2012 MERCEDES-BENZ GL SUV oil capacities

data applicable to your vehicle on the vehi-
cle' sidentification plate. VIN
X
Open the fron tright-han ddoor.
X Open cover :in the dire ction of the arrow
and remove it.
The VI Ncan be seen.
The VIN can also be foun donthe vehi cle
identification plate (Y page 422).Engine number
The engin enumber is stamped ont othe
crankcase .You can obtain further informa-
tion fr om any qualified specialist workshop. Service products and capacities
Important safety notes
G
WARNING
Whe nhandling ,storing and disposing of any
servic eproducts, please observe the relevant
regulations, as you could othe rwise endanger
yourself and others.
Keep servic eproducts awa yfromc hildren.
To protec tyour health, do no tallow service
products to com eintoc ontac twith your eyes
or open wounds. See adoctor immediately if
any servic eproduct is swallowed. H
Environmental note
Dispose of service products in an environ-
mentally-responsible manner.
Service products includ ethe following:
R fuels (e.g. petrol, diesel)
R exhaust gas after treatmen tadditives, e.g.
AdBlue ®
R lubrican ts(e.g. engin eoil, transmission oil)
R coolant
R brake fluid
R windscreen washer fluid
R clima te control systemrefrigerant
Components and servic eproducts mus tbe
matched. Mercedes-Benz reco mmends that
you use produc tstested and approved by
Mercedes-Benz. They are listed in this
Mercedes-Benz Owne r'sM anual in the appro-
priat esection.
You can identif yservice product sapproved
by Mercedes-Ben zbythe fol lowinginscrip-
tion sonthe container:
R MB Freigab e(e.g. MB Freigab e229.51)
R MB Approva l(e.g. MB Approval 229.51)
Other designation sorrecommendation sind i-
cat eal evel of qualit yora specification in
ac cord ance wit hanMBS heet Nu mber (e.g.
MB 229.5). They hav enot necessarily been
approved by Mercedes-Benz.
Further informatio ncan be obtained from any
Mercedes -Ben zS ervice Cent reor on the
In te rnet at ht tp://bevo.mercedes -benz.co m. Fuel
Important safety notes G
WARNING
Fuel is highly flammable. If you handle fuel
incorrectly, there is arisk of fir eand explo-
sio n.
You must avoi dfire, naked flames, creating
sparks and smoking. Switc hoff the engine Servic
eproducts and capacities
423Technical data
Z

Diesel (EN 590)
Fuel grade
G
WARNING
If you mix diesel fue lwithp etrol, th eflash
poin toft his fuel mixtur eislower than that of
pur ediesel fuel. When the engine is running,
components in the exhaust system may over-
heat unnoticed. There is arisk of fire.
Never refuel with petrol. Never add petrol to
diesel fuel.
! When refuelling, only use diesel fuel that
conforms to the European standard EN 590
or is of equivalen tquality .Fuel that does
not con form to EN 59 0can lead to
increased wear as well as damag etothe
engin eand exhaust sys tem.
! Do not use the following:
R marine diesel
R heating oil
R bio-diesel
R vegetable oil
R petrol
R paraffin
R kerosene
Do not mix such fuels with diesel fuel and
do not use any special additives. This can
otherwis elead to engine damage .This
does not include flo wimprover additives.
For further information, se e"Flow improv-
ers".
! Vehicles with adiesel particle filter: in
countries outside the EU, only refuel with
low-sulphur Eur odiesel with asulphur con-
ten tunde r50p pm; otherwise the emission
contro lsystem could be damaged.
! Vehicles without adiesel particle fil-
ter: in countries where only diesel fuel with
ah igh sulphur conten tisavailable ,you will
need to carry out your vehicle' soil change
at shorter intervals. More information
abou tthe interval for oil change can be obtained from any qualified specialist
workshop.
Usually you will fin dinformation about the
fuel grade on the pump. If you cannot find the
labe lont he petrol pump, ask the filling sta-
tion staff.
Infor mation on refuelling (Y page 175).
Low outside temperatures
In winter months, diesel fuel with an improved
cold flow quality is available. In Europe, the
EN 590 standard defines various climate-
dependent temperature categories. Malfunc-
tions can be avoide dbyrefuelling with diesel
fuel that corresponds to the climatic specifi-
cations outlined in EN 590. At unusually low
outside temperatures, it is possible that the
flow characteristics of the diesel fuel could be
insufficient .Accordingly, dies elfue lfrom
warmer areas may not be suitabl efor opera-
tion in colder climat icconditions.
i Further informatio noncountry-specific
fuel properties can be obtained from oil
companies, e.g. at filling stations.
Flow imp rovers
To improve the low-temperatur eresistanc eof
diesel fuel, aflow improver can be attached.
The effec tiveness of aflow improver is not
guaranteed for every fuel.
Only use flow improvers tested and approved
by Mercedes-Benz. Durin guse, please
observe the information on operation.
Correc tdosage and sufficien tmixing are deci-
sive in improving low-temperature resistance
with the flow improver. Overdosage can
potentially even decrease low-temperature
resistanc eand must therefor ebeavoided.
Follo wthe manufacturer's guidelines on dos-
age.
Mix the additive int othe diesel in good time,
before the flo wcharacteristic softhe diesel
becom einsufficie nt.O therwise, malfunctions
can only be rectified by heating the entire fuel
system, e.g. by parking in aheated garage. 426
Service products and capacitiesTechnical data

