2012 INFINITI G-CONVERTIBLE garage door opener

GUID-5446BCD8-B2FA-4E23-A9C5-EE0CC97655DFHomeLink®Universal Transceiver provides
a convenient way to consolidate the func-
tions of up to three individual hand-held
transmitters into one built-in device.
HomeLink
®Universal Transceiver:
. Will operate most Radio Frequency (RF)
devices such as garage doors, gates,
home and office lighting, entry door
locks and security systems.
. Is powered by your vehicle’s battery. No
separate batteries are required. If the
vehicle’s battery is discharged or is
disconnected, HomeLink
®will retain all
programming.
Once HomeLink
®Universal Transceiver is
programmed, retain the original transmit-
ter for future programming procedures
(Example: new vehicle purchases). Upon
sale of the vehicle, the programmed
HomeLink
®Universal Transceiver buttons
should be erased for security purposes.
For additional information, see “Program-
ming HomeLink
®” (P.2-53).
WARNING
. Do not use HomeLink®Universal Trans-
ceiver with any garage door opener that
lacks safety stop and reverse features as required by federal safety standards.
(These standards became effective for
opener models manufactured after April
1, 1982.) A garage door opener which
cannot detect an object in the path of a
closing garage door and then automati-
cally stop and reverse, does not meet
current federal safety standards. Using a
garage door opener without these fea-
tures increases the risk of serious injury
or death.
. During programming procedure, your
garage door or security gate may open
or close. Make sure that people and
objects are clear of the garage door,
gate, etc. that you are programming.
. Your vehicle’s engine should be turned
off while programming HomeLink
®Uni-
versal Transceiver.
PROGRAMMING HomeLink®GUID-85A8DB52-5D4A-410F-B74C-59D7400433FETo program your HomeLink®Transceiver to
operate a garage door, gate, or entry door
opener, home or office lighting, you need
to be at the same location as the device.
Note: Garage door openers (manufactured
after 1996) have “rolling code protection”.
To program a garage door opener equipped
with “rolling code protection”; you will
need to use a ladder to get up to the
garage door opener motor to be able to
access the “smart or learn” program
button.
Instruments and controls2-53
HomeLink®UNIVERSAL TRANSCEIVER (if so
equipped)

2-54Instruments and controls
SIC3612
1. To begin, push and hold the 2 outerHomeLink®buttons (to clear the mem-
ory) until the indicator light
*Ablinks
(after 20 seconds). Release both but-
tons.
2. Position the end of the hand-held
transmitter 1-3 inches away from the
HomeLink
®surface.
SIC3613
3. Using both hands, simultaneously push
and hold both the HomeLink®button
you want to program and the hand-held
transmitter button.
DO NOT release the buttons until step 4
has been completed.
4. Hold down both buttons until the
indicator light on HomeLink
®flashes,
changing from a “slow blink”to a
“rapid blink”. This could take up to 90
seconds. When the indicator light
blinks rapidly, both buttons may be
released. The rapidly flashing light
indicates successful programming. To
activate the garage door or other programmed device, push and hold
the programmed HomeLink
®button -
releasing when the device begins to
activate.
5. If the indicator light on HomeLink
®
blinks rapidly for two seconds and then
turns solid, HomeLink®has picked up a
“rolling code” garage door opener
signal. You will need to proceed with
the next steps to train HomeLink
®,
completing the programming may re-
quire a ladder and another person for
convenience.
6. Push and release the program button located on the garage door opener’s
motor to activate the “training mode”.
This button is usually located near the
antenna wire that hangs down from the
motor. If the wire originates from under
a light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener’s motor and the “training light”
is lit, you have 30 seconds in which to
perform step 7. For convenience, use
the help of a second person to assist
when performing this step.

7. Quickly (within 30 seconds of pushingand releasing the garage door opener
training button) and firmly push and
release the HomeLink
®button you’ve
just programmed. Push and release the
HomeLink
®button up to three times to
complete the training.
8. Your HomeLink
®button should now be
programmed. To program the remaining
HomeLink
®buttons for additional door
or gate openers, follow steps 2 through
8 only.
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLink
®buttons.
If you have any questions or are having
difficulty programming your HomeLink
®
buttons, please refer to the HomeLink®
web site at: www.homelink.com or call 1-
800-355-3515.
PROGRAMMING HomeLink®FOR
CANADIAN CUSTOMERS
GUID-1E6AA6A0-C124-48CD-9BAF-EDB500C1AB39Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your hand-
held transmitter to HomeLink
®, continue to
push and hold the HomeLink®button (note
steps 2 through 4 under “Programming
HomeLink
®”) while you push and re-push
(“cycle”) your hand-held transmitter every
2 seconds until the indicator light flashes
rapidly (indicating successful program-
ming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING THE HomeLink®UNI-
VERSAL TRANSCEIVER
GUID-EC404709-2864-44C1-97E6-FE8494B9B99DHomeLink®Universal Transceiver (once
programmed) may now be used to activate
the garage door, etc. To operate, simply
push the appropriate programmed
HomeLink
®Universal Transceiver button.
The red indicator light will illuminate while
the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNO-
SIS
GUID-3AC84787-9EBF-4C77-9CEB-81629E178960If HomeLink®does not quickly learn the
hand-held transmitter information:
. replace the hand-held transmitter bat-
teries with new batteries.
. position the hand-held transmitter with
its battery area facing away from the
HomeLink
®surface.
. push and hold both the HomeLink®and
hand-held transmitter buttons without
interruption.
. position the hand-held transmitter 2 to
5 in (50 to 127 mm) away from the
HomeLink
®surface. Hold the transmit-
ter in that position for up to 15
seconds. If HomeLink
®is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at all
times.
If you continue to have programming
difficulties, please contact the INFINITI
Consumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
Instruments and controls2-55

