4CONTROLS
Regular Headlights Automatic Headlights
Headlights and other lights on.
Parking, tail, front and rear sidemarker lights, license plate
and instrument panel lights on.
Headlights and other lights turn on and off automatically in
accordance with outside light level.
All lights off
AUTOOFF
Fog Lights (if equipped)
Dimmer Switch
Illuminate only when headlights are on low beam.
Turning the knob in the direction of the ON position turns
on the fog lights. Turning the knob in the direction of the
OFF position turns off the fog lights. The knob will return
to the neutral position when released.
• Dimmer (high/low beam change)
To change the headlights from high beam to low beam and vice
versa, pull the turn signal lever fully toward you (1).
An illumiated blue light in the instrument cluster indicates when the
headlights are on high beam.
• Headlight flasher
You can flash the high beams by pulling the lever gently toward you (2).
6OWN THE ROAD
A - CANCEL: To deactivate the cruise control
B - ACC RES: To increase the set speed
C - COAST SET: To set the desired speed and to reduce
the set speed.
D - ON / OFF: To ON/OFF cruise control
To set a cruising speed
1. Press D and the “CRUISE”
indicator light in the meter
cluster will be turned on.
2. Accelerate or decelerate to your desired speed (above
25 mph). Press C and remove your foot from the
accelerator pedal.
To accelerate or decelerate speed
Press B to increase set cruising speed.
Press C to decrease set cruising speed.
To cancel the cruising speed
Press A or press brake pedal, or press D .
– :SHIFT DO WN+ :SHIFTUP
Paddle Shifters (if equipped)
Seat Heater Switch
Position - Action
(HI) - For quick heating
(LO) - To keep the seat warm
Drive Mode Selector (if equipped)
The drive mode can be selected by pressing the switch
while the ignition switch is in the ON position.
2WD: This mode is for economical driving on normal
dry roads and freeways.
4WD AUTO: This mode is for all driving conditions on
various roads.
4WD LOCK: This mode is for driving in slippery
conditions such as on snow-covered roads or sand.
Cruise Control Clock
To set the time
1. Press and hold A and the clock display
flashes.
2. Press C to set the “Hours”.
3. Press D to set the “Minutes”.
4. Press B to stop the clock display from
flashing.
A
ABCD
B
C
D
Simply upshift or
downshift with a
tap of your fingers
– without moving
your hands from the
steering wheel.
You can return to
the “D” operation by
pulling the + (SHIFT
UP) side paddle shifter
rearwards (toward the
driver) and holding for
over 2 seconds.