R
engin edamage
R malfunc tions in the BlueTEC ®
exhaust
gas aftertreatmen tsystem
Assuring the purity of AdBlue ®
is particularly
importan twithr espec ttoavoiding malfunc-
tions in th eBlueTEC exhaust gas aftertreat-
ment system.
If AdBlue ®
is pumped out of the AdBlue ®
tank,
e.g. during repair work, do not use this fluid
to refill the tank. The purity of the fluid can no
longer be guaranteed.
Capacities Model Tota
lcapacity GL 35
0Blue-
TEC 4MATIC 31.2 l
Engine oil
General notes The quality of the engine oil is decisive for the
function and servic
elife of an engine. After
extensive tests, Mercedes-Benz approves
engine oil sthat correspond to the current
technical standard.
Therefore, only Mercedes-Benz approved
engin eoilsm ay be use dinMercedes-Benz
engines.
Further information on tested and approved
engine oils can be obtained from any
Mercedes-Ben zService Centre. Mercedes-
Benz recommends that you have the oil
change carried out at aqualified specialist
workshop. Mercedes-Benz approval is indica-
ted on the oil container by the inscription "MB
Approval" and the corresponding designa-
tion, e.g. MB Approva l229.51.
Yo uc an call up an overview of approved
engine oil sonthe Internet at:
http://bevo.mercedes-benz.com by enter-
ing the designation ,e.g. 229.5.
Th et able sho wswhich engine oil shave been
approved for you rvehicle. Petrol engines MB App
roval GL 500 4MATIC Blue-
EFFICIENCY
GL 63 AMG
22
9.5 Diesel engines with a
diesel particle filter MB Approval
GL 350 Blue-
TEC 4MATIC
GL 350 CDI 4MATIC
228.51,
229.31 ,229.51 Diese
lengines without
ad iesel particle filter MB Approval
GL 350 CDI 4MATIC
22
8.31 ,228.5,
228.51, 229.3,
229.31, 229.5, 229.51 Use onl
ySAE 0W-40 or SAE 5W-40 engine oils
for AM Gvehicles.
i If the engine oils listed in the table are not
available, you may add the followi ngengine
oils until the nex toil change:
R vehicles with apetrol engine: MB
Approval 22 9.12 29.3 or ACEA A3
R diesel engines: MB Approva l229.1,
229.3, 229.5 or ACEA C3
Use onl ySAE 0W -40o rSAE 5W -40e ngine
oil sf or AMG vehicles.
This ma yonly be topped up once, and the
quantity must not be greate rthan 1. 0l.
Ca pacities Th
ef ollowing va luesrefertoano il change
including the oil filter. 428
Service products and capacitiesTechnica
ldata

