VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days, you may want to take steps to preserve your
battery.
•Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
•Or disconnect the negative cable from the battery.
•Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
LIGHT BULBS – Interior Bulb Number
Front Header Lamp......................T578
Center Dome Lamp......................T578
Rear Cargo Lamp/Flashlight.............8–A35LF
LIGHTS BULBS – Exterior Bulb No.
Low Beam/High Beam Headlamp............ H13
Front Park/Turn Signal/Side Marker Lamp. . . 3757KA
Front Fog Lamp......................PSX24W
Center High Mounted Stop Lamp (CHMSL)..... LED
Assembly
Rear Tail/Turn/Stop Lamp.................3157
Backup Lamp.....................W16W (921)
License Lamp.......................... W5W
452 MAINTAINING YOUR VEHICLE
BULB REPLACEMENT
Headlamps
1. Raise the hood and locate the connector behind the
headlamp.
2. Reach into engine compartment and pull red lock out
at connector.
3. Remove the green connector from the back of the bulb
by pulling straight back.
4. Twist the bulb to the left.
5. Pull bulb outward from assembly.
NOTE:These are halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat buildup which reduces bulb
life.
Fog Lamps
Refer to the Service Manual or see your authorized dealer
for bulb replacement.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Rear Tail, Turn Signal And Backup Lamps
1. Raise the liftgate.
2. Remove the two push-pins from the taillamp housing.
3. Grasp the taillamp and pull firmly to disengage the
light from the aperture panel.
4. Twist and remove socket from the light.
5. Remove bulb from socket and replace.
7
MAINTAINING YOUR VEHICLE 453
Lead Free Gasoline...................... 367
Leaks, Fluid............................ 88
Life of Tires............................ 353
Liftgate (Sedan).......................... 37
Liftgate Window Wiper/Washer............. 187
Light Bulbs..........................88,452
Lights..............................88,149
Airbag....................68,69,74,86,199
Alarm............................ 203
Anti-Lock.......................... 200
Back-Up........................... 453
Brake Assist Warning.................. 335
Brake Warning...................... 201
Bulb Replacement.................... 453
Cargo ............................. 182
Center Mounted Stop.................. 454
Daytime Running.................... 150
Dimmer Switch, Headlight.............. 149
Electronic Stability Program (ESP) Indicator . . 335Engine Temperature Warning............ 201
Exterior............................ 88
Fog .........................150,210,453
Headlight Switch..................... 150
Headlights......................... 150
High Beam Indicator.................. 200
Instrument Cluster................... 150
License............................ 454
Lights On Reminder.................. 150
Low Fuel.......................... 199
Malfunction Indicator (Check Engine)...... 209
Map Reading....................... 153
Oil Pressure........................ 199
Seat Belt Reminder................... 200
Security Alarm (Theft Alarm)..........18,203
Theft Alarm (Security Alarm)............ 203
Tire Pressure Monitoring (TPMS)......... 205
Traction Control..................... 335
Turn Signal.................88,149,151,453
492 INDEX
