2012 NISSAN ALTIMA COUPE key

*See your Owner’s Manual for information.
02
05
01
03
04
09
15
06
12
16
13
14
11
10
07
08
LOW TiRe PRe SSuRe WARnin G LiGHT
V e H icL e inf ORMAT iOn diSPLAY
H eAd LiGHT And Tu Rn S iG nAL c OnTROL
in STR uM enT BR iGHTne SS cOnTROL* TW
in TR iP O dOM eTe R / TR iP c HAn Ge
B uTTO n*
W ind SHieL d W iPeR / WASHeR SW iT c H
STee Rin G WH eeL SW iTc HeS fOR
A udi O* / BLueTOOTH
® / nAVi GATiOn
cR uiSe cOn TROL TRunk
Lid OP eneR
Ve Hic Le d YnAM ic cOnTROL (Vdc)
O ff SW iTc H*
inTe LLiGenT keY PORT
Ti LT / Te LeSc OP ic STee Rin G
c OLu Mn* HOO
d ReLeAS e*
f RO nT PASS enGeR Ai R BAG
STATu S LiGHT*
A udi O And nAVi GATiOn SYSTe M
A uTOMATic c LiMATe c OnTROLS
01020304
05
09
13
06
10
141516
07
11
08
12

01
3
first drive features
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
02
03
04
05
06
NISSAN INTELLIGENT k EY® SYSTE M
The niSSAn intelligent k ey® system allows you to lock
or unlock the vehicle, open the trunk and start the engine.
n OTe: it is important to make sure the intelligent k ey is
with you (that is, in your pocket or purse).

The operating range of the intelligent k ey is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle request
switch

01 once or press the
button
02 on
the keyfob.

To unlock the vehicle, perform one of the following
procedures:
• Push either door handle request switch

01 once;
the corresponding door will unlock. Push the door
handle request switch

01 again within 1 minute;
all other doors will unlock, or
• Press the

button
03 on the keyfob to unlock the driver’s side door. Press the
button

again; all other doors will unlock.

To release the trunk lid, press the button
04 for more than 0.5 seconds. Lift the trunk lid
to access the trunk.

The Intelligent Key can also be used to activate the panic alarm by pressing and holding the

button
05 for more than 0.5 seconds. Once activated, the panic alarm and headlight\
s will stay
on for 25 seconds.
ni SSAn inTe LLiGenT keY
® BATTe RY diSc HARG e

If the battery in the Intelligent Key is almost
discharged, the guide light

06 of the intelligent
Key port blinks and the Intelligent Key battery
discharge indicator

07 is displayed in the vehicle
information display.

To start the engine under these circumstances, insert
the Intelligent Key into the key port with the buttons
facing upward and the key ring end toward you until
it latches into place. Then push the ignition switch to
start the engine.

To remove the intelligent k ey from the port, push the
ignition switch to turn the engine off and then pull the
intelligent k ey out of the port.

The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery
indicator

07 , replace the battery in the Intelligent Key.
f
or more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section
5)” and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
F
07

OUTSIDE MIRROR CONTROL SWITCh
To select the right or left side mirror , turn the control
switch

01 right or left.

To adjust the mirror angle, move the control switch
up, down, right or left.

To prevent accidentally moving the mirror, turn and
set the switch to the middle “neutral” position.
for more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
P ASSENGER REAR SEAT ENTRY/EXIT (Coupe models only)
enTRY f ROM O uTSide TH e VeHic Le

Pull the seat recliner lever 01 to the uppermost
position pushing the seatback forward. Slide the
entire seat forward to access the rear seat.
eXi TinG fROM inSide TH e VeH icL e

Pull the upper seatback release lever 02 to the
uppermost position, pushing the seatback forward.
Slide the entire seat forward to exit from the rear seat.
for more information, refer to the “Safety –– Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
01
02
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.5
01
STARTING/STOPPING Th E ENGINE
cOnTinuOuSLY VAR iABL e TRA nSM iSSiOn
(if so equipped)

Depress the brake pedal.

Move the shift lever to P (PAR k).

Push the ignition switch to start the engine.
n OTe: it is important to make sure the ni SSAn intelligent
key
® is with you (that is, in your pocket or purse).
MAnu AL TRAn SMiSS iO n (if so equipped)

Depress the brake pedal.