Model Replacement
amount GL 50
04MATIC
Blue EFFICIEN CY 8.5 l
GL 63 AMG
With external oil
cooler: 9.5 l GL 350 Blue-
TEC 4MATIC
GL 350 CDI
4MATIC
8.0 l
Additives
!
Do not use any additives with the engine
oil .T his could damage the engine.
Engine oil viscosity Viscosit
ydescribes the flow characteristics
of afluid. If an engine oil has ahigh viscosity
rating, it flows slowly ;the lower the viscosity,
the faster it flows.
Engin eoil selection is based on the respective
outside temperatures and in accordance with
the SAE classification (viscosity). The table
shows you which SAE classifications are to be
used. The low-temperature properties of
engine oils can be significantly impaired dur-
ing operation due to, for example, ageing or
soot and fuel accretion .Itistherefore
strongly recommended to observe regular oil
changes usin ganapproved engine oil with the
appropriate SAE classification. Brake fluid
G
WARNING
Over aperiod of time, the brak efluid absorbs
moisture from the air; This lowers its boiling
point.
If the boiling point of the brake fluid is too low,
vapour pocket smay form in the brake system
when the brakes are applied hard (e.g. when
driving downhill). This impairs braking effi-
ciency.
You shoul dhave the brake fluid renewed at
regular intervals. The brake fluid change inter-
vals can be found in the Service Booklet.
Only use brake fluid approved by Mercedes-
Benz according to MB Approval 331.0.
Information about approved brake fluid can
be obtained at any qualified specialist work-
sho poront he Internet at
http://bevo. mercedes-benz.com.
i Have th ebrake flui drenewed regularly at
aq ualified specialist workshop. Coolant
Important safety notes G
WARNING
Antifreeze is highly flammable. Fire, naked
flames and smoking are prohibited when han-
dling antifreeze.
If antifreeze comes into contact with hot
engine parts, it may ignite and you could burn
yourself. Do not spill any antifreeze on hot
engine parts.
! Only add coolant that has been premixed
with the desired antifreez eprotection. You
cou ld othe rwise damage th eengine.
Further information on cool ants can be
found in the Merced es-Benz Specifications
for Service Prod ucts, MB Specifications for
Service Products 310.1 ,e.g. on the Inter-
net at http://bevo.mercedes-benz.co m.
Or contac taqualified specialist workshop. Servic
eproducts and capacities
429Technical data Z

!
Alway suseasuitabl ecoolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the engin ecooling system is not
sufficiently protected from corrosion and
overheating.
! The engin ecooling system is filled with
coolant, which must be renewed after
15 years or after 250,000 kilometres at the
latest.
The coolant is amixtur eofw ater and anti-
freeze/corrosio ninhibitor. It performs the
following tasks:
R anti-corrosio nprotection
R antifreeze protection
R raising th eboiling point
If antifreeze/ corrosion inhibitor is presen tin
the correct concentration, the boil ingp oint of
the coolant during operation will be approx-
imately 13 0†.
The antifreeze/ corrosion inhibitor concentra-
tion in the engin ecooling system should:
R be at least 50%. This will protect the engine
coolin gsystem against freezing down to
approximatel y-37 †.
R not exceed 55% (antifreeze protection
down to -45 †). Hea twill otherwise not be
dissipated as effectively.
If the vehicle has lost coolant, top it up with
equa lamounts of water and antifreeze/cor-
rosio ninhibitor. Mercedes-Benz recom-
mends an antifreeze/corrosion inhibito rcon-
cen trate in accordance with MB Specifica-
tions for Service Products 310.1.
The coolant is checked at every maintenance
interval at aqualified special istworkshop.
i When the vehicle is first delivered ,itisfil-
led with acoolant mixtur ethat ensures
adequate antifreeze and corrosion protec-
tion. Windscreen washe
rsystem an dhead-
lamp cleaning system
Important safety notes G
WARNING
Windscreen washer concentrat eishighly
flammable. If it comes into contact with hot
engine component sorthe exhaust system it
coul dignite. There is arisk of fire and injury.
Make sure that no windscreen washer con-
centrate is spille dnext to the filler neck.
! Only use washer fluid that is suitable for
plastic lamp lenses, e.g. MB SummerFit or
MB WinterFit. Unsuitable washer fluid
could damage the plastic lenses of the
headlamps.
! Do not use distilled or de-ionised water in
the washer fluid reservoir. Otherwise, the
level sensor may be damaged.
! Only the washer fluids SummerFit and
WinterFit can be mixed. Otherwise, the
spraying nozzles could become blocked.
At temperatures above freezing:
X Fill the washer fluid reservoir with amixture
of water and washer fluid, e.g. MB Sum-
merFit.
Mix 1part MB SummerFit to 100 parts water.
At temperatures below freezing:
X Fill the washe rfluid reservoir with amixture
of water and washer fluid, e.g. MB Winter-
Fit.
Adapt the mixin gratio to the outside temper-
ature.
R Down to Ò10 †: mix 1part MB WinterFit to
2p arts water.
R Down to Ò20 †: mix 1part MB WinterFit to
1p art water.
R Down to Ò29 †: mix 2parts MB WinterFit
to 1p art water.
i Add washe rfluid concentrate, e.g. MB
SummerFit or MB WinterFit, to the washer
fluid all year round. 430
Service products and capacitiesTechnical data