2012 Hyundai Accent oil dipstick

Your vehicle at a glance
4
2
ENGINE COMPARTMENT
ORBI071001G/ORBI071001
1. Engine coolant reservoir ...................7-22
2. Windscreen washer fluid reservoir....7-28
3. Radiator cap .....................................7-24
4. Engine oil filler cap ...........................7-20
5. Engine oil dipstick .............................7-20
6. Brake/clutch* fluid reservoir ..............7-25
7. Air cleaner.........................................7-30
8. Fuse box ...........................................7-539.
Positive battery terminal...................7-38
10. Negative battery terminal ..............7-38
11. Automatic transaxle fluid
dipstick* .........................................7-26
* : if equipped
■ Petrol Engine
■ Diesel Engine

Maintenance
2
7
ENGINE COMPARTMENT
ORBI071001G/ORBI071001
1. Engine coolant reservoir
2. Windscreen washer fluid reservoir
3. Radiator cap
4. Engine oil filler cap
5. Engine oil dipstick
6. Brake/clutch* fluid reservoir
7. Air cleaner
8. Fuse box9.
Positive battery terminal
10. Negative battery terminal
11. Automatic transaxle fluid dipstick*
* : if equipped
■ Petrol Engine
■ Diesel Engine

Maintenance
20
7
ENGINE OIL
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to
return to the oil pan.
4. Pull the dipstick out, wipe it clean, and re-insert it fully. 5. Pull the dipstick out again and check
the level. The level should be betweenF and L.
If it is near or at L, add enough oil to bring
the level to F.Do not overfill.
Use a funnel to help prevent oil frombeing spilled on engine components.
Use only the specified engine oil. (Refer to “Recommended lubricants and capaci- ties” in section 8.)
WARNING - Radiator hose
Be very careful not to touch the
radiator hose when checking or
adding the engine oil as it may be
hot enough to burn you.
ORBC070003
CAUTION
Do not overfill with engine oil. Engine damage may result.
Do not spill engine oil, when adding or changing engine oil. If you dropthe engine oil on the engine room,wipe it off immediately.
ORB070004
CAUTION - Diesel engine
Overfilling the engine oil may cause
severe dieseling. It may lead toengine damage accompanied with
abrupt engine speed increment,combustion noise and white smoke emission.

85
Specifications & Consumer information
Recommended SAE viscosity
numberEngine oil viscosity (thickness) has an
effect on fuel economy and cold weather
operating (engine start and engine oil
flowability). Lower viscosity engine oils
can provide better fuel economy and cold
weather performance, however, higher
viscosity engine oils are required for sat-
isfactory lubrication in hot weather.
Using oils of any viscosity other than those recommended could result in
engine damage.When choosing an oil, consider the
range of temperature your vehicle will be
operated in before the next oil change.Proceed to select the recommended oil
viscosity from the chart.
CAUTION
Always be sure to clean the area
around any filler plug, drain plug, ordipstick before checking or drain-ing any lubricant. This is especially
important in dusty or sandy areasand when the vehicle is used onunpaved roads. Cleaning the plugand dipstick areas will prevent dirt
and grit from entering the engine and other mechanisms that couldbe damaged.
Temperature Range for SAE Viscosity Numbers
Temperature °C
(°F)-30 -20 -10 0 10 20 30 40 50 -10 0 20 40 60 80 100 120
Diesel
Engine Oil
5W-30
15W-40
10W-30
0W-30* 2
*1
: For better fuel economy, it is recommended to use the engine oil of a viscosity grade SAE 5W-
20 (API SM/ILSAC GF-4). However, if the engine oil is not available in your country, select the
proper engine oil using the engine oil viscosity chart.
* 2
: It is only for extreme cold area and to be restricted by driving condition and area.
(Especially, not recommended for sustained high loaded and high speed operation.)
Petrol
Engine Oil * 1
20W-50
10W-30
15W-40
5W-20, 5W-30