2012 FORD SUPER DUTY buttons

6Welcome
Welcome
Thank you for purchasing this REVOLUTION
headrest video monitor with built-in DVD player.
Before operating this system, read this manual
thoroughly and retain it for future reference.
Important Notice
It is unlawful in most jurisdictions for a person
to drive a motor vehicle which is equipped with
a television viewer or screen that is located in
the motor vehicle at any point forward of the
back of the driver’s seat, or that is visible, dire
ct-
ly or indirectly, to the driver while operating the
vehicle. In the interest of safety, the unit should
never be installed where it will be visible, direct -
ly or indirectly, by the operator of the motor
vehicle. If your vehicle is equipped with a wire-
less rear seat audio system or any other wireless
IR device, power system of in order to operate
the DVD headrest system. If system is powered
on, the two systems may interfere with each
other canceling out or creating undesirable
audio through the wireless headphones.
Safety Precaution
For safety reasons, when changing video disc
it is recommended that the vehicle not be in
motion, and that you do not allow children
to unfasten safety belts to change disc or
make any adjustments to the system. System
adjustments can be accomplished using the
remote control unit, while safety belts remain
fastened. Enjoy your entertainment system
but remember that safety of all passengers
remains the number one priority.
Product Features
t
7-inch Color TFT-LCD Panel
(480x234) with 16:9 aspect
t
Built-in Top-Loading Slot load DVD Player
t
Infrared Transmitters for IR Wireless Head-
phones
t
Audio/Video Source Input- 3 RCA Jacks
t
USB 2.0 (optional)
t
1/8-inch Stereo Headphone Jack
t
Forward Remote Sensor on the Front Panel t

Full Function Remote Control
t
5 Control Buttons on the Front Panel-
POWER, SOURCE, STOP, PLAY, EJECT
t
OSD (On Screen Display) Control
t
12V DC Power Input
t
FM Transmitter (may be optional)
Caution:
t
Do not touch the inner pins of the jacks on
the front panel. Electrostatic discharge may
cause permanent damage to the device.
t
Be sure to run the vehicle engine while us-
ing the device. Using this device without
running the engine can result in battery
drainage. To avoid the risk of battery
drainage, please remember to turn of the
device when the vehicle is not in use for
long periods of time.

7Welcome
ENWireless Headphones
This unit includes a built-in dual channel infra-
red transmitter for use with a wireless head-
phone. The volume can then be adjusted with
the controls on each headset. The wireless
headphone must be used within a line of sight
from the transmitter as infrared transmission,
like visible light, travels only in a straight line.
Wired Headphones
There is a 1/8-inch headphone jack on the de-
vice that can be used with any standard stereo
headphone. Remove and save the protective
plastic cover to access the jacks. Remember
to replace the cover when the jacks are not in
use.
AV Input
An external AV device such as a DVD player,
video game device, or other audio/video
device may be connected to the unit by using
the “AV INPUT” port consisting of 3 RCA jacks
(Yellow: Video, Red: Audio-R, White: Audio-L).
To display and listen to the video/audio sig-
nal of this external source, connect the video
source RCA cables to the AV inputs on the
monitor. The video source will overide any
other video source for that monitor.
Wireless FM Transmitter
Your device may be equipped with an external
FM transmitter, which allows you to listen to
the audio signal by tuning your vehicle’s FM
radio to the selected frequency and turning
SOUND AROUND on with the remote. When-
ever the SOUND AROUND is on, broadcast
radio reception may be poor. Performance will
vary based on geographic location. Turning
SOUND AROUND of will allow normal radio
reception.
How to use the FM Transmitter
Power up your system and place a disc in
monitor “A”. While pointing your remote at
the monitor press the “DVD A” button directly under the red “POWER” button on your remote
control. Next press the “Sound Around ON/
OFF” button to turn FM transmission on or of
as desired. Three buttons to right is the “Sound
Around SELECT” button which will cycle
through 6 possible stations (88.3, 88.7, 89.1,
89.5, 89.9, and 90.3MHz) for broadcasting au-
dio to your radio. Once you’ve selected a fre-
quency, you must then tune your radio to the
corresponding frequency. Try each station fre-
quency until you achieve a clear audio signal.

