2012 MITSUBISHI iMiEV lock

1-48 General information/Charging
1
Charging Timer
N01203700010
The Charging Timer can be set as follows.

ON timer: Time from the present to when charging will
begin.

OFF timer: Time from the start of charging to the end of
charging
To set the timer, the following conditions must be met.

Selector lever: “P” (PARK) position

Electric motor switch: “LOCK”position

EV charging cable (regular charger): ConnectedNOTE
Charging Timer cannot be used with a quick charging sys-
tem. (if so equipped)
CAUTION
!
Never leave the MiEV Remote in place where it will
be subject to high temperatures, such as in direct
sunlight, or subject to extreme low temperatures.
The MiEV Remote can be damaged and may not
properly operate.
Never drop or hit the MiEV Remote. Do not apply
force to bend the antenna. These can cause damage
to or failure of the remote.
If the MiEV Remote gets wet, please wipe water off
immediately. Water entering the MiEV Remote can
cause a failure.
WA R N I N G
!
Improper charging can result in a fire, property
damage, and serious injury or death.
Before Charging Timer, carefully read and follow
the instructions in “Precaution on Charging the
Main Drive Lithium-ion Battery” on page 1-18 and
“Regular charging (charging method with rated AC
120 V outlet)” on page 1-20.
BK0140800US.book 48 ページ ２０１１年９月２９日　木曜日　午後３時２８分

1-58 General information/Charging
1
2. Press the manual charging switch (H), then press the
power/communication switch (B) for less than 1 sec-
ond.
NOTE
If the manual charging switch (H) is pressed, the
symbol of MiEV Remote will blink. Remote Climate
Control is also stopped.
3. Canceling Charging Timer is complete, and the MiEV
Remote will sound two different melodies.
4. Turn off the MiEV Remote. Refer to “To turn the
MiEV Remote ON/OFF” on page 1-50.B. By operating the electric motor switch on the vehicle
Turn the electric motor switch to the “ACC” or “ON”
position, then turn back to the “LOCK” position.
Canceling the Charging Timer is now complete.
BK0140800US.book 58 ページ ２０１１年９月２９日　木曜日　午後３時２８分

General information/Charging
1-59
1
Remote Climate Control
N01204200012
NOTE
The Remote Climate Control works regardless the posi-
tion of the air conditioning switch or dial on the vehicle.
While the Remote Climate Control is activated, the air
conditioning switch or dial on the vehicle will not affect
operation of the cooler, heater or defroster.

The Remote Climate Control will automatically stop 30
minutes after the Remote Climate Control has been set.

The Remote Climate Control is operated by electric power
supplied through the EV charging cable (regular charger).

Under the following conditions, the effect of the Remote
Climate Control can be decreased.
• When the outside temperature is very high.
• When the sunlight is strong.
• When the outside temperature is very low.

When Remote Climate Control is activated while charg-
ing the Main Drive Lithium-ion Battery, the time required
to fully charge the Main Drive Lithium-ion Battery will
become longer or the amount of charge may decrease if
the OFF timer has been set.

If the Main Drive Lithium-ion Battery Warming System
(if so equipped) is operated while the Remote Climate
Control is activated, the Remote Climate Control will
stop. When the Main Drive Lithium-ion Battery Warming
System stops, the Remote Climate Control will resume.
Refer to “Main Drive Lithium-ion Battery Warming Sys-
tem” on page 1-26.

