2012 FORD SUPER DUTY audio

15General Operating Instructions
General Operating Instructions
Turning the Device ON or OFF
1. Pivot the screen downward until a com-
fortable viewing angle is reached.
2. Press the POWER button on the lower-left corner of the front panel or the remote
control to turn the device on or of. When
in use, the controls will be lit.
3. After the device has been turned on and is displaying a picture, adjust the
viewing angle by pivoting the screen to
optimize the picture quality.
4. Remember to turn the device of and pivot the LCD panel to the locked posi-
tion when not in use.
DVD Basic
To get the most use out of each DVD, make
sure you read this section completely.
Regional Coding
Both the DVD player and disc are coded by
region. These regional codes must match in
order for the disc to play. If the codes do not
match, the disc will not play by default. The
system is preset to the region code desig-
nated for your area by the DVD Copy Control
Association. Other regions may not be played
in this system.
Type of Discs your DVD will play
DVD-Video: DVD contains video.
DVD +/- R: DVD contains video.
CD-DA: CD contains musical or sound content
only.
CD-Video: CD contains movie only.
CD-R/RW: A disc that contains audio fles (for
example, a CD-R with downloaded MP3 fles),
MPEG, or JPEG fles. Loading and Playing Discs
Before you load a disc, make sure that it is com-
patible with the player. Note that the following
discs
CANNOT be used with this player:
Optical disc- CD-1, CD-ROM, and DVD-ROM
Mini disc- CDG (audio only, not graphics)
To Load and Play a Disc
When you press the POWER button the sys-
tem turns on in DVD mode. Place the disc
about halfway into the disc compartment slot,
with the disc’s label facing the rear of the
vehcle. player, do NOT insert the disc at an
angle. The disc must be inserted straight into
the player.
The disc will load automatically and begin to
play. (Some discs may start at the root menu,
where play must be selected to start movie.)
Depending on the disk and playback location
on the disc, the icon may be displayed in the
upper-left corner of the screen indicating that
still playback is not possible.

16General Operating Instructions
ENNotes on Discs
t
To keep a disc clean, do not touch its sur-
face. Handle the disc by its edge.
t
Keep your discs in their cases or disc
magazines when not in use. Also, do not
subject disc to heat/high temperature.
Avoid leaving them in a parked vehicle or
on a dashboard/rear tray.
t
Do not attach labels, or use discs with
sticky ink/residue. Such discs may stop
spinning when used, causing a malfunc-
tion, or may ruin the disc.
t
Do not use any discs with labels or stickers
attached. The following malfunctions may
result from using such discs:
t
Inability to eject a disc (due to a label
or sticker peeling of and jamming the
eject mechanism).
t
Inability to read audio data cor-
rectly (i.e., playback skipping, or no
playback) due to heat shrinking of a
sticker or label causing a disc to warp.
t

Before playing, clean the discs with a
commercially available cleaning cloth.
Wipe each disc from the center out.
Do not use solvents such as benzene,
thinner, commercially available clean-
ers, or antistatic spray intended for
analog discs.
t
Use only normal, round discs. If you
insert irregular, non-round, shaped
discs they may jam in the DVD player
or not play properly.

18
ENAudio Setup Menu
(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Speaker Setup Menu
Press the Setup button on the remote con-
trol. Press the once to reach the Audio
Setup Page. Press ENTER to navigate to the
sub-menu. Use theuse the and to
navigate the sub-menus. Press the ENTER
or button to select an item and then the
buttons to see the selection items. Press
ENTER to select and then the to return to
the sub-menu.
t
5IF
4QFBLFS
4FUVQ
NFOV
IBT
UIF
GPMMPXJOH

options: LT/RT, Stereo, V SURR and OFF.
t
5IF
%PMCZ
%JHJUBM
4FUVQ
NFOV
IBT
UIF
GPM -
lowing options: Stereo, L-Mono, R-Mono and
Mix-Mono.
Quality Setup Menu
(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Video Quality Setup Menu
Press the SETUP button on the remote con-
trol, press the to navigate to the Video
Setup Page. Press ENTER twice to enter the
sub-menu. Use the and the or to
navigate the sub-menus. Press the ENTER
or button to select an item and then the
buttons to see the selection items. Press
ENTER to select and then the to return to
the sub-menu.