13Button Function Descriptions
EN1. SOURCE
Any video equipment connected to the
audio/video inputs can be used with the
monitor by pressing this button. Each
time the button is pressed, the audio/
video source will change in the following
sequence: Monitor A, Monitor B, AUX/TV,
AUX 2.
2. POWER
Press the button to turn the device on. The
current video source will be displayed on
the screen, and the picture will appear in a
few seconds. Press the button again to turn
the device off.
3. DVD-Monitor A
Transmit IR codes for DVD mode of
MONITOR A.
4. TV-Monitor A (If available)
Transmit IR codes for TV mode of Monitor A.
5. SOUND AROUND ON/OFF (If available)
Turn the FM transmitter ON/OFF.
6. MUTE (for DVD only)
Press the button to shut off the sound
transmitted to the headphone stations.
The screen will display that the sound has
been turned off. Pressing the button again
restores sound to the previously set level.
7. MENU
Press the button to go to the Root Menu
included on the disc.
8. UP, DOWN
For DVD: Navigation button, you can
use this button to move the select bar to
items among the menu or file list. For TV:
Use these buttons to advance to the next
higher or lower channel. For OSD: Increase
or decrease the setting of selected item.
9. LEFT, RIGHT
Navigation button; you can use this button
to move the select bar to one of the items
in the menu or file list. 10.
ENTER
Makes a selection or begins playback of
the disc.
11. TITLE
Navigate the title menu included in the disc.
12. SUBTITLE
Press this button. If the current disc has dif-
ferent subtitles options, this now appears
on the screen. Press this button repeat-
edly until you have reached your desired
subtitles option.
13. Numbers
Decimal number: 0 to 9.
14. CLR
Press this button to clear any wrong
numeric input from the number keypad.
15. PLAY
Press this button to Play a disc that is
inserted into the DVD Player.
16. STOP
Stop playing the movie or songs.
STOP PLAY: Resumes disc playback.
STOP STOP PLAY: Resumes from the begin-
ning of the disc.
17. PAUSE
While playing, press this button to pause
the playback of the CD or DVD.
18. FR (Fast Rewind)
Press this button to search disc backward
continuously. There are 5 speed options to
choose: 2X, 4X, 8X, 16X, and 32X.
19. FF (Fast Forward)
Press this button to search disc forward
continuously. There are 5 speed options to
choose: 2X, 4X, 8X, 16X, and 32X.
20. SETUP
Navigate the Setup Menu. Please refer to
the appropriate section of this manual for
detailed information on each menu.

17How to use the DVD OSD Menu
EN
How to use the DVD OSD Menu
This section describes how to set and adjust
settings using the on-screen setup pages
included in the On-screen Display (OSD)
Menu. You can use the OSD menu screen to
adjust all the settings on your screen. Follow
the steps outlined below to select the func-
tion you desire, and refer to the pages indi-
cated for more information.
General Setup Menu
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
(Accessible when no disc is loaded)
To cancel using the Setup Display : Press the
SETUP button on the remote
OSD Language Menu
(Accessible when no disc is loaded) The OSD Lang sub-menu allows the user to
select the language for the on-screen display.
Press the right (forward)button and then use
the up and down buttons on the remote
control to select the desired language. The
user can select English, Simple / Traditional
Chinese, French, German, Italian, Spanish,
Portuguese or Korean for the OSD language.
Press ENTER to select and then the left (back)
button to return to the sub-menu.
Angle Mark Menu
(Accessible when no disc is loaded)
The angle mark is an option for diferent
viewing angles on the DVD.
Press the
or button to turn the angle
mark setting on or of. Press ENTER to select
and then the button to return to the sub-
menu.