Move the shift lever to N (N EUTRAL).

depress the clutch pedal to the floor.

Push the ignition switch to start the engine.

system guide
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.12
Speak in a clear and natural voice without pausing between words.

Look straight ahead and avoid speaking too loudly or too softly.

To go back to the previous command, say “Go back”.

To cancel a voice recognition session, say “exit” or press and hold the
or
button.

To interrupt the system voice and give a command quickly, press the
or
button.

When speaking Phonebook names, please be aware some phones require the last name to be
spoken before the first name. For example, “Michael Smith” may be spoken as “Smith Michael”.

To increase or decrease the volume of the voice prompts, push the volume \
control switches

or
+ on the steering wheel or turn the VOL/ON•OFF control knob on the audio system

while the system is responding.

if the Voice Recognition system does not recognize your voice commands, train th\
e system
using the Speaker Adaptation Mode. See your Owner’s Manual for detailed information.

Some commands are not available while the vehicle is in motion.

The “Help” command can be used to hear a list of available commands at any time.

Please refer to the cellular phone manufacturer’s Owner’s Manual f\
or detailed information
regarding your Bluetooth phone.
Bluetooth System without Navigation (if so equipped)
cOnnec TinG PROcedu Re
NOTE: The vehicle must be stationary when connecting
the phone.
1. Press the

button on the steering wheel. The
system announces the available commands.
2. Say: “connect phone”. The system acknowledges
the command and announces the next set of
available commands.
3. Say: “Add phone”. The system acknowledges the
command and asks you to initiate connecting from
the phone handset.
4. initiate connecting from the phone:

The connecting procedure varies according to each cellular phone model. f or detailed
connecting instructions and compatible phones, please visit
www.nissanusa.com/bluetooth.

When prompted for a Passkey code, enter “1234” from the handset. (The Passkey code is
assigned by NISSAN and cannot be changed.)
5. Say a name for the phone when the system asks you to provide one. You can give the phone
a name of your choice.

Bluetooth System with Navigation (if so equipped)
cOnnecTinG PROcedu Re
NOTE: The vehicle must be stationary when connecting
the phone.
1. Press the SETTING button on the instrument panel
and select the “Bluetooth” key on the display.
2. Select the “connect Bluetooth” key.
3. A popup box will appear on the screen, prompting
you to confirm that the connection is for the phone
system. Select the “Yes” key.
4. initiate connecting from the phone.

The connecting procedure varies according
to each cellular phone model. f or detailed
connecting instructions and a list of
compatible phones, please visit
www.nissanusa.com/bluetooth.

When prompted for a P in code, enter “1234”
from the handset. (The PIN code is assigned by NISSAN and cannot be changed.)
5. When connecting is complete, the screen will return to the Bluetooth sett\
ings screen.
system guide
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.14

PHOneBOOk SeTu P

depending on your cell phone, the system may automatically download your \
cell phone’s
entire phonebook to the vehicle’s Bluetooth system.

If the phonebook does not download automatically, the vehicle phonebook may be set for up to
40 entries.

To manually download entries:
1. Press the Ph ONE
button and select the
“Vehicle Phonebook” key.
2. Select the “Add new” key at the top of the display.
There are different methods to input a phone
number. Select one of the following options:
• “Copy from Call History” to save a number from
the Outgoing, incoming or Missed calls lists.
• “Copy from the Handset” to save a number that
has been downloaded from your handset to
the vehicle.
• “Enter Number by Keypad” to input the number
and name manually.
MAkin G A cALL
To make a call, follow this procedure:
1. Press the Ph ONE button on the instrument panel or
the

button on the steering wheel. The “Phone”
menu will appear on the control panel display.
2. Select the “Vehicle Phonebook”, “Call History”,
“Handset Phonebook” or “Dial Number” key.
3. Select the desired entry from the list.
4. Dialing begins when the entry is selected or when the “OK” key is selected.
Recei Vin G/endin G A cALL

To accept the call, press the Ph ONE button on the
instrument panel, the

button on the steering
wheel or touch the “Answer” key. To reject the call,
touch the “Reject call” key.

To hang-up, press the
button or touch the
“Hang-up” key.
for more information, refer to the “Monitor, climate, audio, phone and
voice recognition systems (section 4)” of your Owner’s Manual or
visit www.nissanusa.com/bluetooth.
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.15