2012 JEEP WRANGLER air condition

[x] Cancel search: air condition

Page 461 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual The TPMS will not be able to monitor the tire pressure.
If you install the spare tire in place of a road tire that
has a pressure below the low-pressure warning limit,
upon the next ignition key cycle

Page 464 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual •disconnect and reconnect the battery to reset the
engine controller memory
More extensive repairs will be required for prolonged
exposure to E-85 fuel.
MMT In Gasoline
MMT is a manganese containing

Page 466 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual Carbon Monoxide Warnings
WARNING!
Carbon monoxide (CO) in exhaust gases is deadly.
Follow the precautions below to prevent carbon
monoxide poisoning:
•Do not inhale exhaust gases. They contain carbo

Page 486 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual Electronic Speed Control – If Equipped
�
Do not use in hilly terrain or with heavy loads.
�When using the speed control, if you experience speed
drops greater than 10 mph (16 km/h), disengage until

Page 494 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on the
instrument panel below the climate controls.Press the switch to turn on the Hazard Warning
flasher. When the switch is activ

Page 495 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual NOTE:There are steps that you can take to slow down
an impending overheat condition:
•If your air conditioner (A/C) is on, turn it off. The A/C
system adds heat to the engine cooling system and
turn

Page 513 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual MAINTAINING YOUR VEHICLE
CONTENTS
Engine Compartment — 3.6L ............. 513
 Onboard Diagnostic System — OBD II ...... 514
▫ Loose Fuel Filler Cap Message ........... 514
 Emissions Inspect

Page 524 of 613

JEEP WRANGLER 2012 JK / 3.G Owners Manual CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are