2012 MITSUBISHI iMiEV maintenance

7-36 Vehicle care and maintenance
7
Bulb capacity
N00943000099
The bulb should only be replaced with a new bulb with the
same rating and type. The type and rating are listed on the base
of the bulb.Outside
N00950300847
NOTE
Check with a certified i-MiEV dealer when the headlight
and the parking light need to be repaired or replaced.
Description
Wa t t a g e
ANSI Trade
No. or Bulb
type
1- Headlight, low beam 55 W H11
2- Head light, high beam 60 W 9005 HB3
3- Front fog light (if so
equipped)35 W H8Front
4- Daytime running light
(if so equipped)13 W P13W
5- Front turn signal light 21 W W21W
6- Parking light 5 W W5W
7- Front side-marker light 5 W W5W
Description
Wa t t a g e
ANSI Trade
No. or Bulb
type
BK0140800US.book 36 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-37
7
NOTE
The tail and stop lights use LEDs rather than bulbs.
For repair and replacement, contact a certified i-MiEV
dealer.
Inside
N00950400604
Adjustment of headlight aim
N00943200349
The alignment of the headlights should be checked by a certi-
fied i-MiEV dealer.
Description
Wattage
ANSI Trade
No. or Bulb
type
8- High-mounted stop
light5 W W5W
9- Tail and stop light — —
10- Rear turn signal light 21 W WY21W
11- License plate light 5 W W5W
12- Rear side-marker light 5 W W5W
13- Back-up light 21 W W21WRear
Description
Wattage
1- Dome light (Rear) 8 W
2- Dome light (Front)/Read-
ing lights8 W
BK0140800US.book 37 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-38 Vehicle care and maintenance
7
Front side-marker lights
N00915500161
1. Insert a flat blade screwdriver into the end of the light
nearer the rear of the body and pry gently to remove the
light.NOTE
Wrap a cloth around the tip of the screwdriver to keep
from scratching the lens.2. Remove the socket and bulb assembly together by turning
it counterclockwise.*: Front of the vehicle
*
BK0140800US.book 38 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-39
7
3. Pull the bulb out of the socket. 4. To install the bulb, perform the removal steps in reverse.
NOTE
When installing the light assembly, push in the end facing
the front of the vehicle first.*: Front of the vehicle
BK0140800US.book 39 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-40 Vehicle care and maintenance
7
Front turn signal lights/Front fog lights (if so
equipped)/Daytime running lights
(if so equipped)
N00943400312
1. To create enough work space, turn the steering wheel all
the way in the same direction to the side you wish to
replace.
2. Remove the clip (A) and bolts (B), then lift the cover (C).3. Turn the socket counterclockwise to remove it.
D- Front turn signal light
E- Front fog light
F- Daytime running light
BK0140800US.book 40 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-41
7
4. Remove the bulb as follows.
[Front turn signal light]
Pull the bulb out of the socket.
[Front fog light and daytime running light]
While holding down the tab (F), pull out the bulb assem-
bly (G).5. To install the bulb, perform the removal steps in reverse.Front fog light
Daytime running light Front turn signal light
CAUTION
!
Handle halogen light bulb with care. The gas inside
a halogen light bulb is highly pressurized, so drop-
ping, knocking, or scratching a halogen light bulb
can cause it to shatter.
Never hold the halogen light bulb with a bare hand,
dirty glove, etc.
The oil from your hand could cause the bulb to
break the next time the fog lights are used.
If the glass surface is dirty, clean it with alcohol and
let it dry completely before installing the bulb.
BK0140800US.book 41 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-42 Vehicle care and maintenance
7
Rear combination lights
N00943700487
1. Open the liftgate.
(Refer to “Liftgate” on page 3-16.)
2. Remove the screws (A) that hold the light unit and remove
the light unit.3. Move the light unit toward the rear of the vehicle and
remove the pins (B) of the light unit from the vehicle.
BK0140800US.book 42 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-43
7
4. Turn the socket counterclockwise to remove it.NOTE
The tail and stop lights use LEDs rather than bulbs.
For repair and replacement, contact a certified i-MiEV
dealer.5. Pull the bulb out of the socket.
6. To install the bulb, perform the removal steps in reverse.C- Tail and stop light (LED) - cannot be replaced
D- Rear turn signal light
E- Back up light
BK0140800US.book 43 ページ ２０１１年９月２９日　木曜日　午後３時２８分