Symbols
Registered trademarks:
R BabySmart™ is a registered trademark of
the Siemens Automotive Corp.
R Bluetooth ®
is a registered trademark of the
Bluetooth SIG Inc.
R DTS is a registered trademark of DTS, Inc.
R Dolby and MLP are registered trademarks
of Dolby Laboratories.
R ESP ®
and PRE-SAFE ®
are registered
trademarks of Daimler AG.
R HomeLink ®
is a registered trademark of
Prince, a Johnson Controls Company.
R iPod ®
and iTunes ®
are registered
trademarks of Apple Inc., registered in the
USA and in other countries.
R Logic 7 ®
is a registered trademark of
Harman International Industries,
Incorporated.
R Microsoft ®
is a registered trademark of the
Microsoft Corporation in the USA and in
other countries.
R SIRIUS and associated brands are
registered trademarks of SIRIUS XM Radio
Inc.
R HD Radio and associated brands are
registered trademarks of the iBiquity
Digital Corporation.
R Windows Media ®
is a registered trademark
of the Microsoft Corporation in the USA and
in other countries.
R Gracenote ®
is a registered trademark of
Gracenote, Inc.
R ZagatSurvey ®
and associated brands are
registered trademarks of Zagat.
In this Operator's Manual, you will find the
following symbols:GWARNING
Warning notes draw your attention to hazards
that endanger your health or life, or the health
or life of others.
! These warning notes draw your attention
to hazards that could cause damage to your
vehicle.
i This symbol indicates useful instructions
or further information that could be helpful
to you.XThis symbol designates an
instruction you must follow.XSeveral consecutive symbols
indicate an instruction with several
steps.Y PageThis symbol tells you where you
can find further information on a
topic.YYThis symbol indicates a warning or
an instruction that is continued on
the next page.DisplayThis font indicates a display
message in the multifunction
display/COMAND display.
Parts of the software in the vehicle are
subject to copyright according to ©
2005
The FreeType Project
http://www.freetype.org. All rights
reserved.
X
Turn theSmart Keytoposition 2in the
ignition lock.
X Press theprogramming buttonofthe door
or gate drive (seethedoor orgate drive
operating instructions ,e.g. under
"Programming ofadditional remote
cont rols"). i
You
now normally have30seconds to
initiate thenext step.
X Press thepreviously programmed
tran smitt erbutton ofthe HomeLin k®
integr atedgarage dooropener repeatedly
in succession untilthedoor opens.
The rolling codesynchron izationisthen
complete.
Notes onprogr ammingthe remot e
control
Canadian radiofrequency lawsrequire a
"break" (orinter ruption) ofthe tran smission
signals afterbroadcasting forafew seconds .
These signals maynottheref orelast long
enough forthe integr atedgarage dooropener
to recogn izethe signal during programming.
Comparable withCanadian law,some U.S.
garage dooropeners alsohave abuilt-in
"interr uption".
If you liveinCanada orhave difficulties
programming thegarage dooropener
(regardless ofwhere youlive) when usingthe
programming steps(seeabove), proceed as
follows:
X Press andhold oneoftran smitt er
button s; to? ofthe integr atedgarage
door opener.
Indicat orlamp :start sto flash yellow
after ashort period.
X Release thetran smitt erbutton .
X Press transmitt erbutton Bofthe garage
door remote controland hold fortwo
seconds, thenrelease fortwo seconds,
then press againandhold fortwo seconds. X
Repeat thissequence ontran smitt er
button Bofthe garage doorremot e
cont roluntil indicator lamp:isgreen.
Repeat theprocess ifindicator lamp:
turns red.
X Contin uewith theother programming
steps (seeabove).
Problems whenprogramming
If you areexperienc ingproblems
programming theintegr atedgarage door
opener onthe rear-view mirror,takenoteof
the following instructions :
R check thetran smission frequency of
garage doorremot econt rolA (usual ly
found onthe reverse sideofthe remot e
cont rol).
The integr atedgarage dooropener is
compatible withdevices thatcanbe
operated withunits inafrequency rangeof
280 to390 MHz.
R change thebatteries ingarage doorremot e
cont rolA.T hisincreases theprobabil ity
that garage doorremote controlA will
send astron gand precise signaltothe
integrated garagedooropener onthe rear-
view mirror.
R when programming, holdgarage door
remote controlA atdifferent distances
and angles fromthetransmit terbutton that
you areprogramming. Trydifferent angles
at adistance between 2and 12inches (5
to 30 cm) orthe same angle atvarying
distances.
R ifanother remotecontrolfor the same
garage doordrive isavaila ble,repeat the
same programming stepswiththisremote
cont rol.Before youperform thesteps ofthe
operation, makesurethatthere arenew
batteries inthe garage doorremote
cont rol.
R note thatsome remote controlsonly
transmit foralimited amount oftime (the
indicator lamponthe remote controlgoes Features
307Stowing and features Z
