Page 114 of 346

The turn signal lamps will flash once when all doors, the hood and the
trunk are closed indicating the vehicle is locked and entering the
20 second countdown. If any closure is not properly closed the turn
signal lamps will not flash and that closure will not be armed.
Disarming the system
You can disarm the system by any of the following actions:
•Unlock the doors by using the remote entry transmitter portion of
your integrated keyhead transmitter.
•Turn ignition to the on position with a valid programmed SecuriLock
key or integrated keyhead transmitter (IKT).
•Press the panic control on the remote entry transmitter portion of
your IKT. This will only shut off the horn and turn lamps when the
alarm is sounding. The alarm system will still be armed.
•Use a key in the driver’s door to unlock the vehicle.
Pressing the power door unlock control within the 20 second prearmed
mode will return the vehicle to a disarmed state.
Note:Unlocking the trunk inhibits the motion sensing system but the
system continues to monitor the doors, hood and vehicle incline. Once
the trunk becomes closed the motion sensing system will rearm.
Triggering the anti-theft system
The armed system will be triggered if:
•Any door, the hood or the trunk is opened without using the remote
entry transmitter portion of your IKT or key in driver door cylinder.
•The ignition is turned to the on position with an invalid
unprogrammed SecuriLockkey or IKT.
•The vehicle is towed/inclined.
•Motion is detected in the interior passenger compartment.
Locks and Security
114
2012 05+ Mustang(197)
Owners Guide, 1st Printing
USA(fus)
Page 276 of 346
OPENING THE HOOD
1. Inside the vehicle, pull the hood
release handle located on the
driver’s side kick panel.
2. Go to the front of the vehicle and release the auxiliary latch that is
located under the front center of
the hood.
3. Lift the hood and secure it with
the prop rod.
Maintenance and Specifications
276
2012 05+ Mustang(197)
Owners Guide, 1st Printing
USA(fus)
Page 280 of 346

CHANGING THE WIPER BLADES
1. Pull the wiper blade and arm
away from the glass.
2. Squeeze the locking tabs to
release the blade from the arm and
pull the blade away from the arm to
remove it.
3. Attach the new blade to the arm and snap it into place.
Replace wiper blades at least once per year for optimum performance.
Poor wiper quality can be improved by cleaning the wiper blades and the
windshield. Refer toWindows and wiper bladesin theCleaning
chapter.
To prolong the life of the wiper blades, it is highly recommended to
scrape off the ice on the windshield before turning on the wipers. The
layer of ice has many sharp edges and can damage the micro edge of the
wiper rubber element.
ENGINE OIL
Checking the engine oil
Refer to thescheduled maintenance informationfor the appropriate
intervals for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait 15 minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park) (automatic transmissions) or 1 (First) (manual transmissions).
4. Open the hood. Protect yourself from engine heat.
Maintenance and Specifications
280
2012 05+ Mustang(197)
Owners Guide, 1st Printing
USA(fus)
Page 343 of 346

Emission control system ..........300
Engine ........................................311
cleaning ...................................269
coolant .....................................285
fail-safe cooling .......................290
idle speed control ...................283
lubrication specifications .......309
refill capacities ........................309
service points ..................277–278
Engine block heater .................207
Engine oil ..................................280
checking and adding ..............280
dipstick ....................................280
filter, specifications ........282, 308
recommendations ...................282
refill capacities ........................309
specifications ..........................309
Event data recording ....................7
Exhaust fumes ..........................206
F
Fail safe cooling ........................290
Fleet MyKey programming ........94
Floor mats ...................................87
Fluid capacities .........................309
Fog lamps ....................................55
Fuel ............................................291
calculating fuel economy..21, 297
cap ...........................................293
capacity ...................................309
choosing the right fuel ...........294
detergent in fuel .....................296
filler funnel .............................296
filling your vehicle with
fuel ...........................291, 293, 297
filter, specifications ........291, 308
fuel pump shut-off ..................231
improving fuel economy ........297octane rating ...................295, 311
quality ......................................295
running out of fuel .........254, 296
safety information relating to
automotive fuels .....................291
Fuses ..................................231–232
G
Garage door opener ....................80
Gas cap (see Fuel cap) ............293
Gas mileage (see Fuel
economy) ...................................297
Gauges .........................................17
H
Hazard flashers .........................230
Headlamps ...................................54
aiming ........................................57
autolamp system .......................54
bulb specifications ....................61
daytime running lights .............56
flash to pass ..............................56
high beam .................................56
replacing bulbs .........................62
turning on and off ....................54
Head restraints .................115, 123
Heating
heating and air conditioning
system .................................46, 49
Hood ..........................................276
I
Ignition ...............................203, 311
Illuminated visor mirror .............69
Infant seats (see Safety seats)..155
Index
343
2012 05+ Mustang(197)
Owners Guide, 1st Printing
USA(fus)