While the Remote Climate Control is activated, if a heated
seat switch is ON, the heated seat will operate.
WA R N I N G
!
The Remote Climate Control, even when set, cannot
be relied upon to maintain safe vehicle cabin tem-
peratures while the vehicle is stopped or parked.
Never leave children or persons requiring supervi-
sion/nursing unattended inside the vehicle. Temper-
ature inside the vehicle could become extremely high
or low resulting in a risk of heat stroke or hyper-
thermia that could result in death.
In addition, children can activate switches and con-
trols, resulting in an injury or fatal accident.
While the Remote Climate Control is activated, keep
away from the cooling fan under the front hood,
since the cooling fan may automatically operate
even if the electric motor switch is in the “LOCK”
position.
BK0140800US.book 59 ページ ２０１１年９月２９日　木曜日　午後３時２８分

1-60 General information/Charging
1
To operate the Remote Climate Control
N01204300013
The following conditions must be met to operate the Remote
Climate Control.

Selector lever: P (PARK) position.

Electric motor switch: LOCK position.

EV charging cable (regular charger): Connected.

Quick charging: Not used (if so equipped).

Main Drive Lithium-ion Battery Level Indicator: Shows
one bar or more. Refer to “Main Drive Lithium-ion Bat-
tery Level Indicator” on page 1-63.

All doors and the liftgate: Closed.
1. Start charging. Refer to “Regular charging (charging
method with rated AC 120 V outlet)” on page 1-20.
2. Turn on the MiEV Remote. Refer to “To turn the MiEV
Remote ON/OFF” on page 1-50.3. Press the MODE switch (E) to change the mode to
Remote Climate Control (3).
WA R N I N G
!
Improper charging can result in a fire, property
damage, and serious injury or death.
Carefully read and follow instructions in “Precau-
tion on Charging the Main Drive Lithium-ion Bat-
tery” on page 1-18 and “Regular charging (charging
method with rated AC 120 V outlet)” on page 1-20.
1_ Shown the ON timer
2_ Shown the OFF timer
3_ Shown the Remote Climate Control
BK0140800US.book 60 ページ ２０１１年９月２９日　木曜日　午後３時２８分

General information/Charging
1-67
1
Actions to be taken when the MiEV Remote system does not operate correctly
N01204900019
Take the following actions when the system does not operate correctly. If the system still does not operate correctly after the
action(s) have been taken, a system component may not be working properly. Please consult with a certified i-MiEV dealer to check
it.
Phenomena
Cause
Remedy
Charging does not start when regular charge
connector is inserted.“ON” timer has been set. Cancel the “ON” timer.
The regular charge connector is not
locked completely.Lock the regular charge connector securely.
A household electrical outlet, which the
EV charging cable is connected to, is
shut down.(e.g. disconnected plug)Turn on the household electrical outlet and make
sure the plug is securely connected.
MiEV Remote
does not operate
normally.MiEV Remote is not
powered on.Batteries in the MiEV Remote are
defective or the batteries are discharged.Replace the batteries in the MiEV Remote.
Refer to “Replacement of batteries for the MiEV
Remote” on page 1-65.
No indicator lights
come on when the
remote is turned on.
Melody or buzzer does
not sound.Melody or buzzer has been disabled. Enable the melody or buzzer.
Refer to “To turn on/off melody and buzzer” on
page 1-63.
BK0140800US.book 67 ページ ２０１１年９月２９日　木曜日　午後３時２８分

1-68 General information/Charging
1
The following
symbol blinks
when the power
supply/communi-
cation switch on
the MiEV Remote
is pressed.

ERROR
symbol

symbolBlinks after about 1
second.
Electrical noise source is present in
the vicinity of the MiEV Remote.
(e.g. personal computer)

Electrical noise source is present
between the vehicle and the MiEV
Remote.Move away from the noise source.
Blinks after about 10
seconds.The MiEV Remote antenna is not
extended.Extend the MiEV Remote antenna to communi-
cate.
Out of effective communication range.
(e.g. too far away from the vehicle, or
radio signal is interfered)Move to the location where the system reaches
the effective communication range.
The electric motor switch is at the posi-
tion other than “LOCK” position.Turn the electric motor switch to the “LOCK”
position.

Electrical noise source is present in
the vicinity of the vehicle.