18
ENAudio Setup Menu
(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Speaker Setup Menu
Press the Setup button on the remote con-
trol. Press the once to reach the Audio
Setup Page. Press ENTER to navigate to the
sub-menu. Use theuse the and to
navigate the sub-menus. Press the ENTER
or button to select an item and then the
buttons to see the selection items. Press
ENTER to select and then the to return to
the sub-menu.
t
5IF
4QFBLFS
4FUVQ
NFOV
IBT
UIF
GPMMPXJOH

options: LT/RT, Stereo, V SURR and OFF.
t
5IF
%PMCZ
%JHJUBM
4FUVQ
NFOV
IBT
UIF
GPM -
lowing options: Stereo, L-Mono, R-Mono and
Mix-Mono.
Quality Setup Menu
(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Video Quality Setup Menu
Press the SETUP button on the remote con-
trol, press the to navigate to the Video
Setup Page. Press ENTER twice to enter the
sub-menu. Use the and the or to
navigate the sub-menus. Press the ENTER
or button to select an item and then the
buttons to see the selection items. Press
ENTER to select and then the to return to
the sub-menu.

20How to use the Device OSD Menu
EN
How to use the Device OSD Menu
Preference Setup Menu(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Setting for Audio
This section of the Setup Menu allows the
user to control the audio stream in the
selected language for playback automati-
cally.
Settings for Subtitle
This section of the Setup Menu allows the
user to turn the subtitles ON or OFF in the
selected language for playback automati-
cally.
Settings for Disc Menu
This section of the Setup Menu allows the
user to control the DVD disc menu in the
selected language.
Settings for Parental
This section of the Setup Menu allows user to
control the content of movie playback from
G to ADULT. The parental control function
allows you to limit viewing to your
preference. The rating levels are from 1 to 8
and are country dependant. After navigating to the Parental sub- menu
under the Preference Page, use the
and
the buttons on the remote control to
select: KID SAFE (Children); G; PG; PG 13; PGR;
R; NC 17; ADULT. NOTE: The lower the value,
the more strict the limitation.
Setting the Parental Control
Password
1. Press the SETUP button and navigate to the
Password submenu under the Password Set-
up Page. The menu appears and allows you to
change the parental control password.
2. Press the button and then press the
ENTER button on the remote control to enter
the sub-menu.
t
0ME
1BTTXPSE
*OQVU
UIF
PME
QBTTXPSE
PS

the default pass- word (6 digits).
t
/FX
1BTTXPSE
*OQVU
B
OFX
QBTTXPSE


digits) using numeric buttons.
t
$POöSN
1BTTXPSE
$POöSN
UIF
OFX

password by entering the same new pass-
word again.
3. Scroll to the OK button and press the
ENTER button on the remote control. Your
password has been changed.
(Note: The default password is 136900)
Default Setting
Press the SETUP button on the remote con-
trol, navigate to the default sub-menu under
the Preference page using the and the


-

22Playing a MP3 Disc
EN
Playing a MP3 Disc
MP3 is a format for storing digital audio. An
audio CD-quality song can be compressed into
the MP3 format with very little loss of quality,
while taking up much less space. CD-R discs
that have been encoded in MP3 format can be
played on your DVD player.
Selecting Folders and Songs
When an MP3 disc is inserted in the player, the
navigation screen appears automatically. You
can change folders and songs by navigating
the fle system. The DVD player plays the songs
in the order they were burned to the disc.
1. If a disc is playing, press the DISPLAY
button on the remote control, and then
press the UP or DOWN arrow buttons to
go through the folder list on the left side
of the navigation screen.
2. Once the folder you want is highlighted,
press the ENTER button on the remote
control
3. Press the UP or DOWN arrow button on
the remote control to go through the
song list and highlight the song you
want. Press the ENTER button to begin
the playback of the highlighted song. Skipping Songs
Use the
(NEXT ) button on the remote
control to move to the next song. Use the
(PREV ) button to move to the beginning of
the currently playing song. Press the (PREV )
button 2 times to move to the previous song.
Selecting a Play Mode
You can choose what order the songs will play
on a disc temporarily. The FOLDER play mode
is the default. To access the play mode opera-
tions, press the REPEAT button on the remote
control. The play mode options are as follows:
Single: Play a selected song.
Repeat One: Repeat the song that is playing.
Folder: Play the folder in the order the songs
were recorded.
Folder Repeat: Repeat the folder that is playing.
Random: Play the songs in the random order.
Shufe: Play the songs in random order (with-
in the selected folder).