2012 JEEP COMPASS headlight bulb

Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.NOTE:
If either light remains on and does not flash, or
there is a very fast flash rate, check for a defective outside
light bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you, to switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beam headlights until the lever is
released.Turn Signals
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

alert you to turn the signals off. If either indicator flashes
at a rapid rate, check for a defective outside light bulb.
9. High Beam IndicatorThis indicator shows that the high beam head-
lights are on. Push the multifunction lever forward
to switch the headlights to high beam, and pull toward
yourself (normal position) to return to low beam.
10. Anti-Lock Brake (ABS) Light This light monitors the Anti-Lock Brake System
(ABS). The light will turn on when the ignition
switch is turned to the ON/RUN position and
may stay on for as long as four seconds.
If the ABS light remains on or turns on while driving, it
indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required. However,
the conventional brake system will continue to operate
normally if the BRAKE warning light is not on. If the ABS light is on, the brake system should be serviced
as soon as possible to restore the benefits of Anti-Lock
brakes. If the ABS light does not turn on when the
ignition switch is turned to the ON/RUN position, have
the light inspected by an authorized dealer.
11. Seat Belt Reminder Light
When the ignition switch is first turned to ON/
RUN, this light will turn on for four to eight
seconds as a bulb check. During the bulb check, if
the driver’s seat belt is unbuckled, a chime will sound.
After the bulb check or when driving, if the driver’s seat
belt remains unbuckled, the Seat Belt Reminder Light
will illuminate and the chime will sound. Refer to
“Occupant Restraints” in “Things To Know Before Start-
ing Your Vehicle” for further information.
198 UNDERSTANDING YOUR INSTRUMENT PANEL

Life of Tires............................ 343
Liftgate (Sedan) .......................... 38
Liftgate Window Wiper/Washer ............. 187
Light Bulbs .......................... 88,442
Lights .............................. 88,148
Airbag .................... 68,69,74,86,197
Alarm ............................ 201
Anti-Lock .......................... 198
Back-Up ........................... 444
Brake Assist Warning .................. 325
Brake Warning ...................... 199
Bulb Replacement .................... 443
Cargo ............................. 182
Center Mounted Stop .................. 444
Daytime Running .................... 149
Dimmer Switch, Headlight .............. 148
Electronic Stability Program (ESP) Indicator . . 325
Engine Temperature Warning ............ 199
Exterior ............................ 88 Fog .........................
149,208,443
Headlight Switch ..................... 148
Headlights ......................... 148
High Beam Indicator .................. 198
Instrument Cluster ................... 148
License ............................ 444
Lights On Reminder .................. 149
Low Fuel .......................... 197
Malfunction Indicator (Check Engine) ...... 207
Map Reading ....................... 152
Oil Pressure ........................ 197
Seat Belt Reminder ................... 198
Security Alarm (Theft Alarm) ..........18,201
Theft Alarm (Security Alarm) ............ 201
Tire Pressure Monitoring (TPMS) ......... 203
Traction Control ..................... 325
Turn Signal ................. 88,148,150,444
Voltage ............................ 196
Warning (Instrument Cluster Description) . . . 196
484 INDEX