2012 Lexus CT200h headlight

548
4-3. Do-it-yourself maintenance
CT200h_OM_OM76067E_(EE)
Replacing light bulbs
Headlight low beams (halogen headlights)
For the right side only: Remove
the securing clips and unclip
the engine coolant reservoir
hose. Then lift up the air
cleaner inlet duct.
Unplug the connector while
pressing the lock release.
STEP1
STEP2

549
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_OM_OM76067E_(EE)Turn the bulb base counter-
clockwise.
Headlight high beams (halogen headlights)
For the right side only: Move
the washer fluid filler opening.
Unplug the connector while
pressing the lock release.
Turn the bulb base counter-
clockwise.
STEP3
STEP1
STEP2
STEP3

550
4-3. Do-it-yourself maintenance
CT200h_OM_OM76067E_(EE)Headlight high beams (LED headlights)
For the right side only: Remove the securing clips and
unclip the engine coolant reservoir hose. Then lift up the air
cleaner inlet duct. (P. 548)
Turn the cover counterclock-
wise and remove it.
Turn the bulb base counter-
clockwise.
Unplug the connector while
pulling the lock release.
STEP1
STEP2
STEP3
STEP4

552
4-3. Do-it-yourself maintenance
CT200h_OM_OM76067E_(EE)Front turn signal lights (halogen headlights)
For the right side only: Remove the securing clips and
unclip the engine coolant reservoir hose. Then lift up the air
cleaner inlet duct. (P. 548)
Turn the bulb base counter-
clockwise.
Remove the light bulb.
STEP1
STEP2
STEP3

553
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_OM_OM76067E_(EE)Front turn signal lights (LED headlights)
Left side
Remove the power control unit
cover.
Turn the bulb base counter-
clockwise.
Remove the light bulb.
STEP1
STEP2
STEP3

558
4-3. Do-it-yourself maintenance
CT200h_OM_OM76067E_(EE)Lights other than the above
If any of the lights listed below has burnt out, have it replaced by
any authorized Lexus dealer or repairer, or another duly quali-
fied and equipped professional.
Headlight low beams (LED type)
Front position lights and daytime running lights
Side turn signal lights
Stop/tail lights
High mounted stoplight
Outer foot light
After replacing the bulbs
After lifting up the air cleaner duct or
removing the power control unit cover,
return the duct or the cover to their origi-
nal positions with the clips.
Push up center portion
Insert
Press

559
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_OM_OM76067E_(EE)
LED lights
The headlight low beams (LED type), front position lights, daytime running
lights, side turn signal lights, stop/tail lights and high mounted stoplight
consist of a number of LEDs. If any of the LEDs burn out, take your vehicle
to any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
When replacing light bulbs
P. 5 4 4
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

574
5-2. Steps to take in an emergency
CT200h_OM_OM76067E_(EE)
Warning lightWarning light/Details
(Flashes)
Pre-crash safety system warning light (if equipped)
Indicates a malfunction in the pre-crash safety system
The warning light will operate as follows, even when
the system is not malfunctioning:
• The light will flash quickly when the system is oper-
ating. (P. 299)
• The light will turn on when the pre-crash braking is
disabled. (P. 300)
• The light will turn on when the system cannot tempo-
rarily be used. (P. 589)
Slip indicator light
Indicates a malfunction in:
• Vehicle stability control;
• Traction control;
• Hill-start assist control
Brake system warning light (yellow indicator)
Indicates a malfunction in:
• The regenerative brake system; or
• The electronically controlled brake system
Automatic headlight leveling system warning light (if
equipped)
Indicates a malfunction in the automatic headlight lev-
eling system