2012 MITSUBISHI iMiEV audio

Features and controls
3-93
3
Volume up buttonPress this button to increase the volume. Volume down buttonPress this button to decrease the volume.SPEECH button
Press this button to change to voice recognition mode.
While the system is in voice recognition mode, “Listen-
ing” will appear on the audio display.

If you press the button briefly while in voice recognition
mode, it will interrupt prompting and allow voice com-
mand input.
Pressing the button longer will deactivate the voice recog-
nition mode.

Pressing this button briefly during a call will enable voice
recognition and allow voice command input.PICK-UP button
Press this button when an incoming call is received to
answer the telephone.

When another call is received during a call, press this but-
ton to put the first caller on hold and talk to the new caller.
• In such circumstances, you can press the button briefly
to switch between callers. You will switch to the first
caller and the other caller will be put on hold.
• To establish a three-way call in such situations, press the
SPEECH button to enter voice recognition mode and
then say “Join calls.”
HANG-UP button
Press this button when an incoming call is received to
refuse the call.

Press this button during a call to end the current call.
When another call is on hold, you will switch to that call.

If this button is pressed in the voice recognition mode, the
voice recognition mode will be deactivated.NOTE
When you press the SPEECH button to enter voice recog-
nition mode with a cellular phone paired to the system,
current information on the cellular phone, such as
“remaining battery life,” “signal strength” or “roaming,”
will be displayed on the audio display.*
*: Some cellular phones will not send this information to
the Bluetooth
® 2.0 interface.

Call waiting and three-way calls can be used by the
Bluetooth
® 2.0 interface, only if it is possible to use those
services with your cellular phone.
BK0140800US.book 93 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-106 Features and controls
3
6. The voice guide will say “Calling ”
and then the system will dial the telephone number.NOTE
When the confirmation function is on, the system will
check if the name and location of the receiver are correct.
If the name is correct, answer “Yes.”
To change the name or location to call, answer “No.” The
system will return to Step 3.
Redialing
You can redial the last number called, based on the history of
dialed calls in the paired cellular phone.
Use the following procedure to redial.
1. Press the SPEECH button.
2. Say “Redial.”Send function
N00565700018
During a call, press the SPEECH button to enter voice recogni-
tion mode, then say “ SEND” to generate DTMF
tones.
For example, if during a call you need to simulate the pressing
of a phone button as a response to an automated system, press
the SPEECH button and speak “1 2 3 4 pound send” and the
1234# will be sent via your cellular phone.
Receiving calls
N00565800022
If an incoming phone call is received while the electric motor
switch is in the “ACC” or “ON” position, the audio system will
be automatically turned on and switched to the incoming call,
even when the audio system was originally off.
The voice guide announcement for the incoming call will be
output from the front passenger’s seat speaker.
If the CD player or radio was playing when the incoming call
was received, the audio system will mute the sound from the
CD player or radio and output only the incoming call.
To receive the call, press the PICK-UP button on the steering
wheel control switch.
When the call is over, the audio system will return to its previ-
ous state.
BK0140800US.book 106 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-120 Features and controls
3
4. Connect the Dock connector (C) to the USB input termi-
nal (D).
5. To remove the Dock connector, turn the electric motor
switch to the “LOCK” position first and perform the
installation steps in reverse.
Types of connectable devices and supported file
specifications
N00567000031
Device types
N00567100074
Devices of the following types can be connected.
*: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are
registered trademarks of Apple Inc. in the United States and
other countries.
WA R N I N G
!
Place the iPod and the USB connector cable so as
not to interfere with driving.
Model name
Condition
USB memory deviceStorage capacity of 256 Mbytes
or more
iPod touch* F/W Ver.1.1.1 or later
iPod classic* F/W Ver.1.0 or later
iPod (fifth generation)* F/W Ver.1.2.2 or later
iPod nano (fifth generation)* F/W Ver.1.2 or later
iPod nano (second generation)* F/W Ver.1.1.2 or later
Models other than USB mem-
ory devices and iPodsDigital audio player supporting
mass storage class
BK0140800US.book 120 ページ ２０１１年９月２９日　木曜日　午後３時２８分

5
Comfort controls
Vents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 2
Air conditioning . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 6
Important air conditioning operating tips . . . . . . .5- 17
Air purifier . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 18
Remote Climate Control (if so equipped) . . . . . . .5- 18
AM/FM electronically tuned radio with
CD player (if so equipped) . . . . . . . . . . . . . . . . .5- 18
To play iPod/USB memory device tracks via
voice operation (vehicles with Bluetooth
® 2.0
interface) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 30
Steering wheel audio remote control switch
(if so equipped) . . . . . . . . . . . . . . . . . . . . . . . . . .5- 34
Error codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 37
Handling of compact discs . . . . . . . . . . . . . . . . . . .5- 38
Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 40
Clock (if so equipped) . . . . . . . . . . . . . . . . . . . . . .5- 41
General information about your radio . . . . . . . . . .5- 42
BK0140800US.book 1 ページ ２０１１年９月２９日　木曜日　午後３時２８分

