2012 JEEP LIBERTY center console

[x] Cancel search: center console

Page 71 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual WARNING!
Never place a rear facing infant seat in front of an air
bag. A deploying passenger Advanced Front Air Bag
can cause death or serious injury to a child in a
rear-facing infant seat.
Passenger

Page 165 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual NOTE:If the multifunction lever is held in the flash-to-
pass position for more than 15 seconds, the high beams
will shut off. If this occurs, wait 30 seconds before
activating the flash-to-pass funct

Page 186 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual WARNING! (Continued)
•Before using the ParkSenseRear Park Assist
System, it is strongly recommended that the ball
mount and hitch ball assembly is disconnected
from the vehicle when the vehicle is

Page 207 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual CUPHOLDERS
There are two cupholders for the front seat passengers,
located in the center console.The rear passengers have cupholders at the rear of the
center console.
Front Cupholders
Rear Cupholders

Page 209 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual Console Storage Compartment
To open, press the latch and lift the cover.The center console has a removable storage tray which
can hold cell phones, PDAs, and other small items.
Center ConsoleRemovable

Page 337 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual WARNING! (Continued)
•Since four-wheel drive provides improved trac-
tion, there is a tendency to exceed safe turning and
stopping speeds. Do not go faster than road con-
ditions permit. You or othe

Page 343 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual WARNING! (Continued)
•Since four-wheel drive provides improved trac-
tion, there is a tendency to exceed safe turning and
stopping speeds. Do not go faster than road con-
ditions permit. You or othe

Page 353 of 558

JEEP LIBERTY 2012 KK / 2.G Owners Manual If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to “Fluids, Lubricants, and Genuine
Parts” in “Maintaining Y