ABC
5
Driver’s Seat Adjustments
A. Seat Fore/Aft Adjustment
Lift the handle under the front of the
seat to manually slide the seat forward
or rearward.
B. Seat Height Adjustment
Press the vertical control to raise or
lower the seat.
C. Lumbar Adjustment
Press the horizontal control to adjust
the amount of lumbar support.
D. Seatback Recline Adjustment
Lift the lever to manually recline or
raise the seatback. Manual Driver’s Seat
Power Driver’s Seat (optional)A. Seat Adjustment
Move the front horizontal control to
move the seat forward or rearward and
to raise, lower or tilt the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or
raise the seatback.
C. Lumbar Adjustment
Press the rear horizontal control to
adjust the amount of lumbar support.
ABC
D
Memory Driver’s Seat (optional)
Set Memory Positions
1. Adjust the driver’s seat and power outside mirrors to the desired position.
2. Press and hold the MEM button and button 1 on the outboard side of the driver’s seat
until a beep sounds.
3. Repeat these steps using button 2 for a second driver.
Recall Memory Positions
• Press and hold button 1 or 2 until the memory position is reached.
The memory positions also can be programmed using the Vehicle Settings menu to be
recalled automatically.
See Seats and Restraints in your Owner Manual.
11
Passenger Presence System
The passenger’s frontal airbag On indicator located on the overhead console may illuminate
if an object, such as a handbag, briefcase, notebook computer or other electronic device,
is on the unoccupied front seat. If this is not desired, remove the object from the seat.
See Seats and Restraints in your Owner Manual.
Parking Brake
• To set the parking brake, hold down the regular brake pedal; then push down the
parking brake pedal.
• To release the parking brake, hold down the regular brake pedal; then push down the
parking brake pedal until you feel the pedal release.
See Driving and Operating in your Owner Manual.
Cruise Control
Adjusting Cruise Control
RES+ Resume/Accelerate
Rotate the switch up to resume a
set speed.
When the system is active, rotate the
switch up to increase speed.
SET– Set/Coast
When the system is active, rotate the
switch down to decrease speed.
CANCEL
Press to cancel the cruise control
but retain the set speed in memory.
The cruise control set speed is erased
when cruise control or the vehicle ignition
is turned off.
See Driving and Operating in your Owner Manual.
Setting Cruise Control
1. Press the ON/OFFbutton. The
Cruise Controlsymbol will illuminate in
white in the instrument cluster.
2. When traveling at the desired speed,
rotate the SET– switch down to set the
speed. The Cruise Controlsymbol
will illuminate in green in the instrument
cluster.
Accessory Power Outlets
There are four accessory power outlets in the vehicle — located below the audio system,
inside the center console, on the rear of the center console, and in the rear cargo area. All of
the outlets except the rear cargo area outlet are not powered when the vehicle is off to avoid
draining the battery. Always unplug electrical equipment when not in use.
See Instruments and Controls in your Owner Manual.
