2012 LINCOLN NAVIGATOR Line in

[x] Cancel search: Line in

Page 226 of 381

LINCOLN NAVIGATOR 2012  Owners Manual Starting the engine
1. Turn the key to 3 (on) without
turning the key to 4 (start).
2. Turn the key to 4 (start), then
release the key as soon as the
engine begins cranking. Your vehicle
has a compute

Page 227 of 381

LINCOLN NAVIGATOR 2012  Owners Manual Do not use starting fluid such as ether in the air intake system. Such
fluid could cause immediate explosive damage to the engine and possible
personal injury.
If you should experience cold weather st

Page 249 of 381

LINCOLN NAVIGATOR 2012  Owners Manual Note:If the system cannot be turned off, refer toMyKeyin theLocks
and Securitychapter for more information.
The system defaults toenabledevery time the ignition is switched on.
Press the control to d

Page 260 of 381

LINCOLN NAVIGATOR 2012  Owners Manual “Tread Lightly” is an educational
program designed to increase public
awareness of land-use regulations
and responsibilities in our nations
wilderness areas. Ford Motor
Company joins the U.S. Fore

Page 264 of 381

LINCOLN NAVIGATOR 2012  Owners Manual ROADSIDE ASSISTANCE
Vehicles sold in the U.S. : Getting roadside assistance
To fully assist you should you have a vehicle concern, Ford Motor
Company offers a complimentary roadside assistance program

Page 268 of 381

LINCOLN NAVIGATOR 2012  Owners Manual Passenger compartment fuse panel
The fuse panel is located under the right-hand side of the instrument
panel.
To remove the trim panel for access
to the fuse box, pull the panel
toward you and swing i

Page 275 of 381

LINCOLN NAVIGATOR 2012  Owners Manual CHANGING THE TIRES
If you get a flat tire while driving, do not apply the brake heavily.
Instead, gradually decrease your speed. Hold the steering wheel firmly
and slowly move to a safe place on the s

Page 286 of 381

LINCOLN NAVIGATOR 2012  Owners Manual Connecting the jumper cables
Note:In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
1. Connect the positive (+) jumper
cable to the positive (+) ter