2012 MERCEDES-BENZ G-Class technical data

You should have the brake fluid renewed at
regular intervals. The brake fluid change
intervals can be found in the Maintenance
Booklet.
Only use brake fluid approved by Mercedes-
Benz. Information about approved brake
fluids can be obtained from any authorized
Mercedes-Benz Center. Coolant
Important safety notes The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
R
anti-corrosion protection
R antifreeze protection
R raising the boiling point
The engine cooling system is filled at the
factory with coolant which contains an
antifreeze/corrosion inhibitor that ensures
protection down to approximately -35 ‡
(-37 † ).
! Only add
coolant that has been premixed
with the desired antifreeze protection.
Otherwise, the engine could be damaged.
Further information on coolants and on
filling can be found in the Mercedes-Benz
Specifications for Service Products, MB
Approval 310.1, e.g. on the Internet at
http://bevo.mercedes-benz.com. You can
also consult an authorized Mercedes-Benz
Center.
! Always use a suitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the engine cooling system is not
sufficiently protected from corrosion and
the boiling point will be too low.
If the coolant has antifreeze protection down
to -35 ‡ (-37 † ), the boiling point of the
coolant in the pressurized system is
approximately 266 ‡ (130 † ). Your vehicle has a range of aluminum
components. Aluminum components in the
engine make it necessary to use
anticorrosion/antifreeze coolant which has
been specifically formulated to protect the
aluminum parts. Using other antifreeze/
corrosion inhibitors without these
characteristics affects the service life.
The
coolant

must be used throughout the year
in order to maintain the necessary corrosion
protection and provide protection from
overheating. In the Maintenance Booklet, you
can find information on the intervals for
renewal.
The renewal interval is determined by the
coolant type and the engine cooling system
design. The renewal interval in the
Maintenance Booklet is only valid if the
coolant is renewed or replenished with
Mercedes-Benz approved products.
Therefore, only use MB 326.0 antifreeze/
corrosion inhibitor or another Mercedes-Benz
approved product of the same specification.
Information on other products with the same
specifications that are approved by
Mercedes-Benz can be obtained at an
authorized Mercedes-Benz Center or on the
Internet at
http://bevo.mercedes-benz.com.
The coolant is checked at every maintenance
interval at an authorized Mercedes-Benz
Center.
The antifreeze/corrosion inhibitor
concentration in the engine cooling system
should:
R be at least 50%. This will protect the engine
cooling system against freezing down to
approximately -35 ‡ (-37 † ).
R not exceed 55% (antifreeze protection to
-49 ‡ [-45 † ]); otherwise, heat will not
dissipate as effectively.
If the coolant level is too low, MB 325.0
antifreeze/corrosion inhibitor should be
added. Have the engine cooling system
checked for possible leaks. 276
Service products and capacities
Technical data

Cooling system
Vehicle
model Antifreeze protection
Approx.
-35 ‡
(-37 †) Approx.
-49 ‡
(-45 †)
G 550 6.4 US qt
(6.05 l) 7.1 US qt
(6.7 l)
G 55 AMG 6.7 US qt
(6.35 l) 7.4 US qt
(7.0 l)
Windshield/headlamp cleaning
system
G
WARNING
Washer solvent/antifreeze is highly
flammable. Do not spill washer solvent/
antifreeze on
hot engine parts, because it may
ignite and burn. You could be seriously
burned.
X Use windshield washer concentrate MB
SummerFit.
X At temperatures above freezing: add 1
part MB

SummerFit to 100 parts water, e.g.
1.34 fl oz (40 ml) MB SummerFit to 1 gal
(4.0 l) of water.
X At temperatures below freezing: add 1
part MB SummerFit to 100 parts washer
fluid, e.g.

1.34 fl oz (40 ml) MB SummerFit
to 1 gal (4.0 l) of water. Vehicle data
Vehicle data, G 550 (463.237)
The data stated here refers specifically to a
vehicle with standard equipment. Consult an
authorized Mercedes-Benz Center for the
data for all vehicle variants and trim levels. Vehicle dimensions, G 550
Vehicle length
22 183.9 in
(4672 mm) Vehicle width
including exterior
mirrors
79.0 in (2007 mm)
Vehicle height
76.8 in (1951 mm)
Wheelbase
112.2 in ( 2850 mm)
Track width
59.7 in (1515 mm)
Ground clearance,
front
9.1 in (232 mm)
Ground clearance,
rear
8.8 in (223 mm)
Turning circle
44.6 ft (13.6 m)
Vehicle weights, G 550
Gross Vehicle
Weight Rating
(GVWR)
23 6615 lbs (3000 kg)
Gross Axle
Weight Rating
(GAWR), front
24 3110 lbs (1410 kg)
Gross Axle
Weight Rating
(GAWR), rear
24 3965 lbs (1800 kg)
Vehicle data, G 55 AMG (463.271)
The data stated here refers specifically to a
vehicle with standard equipment. Consult an
authorized Mercedes-Benz Center for the
data for all vehicle variants and trim levels.
22 Including spare wheel.
23 GVWR is the maximum total vehicle weight permissible. Gross Vehicle Weight (GVW) is the vehicle weight
including fuel, service products, spare wheel, accessories installed, load and, if applicable, trailer drawbar
load. The GVW must never exceed the GVWR.
24 The GAWR is the maximum gross axle weight rating. Vehicle data
277Technical data Z

Vehicle dimensions
Vehicle length
183.9 in
(4672 mm) 25
188.2 in
(4780 mm) 26Vehicle width
including exterior
mirrors
79.0 in (2007 mm)
Vehicle height
76.8 in (1951 mm)
Ground clearance
9.2 in (234 mm)
Wheelbase
112.2 in (2850 mm)
Track width
59.1 in (1501 mm)
Turning circle
44.6 ft (13.6 m)
Vehicle weights
Gross Vehicle
Weight Rating
(GVWR)
27 6615 lbs (3000 kg)
Gross Axle Weight
Rating (GAWR),
front
28 3263 lb (1480 kg)
Gross Axle Weight
Rating (GAWR),
rear
28 3965 (1800 kg)
25
Including spare wheel.
26 Including spare wheel and styling bar (USA only).
27 GVWR is the maximum total vehicle weight permissible. Gross Vehicle Weight (GVW) is the vehicle weight
including fuel, service products, spare wheel, accessories installed, load and, if applicable, trailer drawbar
load. The GVW must never exceed the GVWR.
28 The GAWR is the maximum gross axle weight rating.278
Vehicle dataTechnical data