2012 MITSUBISHI OUTLANDER Seat back

Seat and restraint systems
2-11
2
Arm rest
(if so equipped)
N00402300069
The lid on the floor console box can be moved forward and
backward and used as an arm rest.
Heated seat (if so equipped)
N00435600310
The heated seats can be operated by pushing the switch when
the ignition switch is in the “ON” position. The indicator light
(A) will illuminate while the heater is on.1 (HI) - Heater high (for quick heating)
2 - Heater off
3 (LO) - Heater low (to keep the seat warm)
BK0138000US.book 11 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-13
2 Second row seats (60/40 split fold/tumble
seats)
N00402500205
When sitting in the second row seat, adjust the head restraints
to heights at which they lock in position. Refer to “Head
restraints” on page 2-26. To adjust the seat forward or backward (vehicles
with second row seat slide function)Pull the seat adjusting lever and gently rock the seat forward or
backward to the desired position. Release the adjusting lever to
lock the seat in place.NOTE
You can adjust the seat forward or backward on either side
separately.
WA R N I N G
!
To make sure that the seat is securely locked, try to
move it forward or backward without using the
adjusting lever.
CAUTION
!
When sliding (vehicles with second row seat slide
function) or reclining the seat rearward, pay careful
attention to the third row seat passengers.
BK0138000US.book 13 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-14 Seat and restraint systems
2
To adjust the seatbacksTo adjust the seatback, lean forward slightly, gently pull the
seatback lock lever, then lean backward to a comfortable posi-
tion and release the lever. The seatback will lock in place.NOTE
You can adjust the seatback forward or backward on either
side separately.
WA R N I N G
!
To reduce the risk of serious injury or death in the
event of an accident or sudden stop, all seatbacks
should be kept in the upright position while the vehi-
cle is in motion.

Seat belt performance during an accident can be
adversely affected if the seatbacks are reclined. The
more a seatback is reclined, the more likely seat belt
performance will be adversely affected. If the seat
belt is not properly positioned against the body dur-
ing an accident, there is increased risk you will slide
under the belt and receive serious injury or death.
When a person is sitting in the middle seating posi-
tion of the second row seats, the two sides of the sec-
ond seats must have the same forward/backward
position (vehicles with second row seat slide func-
tion) and the same seatback angle. Otherwise, the
seat belt for the middle seating position may not be
adequately effective in the event of hard braking or
a collision.
CAUTION
!
The reclining mechanism used in the seatback is
spring loaded, and will cause the seatback to return
quickly to the vertical position when the lock lever is
operated. When pulling the lever, sit close to the
seatback or hold the seatback with your hand to
control its return motion.
WA R N I N G
!
BK0138000US.book 14 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-16 Seat and restraint systems
2Third row seat (Seating 7 passengers)
N00419500063
The third row seat can be used for two additional passengers.
When the third row seat is not in use, it can be stowed under
the floor to provide more cargo area.
WA R N I N G
!
The third row seats are intended for use by no more
than two belted occupants, each of which does not
exceed 160 cm (63 inches) in height.
Exceeding these limitations can result in an
increased risk of personal injury or death in the
event of an accident.
The third row seats are not intended for use by
infants and small children who must use rear facing
or forward facing child safety seats.
Third row seat operation should always be made
before driving. Operating the seat while driving
could cause the seat to move more than necessary
and result in a serious injury or death.
Before using, check that the third row seat is firmly
secured. If not secured, the third row seat could
move and cause a serious injury or death in an acci-
dent.
The third row seat should not be used when the sec-
ond row seats are folded forward. Third row seat
passengers can suffer a serious or fatal injury if the
second row seats fell backward in a collision or when
heavy breaking is applied.

When using the third row seat, always position and
lock the head restraints on top of the seat back.
See the steps 6 and 7 of the procedure for folding out
the third seat.
For vehicles equipped with the cargo area cover,
when the third row seat is in use, always remove the
cargo area cover to avoid serious injury or death in
the event of an accident.
Refer to “Cargo area cover”, page 3-287.
CAUTION
!
The third row seat should be adjusted only by an
adult. If it is adjusted by a child, an unexpected acci-
dent might occur.
When adjusting the third row seat, keep your hands
and feet away from moving parts and the space
below the seat.
Be careful not to touch the exhaust pipe, because it
will remain hot for some time after the engine is
stopped.
WA R N I N G
!
BK0138000US.book 16 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-17
2
To fold out the third seat1. Open the tailgate. Refer to “Flap-fold tailgate” on page 3-
60.
2. From the rear of the vehicle, pull up the cover.
Secure the cover to the seatback with the strap (A).3. Pull on the strap (B) on the center of the seatback to raise
the seatback upright.
BK0138000US.book 17 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-18 Seat and restraint systems
2
4. Pull the strap (C-black) to release the lock. 5. Tilt the third row seat assembly backward.
NOTE
If the third row seat is locked to the floor after tilting the
third row seat assembly backward, pull the strap (C-black)
again to release the lock.
BK0138000US.book 18 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

Seat and restraint systems
2-19
2
6. Pull the head restraints off the front of the seatback. 7. First check that the head restraints are facing in the right
direction and then insert them into the seatback. The stay
with the notch (D) must be installed in the hole with the
lock knob (E). Push the head restraints down until the
restraints lock into place.
BK0138000US.book 19 ページ ２０１１年４月１３日　水曜日　午前１１時１７分

2-20 Seat and restraint systems
2
8. Lift the third row seat assembly up from the floor and
move it forward to secure it in place.
CAUTION
!
Check that the lock knob (E) is extended out as
shown in the illustration. Then pull the head
restraint up to make sure that it is locked in place
and will not come out of the seatback.
BK0138000US.book 20 ページ ２０１１年４月１３日　水曜日　午前１１時１７分