20How to use the Device OSD Menu
EN
How to use the Device OSD Menu
Preference Setup Menu(Accessible when no disc is loaded)
Press the SETUP button on the remote con-
trol, use the and the or buttons
to navigate the Setup Page. Press ENTER to
select and then the to return to the sub-
menu.
Setting for Audio
This section of the Setup Menu allows the
user to control the audio stream in the
selected language for playback automati-
cally.
Settings for Subtitle
This section of the Setup Menu allows the
user to turn the subtitles ON or OFF in the
selected language for playback automati-
cally.
Settings for Disc Menu
This section of the Setup Menu allows the
user to control the DVD disc menu in the
selected language.
Settings for Parental
This section of the Setup Menu allows user to
control the content of movie playback from
G to ADULT. The parental control function
allows you to limit viewing to your
preference. The rating levels are from 1 to 8
and are country dependant. After navigating to the Parental sub- menu
under the Preference Page, use the
and
the buttons on the remote control to
select: KID SAFE (Children); G; PG; PG 13; PGR;
R; NC 17; ADULT. NOTE: The lower the value,
the more strict the limitation.
Setting the Parental Control
Password
1. Press the SETUP button and navigate to the
Password submenu under the Password Set-
up Page. The menu appears and allows you to
change the parental control password.
2. Press the button and then press the
ENTER button on the remote control to enter
the sub-menu.
t
0ME
1BTTXPSE
*OQVU
UIF
PME
QBTTXPSE
PS

the default pass- word (6 digits).
t
/FX
1BTTXPSE
*OQVU
B
OFX
QBTTXPSE


digits) using numeric buttons.
t
$POöSN
1BTTXPSE
$POöSN
UIF
OFX

password by entering the same new pass-
word again.
3. Scroll to the OK button and press the
ENTER button on the remote control. Your
password has been changed.
(Note: The default password is 136900)
Default Setting
Press the SETUP button on the remote con-
trol, navigate to the default sub-menu under
the Preference page using the and the


-

21Playing an Audio CD
EN
Playing an Audio CD
When playing an audio CD, the DISPLAY ban-
ner appears automatically. It displays the cur-
rent track and the amount of time the track has
been playing, the total amount of time on the
disc and the current time running on the disc.
Press the DISPLAY button on the remote con-
trol to display the DISPLAY banner.
The options below show you what happens
when you press the DISPLAY button.
Press DISPLAY (1x)
“Single Elapsed” appears along with the
current track playing and the time of that
track.
Press DISPLAY (2x)
“Single Remain” appears along with the
current track playing and the amount of time
left.
Press DISPLAY (3x)
“Total Elapsed” appears along with the current
track playing and the total time playing on CD.
Press DISPLAY (4x)
“Total Remain” appears along with the current
track playing and the amount of time left on CD. Using the REPEAT Feature
The default mode for the
REPEAT feature is
OFF. Pressing REPEAT button on the remote
control consecutively changes the REPEAT
options as follows:
- repeat the track that is playing.
- repeat the disc that is playing.
As you toggle through the options, the REPEAT
option changes. The track repeats once that
track has ended. The selected repeat option
loops repeatedly until you turn it of.

