88
uuGauges and DisplaysuMulti-Information Display
Instrument Panel
*1: Default SettingSetup Group Customizable Features Description Selectable settings
Customize Settings
Trip Computer Setup
Adjust
Outside Temp.
DisplayAdjusts the temperature reading by a few degrees.-5°F ~ ±0°F
*1
~ +5°F (U.S.)
-3°C ~ ±0°C *1
~ +3°C
(Canada)
Trip A reset triggerChanges the setting of how to reset trip meter A,
average fuel economy A, average speed A, and elapsed time A.With Refuel/Manual only *1
/
IGN OFF
Trip B reset triggerChanges the setting of how to reset trip meter B,
average fuel economy B, average speed B, and elapsed time B.With Refuel/Manual only *1
/
IGN OFF
Fuel Efficiency
BacklightTurns the ambient meter feature on and off.On *1
/Off
Lighting Setup
Interior Light Dimming TimeChanges the length of time the interior lights stay on
after you close the doors.60sec/30sec *1
/15sec
Headlight Auto Off TimerChanges the length of time the exterior lights stay on
after you close the driver’s door.60sec/30sec/15sec *1
/0sec
Auto Light SensitivityChanges the timing for the headlights to come on.Max/High/Mid/Low/Min *1
115
uuOperating the Switches Around the Steering WheeluWipers and Washers
Continued
Controls
Wipers and WashersThe windshield wipers and washers can be
used when the ignition switch is in ON
(w.
■ MIST
The wipers run at high speed until you release
the lever.
■ Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■ Adjusting the delay *
Turn the adjustment ring to adjust the wiper
delay. ■ Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
■Front Wiper/Washer1Wipers and Washers
NOTICEDo not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICEIn cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation’s
shortest delay setting ( ) and the LO setting become
the same.
Models with intermittent time adjustment ring
Intermittent Time
Adjustment Ring *
MIST
INT : Low speed with
intermittent
OFF
LO : Low speed wipe
HI : High speed wipe
Pull to use
washer.
Long delay
Short delay
* Not available on all models
