding station select button (1 -6 ).

While playing a cd, to select a different cd loaded into the cd changer, press one
of the CD select buttons (1 -6 ).
for more information, refer to the “Heater, air conditioner, audio and phone systems (section 4)” of your Owner’s Manual.
03
02
04
01
9

triP Com PutEr (if so equipped)
With the ignition switch in the on position, modes
of the trip computer

01 can be selected by pressing
the trip computer change button
02 on the
instrument panel.

The following modes can be selected in the display:
• Trip a – measures the distance of one specific trip.
• Trip B – measures the distance of a second specific trip.
• dte (distance to empty) – displays the estimated distance to empty (dte) the vehicle can
be driven before refueling.
• mph – displays the average speed since the last reset.
• mpg – displays the average fuel consumption since the last reset.
• (Journey time) – displays the elapsed time since the last reset.
for more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
0201
Blu EtootH® Han Ds-fr EE PH onE systE m (if so equipped)
With an overhead microphone and sound
transmitted through the audio system speakers,
the Bluetooth
® Hands-free Phone System utilizes
Bluetooth wireless technology and voice recognition
to provide hands-free cellular phone communication.

A cellular telephone should not be used while driving
so full attention may be given to vehicle operation.*
SYSTe M OPeRATin G TiPS
close all windows. Surrounding noises may interfere
with system operation and performance.

Press the
button on the steering wheel to activate
voice recognition.

Wait for the tone before speaking.

Begin speaking a command within 5 seconds of the tone.

Speak in a clear and natural voice without pausing
between words.

Look straight ahead and avoid speaking too loudly or too softly.

To go back to the previous command, say “Go back” or “Correction.”

To cancel a voice recognition session, simply wait 5 seconds, say “cancel” or “Quit,” or press
the

button for 5 seconds.


To interrupt the system voice and give a command quickly, press the
button.

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.11
*Some jurisdictions prohibit the use of cellular telephones while driving.
system guide
microphone