2012 INFINITI G37 light

Black plate (422,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]8-16 Maintenance and do-it-yourself GUID-9300F307-19B1-4EC9-B93C-3421C155DC4A
SDI2027
WARNINGAntifreeze is poisonous and should be
stored carefully in marked containers out
of the reach of children.
Fill the window washer fluid reservoir
periodically. Add window washer fluid
when the low window washer fluid warning
light comes on.
To fill the window washer fluid reservoir,
lift the cap off the reservoir tank and pour
the window washer fluid into the tank
opening. Add a washer solvent to the washer for
better cleaning. In the winter season, add a
windshield washer antifreeze. Follow the
manufacturer ’ s instructions for the mixture
ratio.
Refill the reservoir more frequently when
driving conditions require an increased
amount of window washer fluid.
Recommended fluid is Genuine NISSAN
Windshield Washer Concentrate Cleaner &
Antifreeze or equivalent.
CAUTION . Do not substitute engine anti-freeze
coolant for window washer solution. This
may result in damage to the paint.
. Do not fill the window washer reservoir
tank with washer fluid concentrates at
full strength. Some methyl alcohol
based washer fluid concentrates may
permanently stain the grille if spilled
while filling the window washer reser-
voir tank.
. Pre-mix washer fluid concentrates with
water to the manufacturer ’ s recom-
mended levels before pouring the fluid
into the window washer reservoir tank. Do not use the window washer reservoir
tank to mix the washer fluid concentrate
and water.
WINDOW WASHER FLUID

Black plate (429,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]SDI2362
Be careful not to clog the washer nozzle
* A
. This may cause improper windshield
washer operation. If the nozzle is clogged,
remove any objects with a needle or small
pin
* B
. Be careful not to damage the
nozzle. GUID-32FB5E6D-5B48-42A8-9F60-83E657B04471
If the brakes do not operate properly, have
the brakes checked by an INFINITI retailer.
SELF-ADJUSTING BRAKES GUID-2D98160D-8918-4BF3-999B-F13E2922E177
Your vehicle is equipped with self-adjust-
ing brakes.
The disc-type brakes self-adjust every time
the brake pedal is applied.
WARNING See an INFINITI retailer for a brake system
check if the brake pedal height does not
return to normal.
BRAKE PAD WEAR WARNING GUID-0D7DECB1-F0F3-4C66-A768-32FE17341FFF
The disc brake pads have audible wear
warnings. When a brake pad requires
replacement, it will make a high pitched
scraping sound when the vehicle is in
motion. This scraping sound will first occur
only when the brake pedal is depressed.
After more wear of the brake pad, the
sound will always be heard even if the
brake pedal is not depressed. Have the
brakes checked as soon as possible if the
wear warning sound is heard.
Under some driving or climate conditions, occasional brake squeak, squeal or other
noise may be heard. Occasional brake
noise during light to moderate stops is
normal and does not affect the function or
performance of the brake system.
Proper brake inspection intervals should
be followed. For additional information,
see the maintenance log section of your
“ INFINITI Service and Maintenance Guide ”
for maintenance intervals.
Maintenance and do-it-yourself
8-23BRAKES

Black plate (430,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]8-24 Maintenance and do-it-yourself GUID-41D7E39E-6F5A-404E-A0B5-F23908CDD33C
SDI1479A
ENGINE COMPARTMENT GUID-1BD473A4-2C19-4D87-ADC3-1791751AF8EF
CAUTIONNever use a fuse of a higher or lower
amperage rating than that specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not
operate, check for an open fuse.
1. Be sure the ignition switch is pushed to
the OFF or LOCK position and the
headlight switch is turned to OFF. 2. Open the engine hood and remove the
cover on the battery and the fuse/
fusible link holder.
3. Remove the fuse/fusible link holder
cover.
4. Remove the fuse with the fuse puller.
SDI1754
5. If the fuse is open
* A
, replace it with a
new fuse
* B
. Spare fuses are stored in
the passenger compartment fuse box.
6. If a new fuse also opens, have the
electrical system checked and repaired
by an INFINITI retailer.
Fusible links GUID-E9133FFB-99A7-4084-8BC3-32BBC0B20EAC
If any electrical equipment does not
operate and fuses are in good condition,
check the fusible links. If any of these
fusible links are melted, replace only with
genuine INFINITI parts.FUSES

Black plate (431,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ] SDI2034
PASSENGER COMPARTMENT GUID-B150D9E0-F345-4BB5-BF72-57CEBE3509C0
CAUTIONNever use a fuse of a higher or lower
amperage rating than that specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not
operate, check for an open fuse.
1. Be sure the ignition switch is pushed to
the OFF or LOCK position and the
headlight switch is turned to OFF. 2. Open the fuse box lid.
3. Remove the fuse with the fuse puller
* A
.
4. If the fuse is open, replace it with a new
fuse.
5. If a new fuse also opens, have the
electrical system checked and repaired
by an INFINITI retailer. Spare fuses are
stored in the fuse box. SDI2704
Extended storage switch (if
equipped) GUID-686D0C65-BB54-46EA-AAE5-01212C2311DD
To reduce battery drain, the extended
storage switch comes from the factory
switched off. Prior to delivery of your
vehicle, the switch is pushed in (switched
on) and should always remain on.
If any electrical equipment does not
operate, remove the extended storage
switch and check for an open fuse.
NOTE:
If the extended storage switch malfunc-
tions, or if the fuse is open, it is not
necessary to replace the switch. In this
Maintenance and do-it-yourself
8-25