22Playing a MP3 Disc
EN
Playing a MP3 Disc
MP3 is a format for storing digital audio. An
audio CD-quality song can be compressed into
the MP3 format with very little loss of quality,
while taking up much less space. CD-R discs
that have been encoded in MP3 format can be
played on your DVD player.
Selecting Folders and Songs
When an MP3 disc is inserted in the player, the
navigation screen appears automatically. You
can change folders and songs by navigating
the fle system. The DVD player plays the songs
in the order they were burned to the disc.
1. If a disc is playing, press the DISPLAY
button on the remote control, and then
press the UP or DOWN arrow buttons to
go through the folder list on the left side
of the navigation screen.
2. Once the folder you want is highlighted,
press the ENTER button on the remote
control
3. Press the UP or DOWN arrow button on
the remote control to go through the
song list and highlight the song you
want. Press the ENTER button to begin
the playback of the highlighted song. Skipping Songs
Use the
(NEXT ) button on the remote
control to move to the next song. Use the
(PREV ) button to move to the beginning of
the currently playing song. Press the (PREV )
button 2 times to move to the previous song.
Selecting a Play Mode
You can choose what order the songs will play
on a disc temporarily. The FOLDER play mode
is the default. To access the play mode opera-
tions, press the REPEAT button on the remote
control. The play mode options are as follows:
Single: Play a selected song.
Repeat One: Repeat the song that is playing.
Folder: Play the folder in the order the songs
were recorded.
Folder Repeat: Repeat the folder that is playing.
Random: Play the songs in the random order.
Shufe: Play the songs in random order (with-
in the selected folder).

23Connecting a USB Device
You can connect a USB mass storage device
such as a USB memory stick, digital audio
player (USB mass storage class device) etc. to
the USB port of the REV LT unit.
The REV LT unit can play many popular formats
stored in a USB device, including but not
limited to the following fle types: JPEG, JPG,
M2V, MP3, MPE, MPEG Formats (MPEG-1,
MPEG-2, MGEP-4), MPG, OGG, WMA and MWV.
Turn on the REV LT unit to watch the playback
picture if you playback a fle. You can also con-
trol playback by refering to the REV LT unit
screen.
Order of Tracks
The Rev LT unit plays the fles in the order that
they were written to the USB drive. Therefore,
the playing order may not be the same as the
order shown on your device or as expected.
To access the fle structure/menus, for the USB
device, you will need the remote control, set to
the appropriate systems (A or B).
Upon insertion, the USB device may begin
playing fles automatically, returning to the
previous position, if it was unplugged during
a previous playback. To return to the menus,
press MENU or LEFT ARROW, depending on
the type of fle being played. The current
directory will appear, listing all fle types. Controls:
MENU – Return to the menu structure.
UP / DOWN – Moves the select bar up/down
within the selected menu/fle list.
LEFT – Moves menu up one level / Returns to
the menu structure for some functions.
RIGHT – Selects menu item.
ENTER – Makes a selection or begins playback
of fles.
PLAY – Press this button to play fle
STOP – Stops playing the movie/song
PAUSE – While item is playing, press this but-
ton to temporarily stop the playback
FR (Fast Rewind) – Press to move backwards
(2x, 4x, 8x, 16x, 32x) within a fle.
FF (Fast Forward) – Press to move forwards (2x,
4x, 8x, 16x, 32x) within a fle.
PREV – Moves to previous fle.
NEXT – Moves to next fle.
Sample of Root Directory:
File Structure:

Music Playback: Screen will display: Folder
Location, Elapsed Time, and if available: Song
Title, Artist, and Album.
EN
Connecting a USB Device

24Connecting a MP3 Device
Connecting a MP3 Device
Connecting a MP3 Device to your REV LT
Unit via USB
Plug the MP3 Dock Connector to USB cable
into a high-power USB port on your REV LT
unit, and then connect the other end to the
player.
See the documentation that came with your
device for more information.
Charging the MP3 Player Battery
Connect the device to the USB port on your
REV LT unit. The REV LT unit must be turned on.
Depending on the device, it may or may not
charge when connected to the USB port.
Note: Not all devices are able to charge when
connected to the USB port.
Connecting a MP3 Device to your
REV LT Unit via AV cable
t
Connect the device using an AV cable to
the headphones port . Note: Use the AV
cable made specifcally for the device.
Other similar RCA-type cables might not
work.
t
Connect the video and audio connectors
to the AV-IN ports on your REV LT unit, as
shown. EN