Electrical noise source is present
between the vehicle and the MiEV
Remote.Move away from the noise source.
12V starter battery is discharged. Charge or replace the 12V starter battery.
Refer to “Jump-starting” on page 6-2, “12V
starter battery” on page 9-8.
The below symbol blinks about 10 seconds
after the power/communication switch on
the MiEV Remote is pressed.

ERROR symbolSome errors occur while the system is in
processing.Press the power/communication switch again.
Phenomena
Cause
Remedy
BK0140800US.book 68 ページ ２０１１年９月２９日　木曜日　午後３時２８分

General information/Charging
1-69
1
Charging Timer is
not possible.After the power/com-
munication switch is
pressed, the following
symbol blinks in sev-
eral seconds.

ERROR symbol

symbolRegular charge connector is not inserted
or not locked completely.Lock the regular charge connector securely.
A household electrical outlet, which the
EV charging cable (regular charger) is
connected to, is shut down.(e.g. discon-
nected plug)Turn on the household electrical outlet which the
EV charging cable (regular charger) is connected
to.
Ground fault at the household electrical
outlet. Otherwise, the power supply at
the household electrical outlet is cut off.Check the ground fault and confirm the plug is
connected.
If the charging unit is equipped with the
timer function, the power supply to the
unit has been cut off.Preset the Charging Timer while the charging
unit with timer function is powered on.
After the power/com-
munication switch is
pressed, the following
symbol blinks in sev-
eral seconds.

ERROR symbolThe selector lever is at a position other
than P (PARK).Place the selector lever to P (PARK) position.
Quick charging is in progress. (if so
equipped) (The symbol illumi-
nates.)Terminate the quick charging, or wait until the
quick charging completes.
The temperature of the Main Drive Lith-
ium-ion Battery has exceeded about
140 °F (60 °C).Allow the temperature of the Main Drive Lith-
ium-ion Battery to reach normal operating tem-
perature. Refer to “Cautions and action to deal
with intense heat” on page 1-10.
The temperature of the Main Drive Lith-
ium-ion Battery has been under about -
13 °F (-25 °C).(except vehicles with
Main Drive Lithium-ion Battery Warm-
ing System)Allow the temperature of the Main Drive Lith-
ium-ion Battery to reach normal operating tem-
perature. Refer to “Cautions and action to deal
with intense cold” on page 1-12.
Phenomena
Cause
Remedy
BK0140800US.book 69 ページ ２０１１年９月２９日　木曜日　午後３時２８分

General information/Charging
1-71
1
Timed charging is
impossible.It is not fully charged. If the charging unit is equipped with the
timer function, the power supply to the
unit has been cut off.Preset the Charging Timer while the charging
unit with timer function is powered on.
The Remote Cli-
mate Control can-
not be activated.After the power/com-
munication switch is
pressed, the following
symbol blinks in sev-
eral seconds.

ERROR symbol

symbolThe regular charge connector is not
inserted or it is not locked completely.Lock the regular charge connector securely.
A household electrical outlet, which the
EV charging cable (regular charge) is
connected to, is shut down.(e.g. discon-
nected plug)Turn on the household electrical outlet which the
EV charging cable (regular charge) is connected
to.
Ground fault at the household electrical
outlet. Otherwise, the power supply at
the household electrical outlet is cut off.Check the ground fault and confirm the plug is
connected.
If the charging unit is equipped with the
timer function, the power supply to the
unit has been cut off.Preset the Charging Timer while the charging
unit with timer function is powered on.
After the power/com-
munication switch is
pressed, the following
symbol blinks in sev-
eral seconds.

ERROR symbol

symbolThe Main Drive Lithium-ion Battery
charging level is low.Charge the Main Drive Lithium-ion Battery until
the MiEV Remote illuminates the battery charg-
ing level by at least 1 segment.
Phenomena
Cause
Remedy
BK0140800US.book 71 ページ ２０１１年９月２９日　木曜日　午後３時２８分