A U T O D O O R L O C K SProgram how and when the vehicle doors automatically lock and unlock.
Default Lock SettingProgramming the Auto Door Unlock Setting
The doors are preset to
lock when your vehicle
reaches about \f0 mph.
Default Unlock Setting
Only the driver’s door is
preset to unlock when
you shift into Park (P).
Programmable Auto Door Lock\bUnlock Settings
Below are the options you can choose. See Auto Door Locking/Unlockingin your Owner’s
Manual for instructions on programming these settings.
AUTO \fOOR UNLOCK
Auto Unlock
(all doors)
When you turn
the ignition OFFWhen you shift into Park
Auto Unlock
(only driver’s door)
When you turn
the ignition OFFWhen you shift into Park
Turn off
Auto Unlock
Operate manually
AUTO \fOOR LOCK
Auto Lock
When you
reach \f0 mphWhen you shift out of Park
Turn off
Auto Lock
Operate manually
\f. Close the driver’s door. Shiftinto
Park.
2. Turn the ignition switch to ON (II).4. Within 5 seconds, turnthe ignition
switch to LOCK (0).
3. Press and hold the unlock side of
the master lock switch for about \f0
seconds. In that time, you will hear
three clicks.
23
To program all doors to unlock when you shift to Park:
12 Crosstour TRG\fATG_NEW STYLE \b/30/2011 9\f42 AM Page 3
R E A R V I E W C A M E R A
How It Works
• When you shift into Reverse (R), a real\btime image of the area behind yourvehicle is shown in the navigation display, along with helpful parking guide lines.
• The display turns off when you shift out of Reverse.
For added convenience, the area behind your vehicle is displayed to help you navigate
while backing up.
DRIVING POSITION MEMORY SYSTEM (DPMS) (if equipped)
Store a driver's seat and mirror position into memory for each remote transmitter.
Programming DPMS
Note\b A stored memory position is linked to the corresponding keyless remote (\f or 2).
Each item begins to adjust when you unlock the driver’s door with the remote and enter
the vehicle.
\f. Turn the ignition switch to ON (II).
Shift into Park (P).
2. Adjust your preferred seat and
outside mirror settings. 3.
Press the SET button. You will
hear a beep.
4. Press the memory button
corresponding to the remote
(\f or 2) you are using. You will
hear two beeps.
8\f
Model\f w\bthout nav\bgat\bon Model\f w\bth nav\bgat\bon
P\fess and ho\bd
the power button for
3 secon\fs. Repeatto turn back on. P\fess and ho\bd
CA\bCEL for 3
secon\fs. Repeatto turn back on.
Turning the Guide Lines On or Off
Model\f w\bthout nav\bgat\bon Model\f w\bth nav\bgat\bon
12 Crosstour TRG\fATG_NEW STYLE \b/30/2011 9\f44 AM Page \b
