Page 38 of 393

315
Safety features of your vehicle
Seat belt warning (for driver’sseat)
The driver's seat belt warning light
and chime will activate to the follow-
ing table when the ignition switch is
in "ON" position.
*
1Warning pattern repeats 11 times
with an interval of 24 seconds. If
the driver's seat belt is buckled, the
light will stop within 6 seconds and
chime will stop immediately.
*
2The light will stop within 6 seconds
and chime will stop immediately.
Seat belt - Driver's 3-point system with emergency locking retractor
To fasten your seat belt:
To fasten your seat belt, pull it out of
the retractor and insert the metal tab
(1) into the buckle (2). There will be
an audible "click" when the tab locks
into the buckle.
The seat belt automatically adjusts to
the proper length only after the lap
belt portion is adjusted manually so
that it fits snugly around your hips. If
you lean forward in a slow, easy
motion, the belt will extend and let
you move around. If there is a sud-
den stop or impact, however, the belt
will lock into position.
1GQA2083
ConditionsWarning Pattern
Seat BeltVehicle
SpeedLight-BlinkChime-Sound
Unbuckled6 seconds
Buckled6 secondsNone
Buckled →
Unbuckled
Below 5 km/h
(3 mph)6 secondsNone
5 km/h~10 km/h6 seconds
Above 10
km/h (6 mph)6 sec. on / 24 sec. off (11 times)
Unbuckled
Above 10
km/h (6 mph)
↓
Below 5
km/h (3 mph)
6 seconds *1
↓
Stop *
2
B180A01NF-1
Page 40 of 393

317
Safety features of your vehicle
You should place the lap belt portion
as low as possible and snugly across
your hips. If the lap belt is located too
high on your waist, it may increase
the chance of injury in the event of a
collision.
The arm closest to the seat belt
buckle should be over the belt while
the other arm should be under the
belt as shown in the illustration.
Seat belts - Front passenger andrear seat 3-point system withcombination locking retractor
To fasten your seat belt:
Combination retractor type seat belts
are installed in the rear seat posi-
tions to help accommodate the
installation of child restraint systems.
Although a combination retractor is
also installed in the front passenger
seat position, it is strongly recom-
mended that children always be
seated in the rear seat. NEVER
place any infant restraint system in
the front seat of the vehicle.
This type of seat belt combines the
features of both an emergency lock-
ing retractor seat belt and an auto-
matic locking retractor seat belt. To
fasten your seat belt, pull it out of the
retractor and insert the metal tab into
the buckle. There will be an audible
"click" when the tab locks into the
buckle. When not securing a child
restraint, the seat belt operates in the
same way as the driver's seat belt
(Emergency Locking Retractor
Type). It automatically adjusts to the proper
length only after the lap belt portion
of the seat belt is adjusted manually
so that it fits snugly around your hips.
When the seat belt is fully extended
from the retractor to allow the instal-
lation of a child restraint system, the
seat belt operation changes to allow
the belt to retract, but not to extend
(Automatic Locking Retractor Type).
Refer to “Using a child restraint sys-
tem” in this section.
To convert from the automatic lock-
ing feature to the emergency locking
operation mode, allow the unbuckled
seat belt to fully retract.
B200A02NF
Page 186 of 393
4107
Features of your vehicle
Roof rack (if equipped)
If the vehicle has a roof rack, you can
load cargo on top of your vehicle.The following specification is the
maximum weight that can be loaded
onto the roof rack. Distribute the load
as evenly as possible on the roof
rack and secure the load firmly.
Loading cargo or luggage in excess
of the specified weight limit on the
roof rack may damage your vehicle.
When carrying large objects on the
roof rack, make sure they do not
exceed the overall roof length or
width.
✽ ✽
NOTICE
If the vehicle is equipped with a sun-
roof, be sure not to position cargo
onto the roof rack in such a way that
it could interfere with sunroof oper-
ation.
EXTERIOR FEATURES
OAM049092 ROOF 75 kg (165 lbs.)
RACK EVENLY DISTRIBUTED
CAUTION - Using roof
rock
When carrying cargo on the roof
rack, take the necessary precau-tions to make sure the cargodoes not damage the roof of thevehicle.
Page 387 of 393

Specifications, Consumer information, Reporting safety defects
28
DIMENSIONSBULB WATTAGE
*1with roof rack
Light Bulb
Wattage Bulb Type
Headlights (Low) 55 H7
Headlights (High) 55 H11B
Front turn signal lights/
position light (LED)* LED LED
Front turn signal lights/
Position light (Bulb) 28/8 2357
Side turn signal lights (Fender) 5 W5W
Side turn signal lights
(Outside mirror)* LED LED
Front side marker lights5W5W
Front fog lights* 27 H27W
Tail lights 5 W5W
Tail lights and rear side marker 28/8 2357
Stop and tail lights (Bulb) 28/8 2357
Stop and tail lights (LED)* LED LED
Rear turn signal lights 27 1156NA
Back-up lights 16 92
High mounted stop light (Bulb) 5 W5W
High mounted stop light (LED)*LEDLED
License plate lights5W5W
Map lamps 10 W10W
Room lamp 10 FASTEN 10W
Luggage lamp* 5 FASTEN 5W
Glove box lamp* 5 FASTEN 5W
Vanity mirror lamp* 5 FASTEN 5W
Item 1.6L 2.0L
Displacement [cc (cu. in)] 1591 (1.6) 1999 (121.9)
Bore x Stroke [mm(in.)] 77 x 85.44
(3.03 x 3.36) 81 x 97
(3.18 x 3.81)
Firing order 1-3-4-2
No. of cylinders 4, In-line
Itemmm (in)
Overall length 4120 (162.2)
Overall width 1785 (70.3)
Overall height 1610 (63.4) / 1660 (65.4)*
1
Front tread195/65R15 1570 (61.8)
205/55R16 1555 (61.2)
235/45R18 1535 (60.4)
Rear tread 195/65R15 1585 (62.4)
205/55R16 1575 (62.0)
235/45R18 1550 (61.0)
Wheelbase 2550 (100.4)
ENGINE
* If equipped