Black plate (432,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]8-26 Maintenance and do-it-yourselfcase, remove the extended storage switch
and replace it with a new fuse of the same
rating.
How to remove the extended storage
switch: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407
1. To remove the extended storage switch,
be sure the ignition switch is in the OFF
or LOCK position.
2. Be sure the headlight switch is in the
OFF position.
3. Remove the fuse box cover.
4. Pinch the locking tabs
* 1
found on
each side of the storage switch.
5. Pull the storage switch straight out
from the fuse box
* 2
. GUID-D6C7487D-F01A-4963-A132-57E4904379BF
SDI1834
Replace the battery as follows:
1. Release the lock knob at the back of the
Intelligent Key and remove the mechan-
ical key.
2. Insert a flat-blade screwdriver
* A
wrapped with a cloth into the slit
* B
of the corner and twist it to separate
the upper part from the lower part. SDI2042
3. Replace the battery with a new one.
Recommended battery: CR2032 or
equivalent. .
Do not touch the internal circuit and
electric terminals as it could cause a
malfunction. .
Hold the battery by the edges.
Holding the battery across the con-
tact points will seriously deplete the
storage capacity. .
Make sure that the + side faces the
bottom of the case.
4. Align the tips of the upper and lower
parts, and then push them together
until it is securely closed.INTELLIGENT KEY BATTERY REPLACEMENT

Black plate (434,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]8-28 Maintenance and do-it-yourself GUID-CC43F1E0-CD84-4C89-AE76-E3BF74F58A31
JVM0099XSEDAN GUID-DC499FCB-C993-49FE-B186-4299E70AF763
1. Front turn signal light and parking
light
2. Headlight (high- and low-beam)
3. Front side marker light
4. Map light
5. Rear personal light
6. Fog light
7. Step light
8. Trunk light
9. High-mounted stop light
10. License plate light
11. Back-up light
12. Rear combination light (rear turn
signal/tail/stop/side marker light)LIGHTS

Black plate (435,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ] SDI2702COUPE GUID-0388FA1F-19E7-4691-88ED-9037CE2CE37C
1. Parking light
2. Headlight (high- and low-beam)
3. Front turn signal light
4. Map light
5. Fog light
6. Front side marker light
7. Step light
8. High-mounted stop light (on the rear
parcel shelf or in the rear spoiler)*
9. Trunk light
10. License plate light
11. Back-up light
12. Rear combination light (rear turn
signal/tail/stop/side marker light)
*: Note that when the factory spoiler is
installed, the rear parcel shelf high-
mounted stop light is still present, but
it is disabled and replaced by the rear
spoiler high-mounted stop light.
Maintenance and do-it-yourself
8-29

Black plate (436,1)
[ Edit: 2012/ 1/ 17 Model: V36-D ]8-30 Maintenance and do-it-yourselfHEADLIGHTS GUID-2C37EBF3-FE69-4D64-AE03-00ECA5091687
Replacing GUID-782124E3-CA8B-42A2-90B0-1AC5B2F9C37A
Xenon headlight bulb: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407
WARNING HIGH VOLTAGE
When xenon headlights are on, they pro-
duce a high voltage. To prevent an electric
shock, never attempt to modify or disas-
semble. Always have your xenon headlights
replaced at an INFINITI retailer. For addi-
tional information, see “ Headlight and turn
signal switch ” (P.2-34).
Use the same number and wattage shown
in the following chart as originally in-
stalled.
If replacement is required, see an INFINITI
retailer.
Fog may temporarily form inside the lens of
the exterior lights in the rain or in a car
wash. A temperature difference between
the inside and the outside of the lens
causes the fog. This is not a malfunction. If
large drops of water collect inside the lens,
contact an INFINITI retailer. EXTERIOR AND INTERIOR LIGHTS GUID-BDE3C310-75C1-4F4D-9E48-5E09104465DA
Sedan GUID-4998FE6F-5C4E-43C2-BA3C-10A3EF2B9ECB
Item Wattage (W) Bulb No.
Headlight*
High/Low beams (xenon) 35 D2S
Front turn signal light* 28 7444NA
Front fog light* 35 H8
Parking light* 8 7444NA
Front side marker light* 5 WY5W
Rear combination light*
back-up 16 W16W
turn signal 21 W21W
stop/tail/side marker LED —
License plate light* 5 W5W
Map light 8 —
Rear personal light 8 —
Vanity mirror light 2 —
Step light* 8 —
Trunk light* 3.4 —
High-mounted stop light* LED —
*: See an INFINITI retailer for replacement.
NOTE: Always check with the Parts Department at an INFINITI retailer for the latest
information about parts.