2012 MITSUBISHI iMiEV brake light

For emergencies
6-7
6
As your vehicle has anti-lock brakesIf you drive your vehicle with a low battery charge, after the
electric motor unit has been started by using jumper cables, it
can cause the anti-lock braking system warning light to illumi-
nate. This is only due to the low battery voltage. It is not a
problem with the brake system. If this happens, fully charge the
12V starter battery and ensure the charging system is operating
properly.
Tire repair kit
N00836600366
This vehicle is equipped with a tire repair kit which can be
used to repair a minor puncture in tread area caused by a nail,
screw or similar object. A spare tire is not provided with this
vehicle.
WA R N I N G
!
The tire repair kit may not permanently seal a punc-
tured tire.
Using the tire repair kit may damage the wheel
and/or the tire inflation pressure sensor for the tire.
The vehicle must promptly be inspected and
repaired by a certified i-MiEV dealer after using the
tire repair kit.
Use only the Mitsubishi genuine tire repair kit. Seal-
ant in other repair kits may not sufficiently seal the
tire puncture.
BK0140800US.book 7 ページ ２０１１年９月２９日　木曜日　午後３時２８分

6-22 For emergencies
6Operation under adverse driving conditions
N00837200747
If your vehicle becomes stuck in sand, mud or
snow If your vehicle becomes stuck in snow, sand, or mud, it can
often be moved by a rocking motion. Rock your vehicle back
and forth to free it.
Do not spin the wheels. Constant efforts to free a stuck vehicle
can cause transmission failure.
If your vehicle is still stuck after several rocking attempts, call
for a commercial tow truck service.
On wet roads
WA R N I N G
!
When trying to rock your vehicle out of a stuck posi-
tion, make sure that there are no people nearby. The
rocking motion can make your vehicle suddenly
lurch forward or backward, and injure any
bystanders.
CAUTION
!
Do not drive on a flooded road. If you drive on a
flooded road, not only the electric motor unit stops
but also a failure like electric leakage or short circuit
may occur.
If you inevitably had to run on a flooded road and
the vehicle was exposed to water, be sure to have
your vehicle inspected by a certified i-MiEV dealer.
When driving in rain, on water-covered roads, or
through a car wash, water could get into the brake
discs and make them fail temporarily. In such cases,
lightly press the brake pedal to see if they are work-
ing properly. If they are not, press the pedal lightly
several times while driving to dry the brake pads or
linings, then check them again.
When driving in rain, a layer of water may form
between the tires and the road surface (aquaplan-
ing). This loosens your tires’ grip on the road, mak-
ing it difficult to steer or brake properly. When
driving on a wet road:
• Drive your vehicle at a safe speed.
• Do not drive on worn tires.
• Always keep the tires at the correct inflation pres-
sures.
BK0140800US.book 22 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7
Vehicle care and maintenance
Service precautions . . . . . . . . . . . . . . . . . . . . . . . .7- 2
Hood. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 4
View under the hood and
electric motor unit room . . . . . . . . . . . . . . . . . . .7- 6