FluidAutomatic transmission fluid (ATF) ...
............... 8-12
Brake and clutch fluid ...
.................................. 8-13
Brake fluid ...
................................................... 8-14
Capacities and
recommended fuel/lubricants ...
........................ 9-2
Engine coolant ...
............................................... 8-8
Engine oil ...
.................................................... 8-10
Power steering fluid ...
..................................... 8-13
Window washer fluid ...
................................... 8-14
FM-AM-SAT radio with Compact Disc
(CD) player ...
........................................................ 4-53
Fog light switch ...
................................................ 2-37
Front passenger air bag and status light ...
........... 1-42
Front power seat adjustment ...
............................... 1-3
Front seat, Front seat adjustment ...
........................ 1-3
Front-seat active head restraints ...
....................... 1-10
Fuel Capacities and
recommended fuel/lubricants ...
........................ 9-2
Fuel economy ...
............................................... 5-45
Fuel economy information (display) ...
.............. 4-11
Fuel octane rating ...
.......................................... 9-4
Fuel recommendation ...
..................................... 9-4
Fuel-filler cap ...
............................................... 3-31
Fuel-filler door ...
............................................. 3-31
Gauge ...
............................................................ 2-9
LOOSE FUEL CAP warning ...
............................. 3-33
Fuses ...
................................................................ 8-22
Fusible links ...
..................................................... 8-22G
Garage door opener, HomeLink®
Universal Transceiver ...
........................................ 2-53
Gas cap ...
............................................................ 3-31
Gauge ...
................................................................. 2-6
Engine coolant temperature gauge ...
................. 2-8
Fuel gauge ...
..................................................... 2-9
Odometer ...
....................................................... 2-7
Speedometer ...
................................................. 2-7
Tachometer ...
.................................................... 2-8
Trip computer ...
.............................................. 2-25
General maintenance ...
................................... 8-2, 8-3
Glove box ...
......................................................... 2-46
H
Hands-free phone system, Bluetooth®
(models with navigation system) ...
....................... 4-84
Hands-free phone system, Bluetooth®
(models without navigation system) ...
.................. 4-95
Hard top If the top does not open or close ...
................. 3-25
Indicators for retractable hard top
(dot matrix) ...
......................................... 2-22, 3-23
Initializing ...
.................................................... 3-26
Operating using the Intelligent Key ...
.............. 3-26
Retractable hard top operation ...
.................... 3-19
Hazard warning flasher switch ...
.......................... 2-38
Head restraints ...
................................................... 1-7
Headlights
Bulb replacement ...
......................................... 8-26 Headlight switch
...
.......................................... 2-34
Xenon headlights ...
......................................... 2-33
Heated seats ...
.................................................... 2-39
Heater
Automatic climate control ...
............................ 4-30
Engine block heater ...
..................................... 5-57
HomeLink
®Universal Transceiver ...
...................... 2-53
Hood release ...
.................................................... 3-18
Horn ...
................................................................. 2-38
I
Ignition switch
(Push-button) ...
................................................. 5-9
Manual transmission models ...
....................... 5-18
Immobilizer system ...
........................................... 2-29
In-cabin microfilter ...
............................................ 4-38
Indicator Dot matrix display ...
....................................... 2-17
Lights ...
.......................................................... 2-15
INFINITI Vehicle Immobilizer System ...
.................. 2-29
INFINITI voice recognition system ...
.................... 4-109
INFO button ...
........................................................ 4-9
Inside mirror ...
..................................................... 3-35
Inspection/maintenance (I/M) test ...
.................... 9-23
Instrument brightness control ...
........................... 2-37
Instrument panel ...
................................................ 2-4
Intelligent cruise control (ICC) system ...
............... 5-23
Preview function ...
.......................................... 5-45
Intelligent Cruise Control (ICC) system
warning light ...
.................................................... 2-12
Intelligent Key ...
..................................................... 3-3
10-3