2012 HONDA ACCORD COUPE tires

[x] Cancel search: tires

Page 382 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Keeping the tires properly inf lated
provides the best combination of
handling, tread lif e, and riding
comf ort.Underinf lated tires wear unevenly,
adversely affect handling and fuel
economy, and are

Page 383 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual If you check air pressures when the
tires are hot (driven f or several
miles/kilometers), you will see
readings 4 to 6 psi (30 to 40 kPa, 0.3
to 0.4 kgf/cm ) higher than the cold
readings.Thisisnormal

Page 384 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of trea

Page 385 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual In addition to proper inf lation,
correct wheel alignment helps to
decrease tire wear. If you f ind a tire
is worn unevenly, have your dealer
check the wheel alignment.
Have your dealer check the tire

Page 386 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual To help increase tire lif e and
distribute wear more evenly, rotate
the tires according to the
maintenance messages displayed on
the information display.
Move the tires to the positions
shown in the i

Page 387 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Replace your tires with radial tires of
the same size, load range, speed
rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall).
Mixing radial and bias-ply tires on
your veh

Page 388 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual ´
Tires marked ‘‘M S’’ or ‘‘All
Season’’ on the sidewall have an all-
weather tread design suitable for
most winter driving conditions.
For the best perf ormance in snowy
or icy cond

Page 389 of 454

HONDA ACCORD COUPE 2012 8.G Owners Manual Clean the wheels as you would the
rest of the exterior. Wash them with
thesamesolution,andrinsethem
thoroughly.
When installing chains, f ollow the
manuf acturer’s instructions, and
mount them as ti