Coolant/Hot water heater fluid. . . . . . . . . . . . . . . .7- 7
Washer fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 11
Brake fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 12
12V starter battery . . . . . . . . . . . . . . . . . . . . . . . . .7- 13
Tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 18
Brake pedal free play . . . . . . . . . . . . . . . . . . . . . . .7- 25
Parking brake lever stroke . . . . . . . . . . . . . . . . . . .7- 25
Wiper blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 26
General maintenance . . . . . . . . . . . . . . . . . . . . . . .7- 27
For cold and snowy weather . . . . . . . . . . . . . . . . .7- 28
Fusible links . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 28
Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7- 29
Replacement of light bulbs . . . . . . . . . . . . . . . . . .7- 35
Vehicle care precautions . . . . . . . . . . . . . . . . . . . .7- 49
Cleaning the inside of your vehicle . . . . . . . . . . . .7- 50
Cleaning the outside of your vehicle . . . . . . . . . . .7- 52
BK0140800US.book 1 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-12 Vehicle care and maintenance
7Brake fluid
N00938700261
To check the fluid levelThe brake fluid level must be between the “MAX” and “MIN”
marks on the reservoir.
The brake fluid level falls slightly with wear of the brake pads,
but this does not indicate any abnormality.
The brake fluid in the master cylinder should be checked when
doing other work under the hood. The brake system should also
be checked for leaks at the same time.
If the brake fluid level falls markedly in a short length of time,
it indicates a leak in the brake system.
If this occurs, have the vehicle checked by a certified i-MiEV
dealer.
Fluid typeUse the recommended brake fluid conforming to DOT 3 or
DOT 4. The reservoir cap must be tightly sealed to keep dirt
and water out.
CAUTION
!
Do not let any petroleum-based fluid touch, mix
with, or get into the brake fluid. This will damage
the seals.
Be careful when handling brake fluid. It can damage
painted surfaces.
Use only the listed brake fluid. Different brands of
brake fluid have different additives, and these can
cause a chemical reaction. Do not mix brands of
brake fluid.
Keep the reservoir tank cap closed to keep the brake
fluid from evaporating.
BK0140800US.book 12 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-27
7 General maintenance
N00941500289
The next pages list the maintenance service recommended by
Mitsubishi Motors Corporation. In addition to the general
maintenance that needs to be performed at the times listed,
there are other parts which do not usually need regular mainte-
nance.
But, if any of these parts stops working properly, your vehicle
performance could suffer. Have these items checked if you
notice a problem with them.
See a certified i-MiEV dealer for assistance, if you have any
questions.Disc brake pads, rear drum brake linings and
rear wheel cylinders
N00941600033
Good brakes are essential to safe driving. Check the brake pads
and brake linings for wear and check the rear wheel cylinders
for leaks. For good braking performance, replace the brake
pads with the same type pads as the originals.Brake hoses
N00941700047
Brake hoses and tubing should be checked for:

Severe surface cracking, scuffing or worn spots. If the
fabric casing of the hose is showing through any cracks or
worn spots in the rubber hose cover, the hose should be
replaced. The brakes can fail if the hose wears through.

Improper installation may cause twisting, or wheel, tire or
chassis interference.
Ball joint, steering linkage seals and drive shaft
boots
N00941800077
Check the following parts for damage and grease leaks:

Ball joint boots of the front suspension and steering link-
age

Bellows on both ends of the drive shaftHood lock release mechanism and safety catch
N00942500114
The hood lock release mechanism and hood safety catch should
be checked, cleaned, and oiled when needed for easy move-
ment and to stop rust and wear. Use Multipurpose Grease
NLGI Grade 2 sparingly for all sliding parts of the hood latch
and release lever. Work the grease into the hood lock mecha-
nism until all the movable surfaces are covered.
Also, put a light coat of the same grease on the safety catch
wherever moving parts touch.
BK0140800US.book 27 ページ ２０１１年９月２９日　木曜日　午後３時２８分

7-32 Vehicle care and maintenance
7
Under the hood fuse location table
*: Fusible link

Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.

The table above shows the main equipment corresponding
to each fuse.
No.
Symbol
Electrical system
Capacity
1— — —
2 12V starter battery 30 A*
3 Electric motor switch 40 A*
4 Radiator fan motor 40 A*
5 Power window control 40 A*
6 Brake electric vacuum pump 30 A*
7 Electric motor unit control 15 A
8 Stop lights (Brake lights) 15 A
9 Front fog lights 15 A
10Wa t e r p u m p
(Electric motor unit)15 A
11 Charge 10 A
12 Hazard warning flasher 10 A
13 Horn 10 A
14 Daytime running lights 10 A
15Main drive lithium-ion bat-
tery fan motor15 A
16Wa t e r p u m p
(Air conditioning)10 A
17 Headlight (low beam) (right) 20 A
18 Headlight (low beam) (left) 20 A
19 Headlight (high beam) (right) 10 A
20 Headlight (high beam) (left) 10 ANo.
Symbol
Electrical system
Capacity
BK0140800US.book 32 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Vehicle care and maintenance
7-55
7
Cleaning plastic parts
N00946300211
Use a sponge or chamois to clean these parts.
If a vehicle wax sticks to a gray or black rough surface of the
bumper, molding or lights, the surface may appear white in
color. In this case, wipe it off using lukewarm water and a soft
cloth or chamois. Chrome parts
N00946400065
To prevent spots and corrosion of chrome parts, wash with
water, dry thoroughly, and apply a nonabrasive automotive
wax. If the chrome is severely damaged or pitted, use a com-
mercially available chrome polish.
Aluminum wheels (if so equipped)
N00946500196
1. Remove dirt using a wet sponge.
2. Use a mild detergent on any dirt that cannot be removed
easily with water.
Rinse off the detergent after washing the wheel.
3. Dry the wheel thoroughly using a chamois leather or a soft
cloth.Window glass
N00946600067
The window glass can usually be cleaned using only a sponge
and water. Glass cleaner can be used to remove wax, oil,
grease, dead insects, etc. After washing the glass, wipe it dry
with a clean, dry, soft cloth.
CAUTION
!
Do not use a scrubbing brush or other rough scrub-
ber as these may damage the plastic surface.
Do not use wax containing compounds (polishing
powder) which may damage the plastic surface.
Do not let the plastic parts get soiled with gasoline,
oil, brake fluids, greases, paint thinner, and sulfuric
acid (battery electrolyte). These fluids, etc., may
crack, stain or discolor the plastic parts.
If any of these get on the plastic parts, wipe them up
with a soft cloth or chamois and a mild solution of
soap and water. Then rinse them immediately with
water.
CAUTION
!
Do not use a brush or other hard implement on the
wheels.
Doing so could scratch the wheels.
Do not use any cleaner that contains an abrasive
substance or is acidic or alkaline. Doing so could
cause the coating on the wheels to peel or become
discolored or stained.
Do not directly apply hot water using a steam
cleaner or by any other means.
Contact with seawater or road salt used for de-icing
can cause corrosion. Rinse off such substances as
soon as possible.
BK0140800US.book 55 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Alphabetical index
1
A
Accessory (installation) 1-7
Acoustic vehicle alerting system (AVAS) 3-38
Active stability control 3-46
ASC indicator 3-48
ASC OFF indicator 3-48
ASC OFF switch 3-47
Skid control function 3-47
Traction control function 3-46
Air conditioning 5-6
Important air conditioning operating tips 5-17
Air purifier 5-18
Aluminum wheels 7-55
Antenna 5-40
Anti-lock braking system 3-41
Warning light 3-42
,3-43
ASC 3-46
ASC indicator 3-48
ASC OFF indicator 3-48
ASC OFF switch 3-47
Assist grip 3-131
Audio
AM/FM electronically tuned radio with CD player 5-18
Error codes 5-37
Handling of compact discs 5-38
Steering wheel audio remote control switch 5-34
B
Back up lights
Bulb capacity 7-36
Replacement 7-42
Ball joint, steering linkage seals and drive shaft boots 7-27
Battery
Disconnection and connection 7-16
During cold weather 7-15
Main drive lithium-ion battery 1-4
12V starter battery charging system warning light 3-74
Bluetooth
® 2.0 interface 3-91
Brake
Anti-lock braking system 3-41
Braking 4-8
Fluid 7-12,9-10
Hose 7-27
Parking brake 3-25
Parking brake lever stroke 7-25
Pedal 3-39
Pedal free play 7-25
Power brakes 3-39
Service brake 3-39
Warning light 3-73
Brake assist system 3-40
Break-in recommendations 3-2
Bulb capacity 7-36
BK0140800US.book 1 ページ ２０１１年９月２９日　木曜日　午後３時２８分