5-18 Comfort controls
5Air purifier
N00733800177
The air conditioning system is equipped with an air filter to
reduce pollen and dust entering the cabin.
The air filter’s ability to collect pollen and dust will be reduced
as it becomes dirty, so replace it periodically. For the mainte-
nance interval, refer to the “WARRANTY AND MAINTE-
NANCE MANUAL”.NOTE
Operation in certain conditions such as driving on a dusty
road or frequent use of the air conditioning can reduce the
service life of the filter. When you feel that the air flow is
lower than normal or when the windshield or windows
start to fog up easily, replace the air filter.
Contact a certified i-MiEV dealer for assistance.
Remote Climate Control
(if so equipped)
N00766600016
You can run the air conditioning in advance of using the vehi-
cle. For details, refer to “Remote Climate Control” on page 1-
59.
AM/FM electronically tuned radio with CD
player
(if so equipped)
N00734301062
The audio system can only be used when the electric motor
switch is in the “ON” or “ACC” position.NOTE
To listen to the audio system while the electric motor unit
is not running, turn the electric motor switch to the
“ACC” position.
If the electric motor switch is in the “ACC” position, the
accessory power will automatically turn off after a certain
period of time and you will no longer be able to use the
audio system. The accessory power comes on again if the
electric motor switch is turned from the “ACC” position.
Refer to “ACC power auto-cutout function” on page 3-30.

If a cellular phone is used inside the vehicle, it may create
noise in the audio equipment. This does not mean that
anything is wrong with your audio equipment. In such a
case, use the cellular phone at a place as far away as possi-
ble from the audio equipment.

If foreign objects or water get into the audio equipment, or
if smoke or a strange odor comes from it, immediately
turn off the audio system and have it checked at a certified
i-MiEV dealer. Never try to repair it yourself. Avoid using
the audio system until it is inspected by a qualified person.

If the audio system is damaged by foreign objects, water,
or fire, have the system checked at a certified i-MiEV
dealer.
BK0140800US.book 18 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Comfort controls
5-19
5
Volume and tone control panel
N00711900716
To adjust the volume
N00712000408
Turn the VOLUME knob clockwise to increase the volume;
counterclockwise to decrease the volume.
The status will be displayed in the display.NOTE
The volume control mode will shut off automatically if
the another mode is selected, or if no adjustment is made
within about 2 seconds.
1- VOLUME (Volume control) knob
2- SEEK (Audio adjust) button
3- Display
4- POWER (On-Off) button
5- (Mode change) button
BK0140800US.book 19 ページ ２０１１年９月２９日　木曜日　午後３時２８分

5-20 Comfort controls
5
To adjust the tone
N00712100669
1. Press the button repeatedly to select the tone, balance
and SCV (Speed Compensated Volume) function control
to change. The order is: BASS → TREBLE → FADER →
BALANCE → SCV → Audio adjust mode OFF
2. Press the SEEK button to change the tone, balance and
SCV function setting.
The status will be displayed in the display.
BASS (Bass tone control)To select the desired bass level.TREBLE (Treble tone control)To select the desired treble level.FADER (Front/Rear balance control) (if equipped with
rear speakers)To balance the volume from the F (front) and the R (rear)
speakers.BALANCE (Left/Right balance control)To balance the volume from the L (left) and the R (right)
speakers.
A- Adjust mode
B- Adjust level
Adjust
Mode
Adjust
Level
SEEK button operation
BASS
-6 to 6Stronger Weaker
TREBLE Stronger Weaker
FA D E R F 11 t o R 11F (Front)
increasesR (Rear)
increases
BALANCE L11 to R11R (Right)
increasesL (Left)
increases
SCVHIGH, MID,
LOW, OFFHIGH
↑
MID
↑
LOW
↑
OFFHIGH
↓
MID
↓
LOW
↓
OFF
BK0140800US.book 20 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Comfort controls
5-21
5
NOTE
In a four-speaker vehicle, keep the FADER setting in the
middle position. Since no rear speakers are connected,
adjusting the FADER setting toward the “R” side will
result in a loss of sound output.SCV (Speed Compensated Volume) functionSpeed Compensated Volume function is a feature that automat-
ically adjusts the VOLUME, BASS and TREBLE settings in
accordance with the vehicle speed.
The effects of the SCV function can be selected either of three
levels (LOW, MID and HIGH). Select the degree of your
choice by pressing the SEEK button.
If you want to stop the SCV function, select the OFF.NOTE
The audio adjust mode will automatically shut off when
another mode is selected, or if no adjustment is made
within about 10 seconds.
Radio control panel and display
N00734900902
1- FM (FM1/FM2) indicator
2- RADIO (AM/FM selection) button
3- MEMORY (Memory selection) button
4- POWER (On-Off) button
5- SCAN button
6- SEEK (Up-seek) button
7- SEEK (Down-seek) button
BK0140800US.book 21 ページ ２０１１年９月２９日　木曜日　午後３時２８分