Charging system:Illuminates when
the battery is not charging properly.
If it stays on while the engine is
running, there may be a malfunction
with the charging system or a related component. Contact your
authorized dealer as soon as possible.
Check fuel cap (gasoline engine
only):Illuminates when the fuel cap
may not be properly installed.
Continued driving with this light on
may cause the service engine soon
warning indicator to illuminate.
Check suspension (if equipped):
Illuminates when the air suspension
dump switch has been activated.
Check trans (Allison automatic
transmission only):Illuminates
while driving if a problem has been
detected and shifting may be
restricted. Depending upon the
severity of the problem, the
read-out digit on the shifter display
may be blank.
On MD 3000 series transmissions,operation may continue in order to
reach service assistance. The ECU may not respond to shift selector
requests, since operating limitations are being placed on the
transmission, i.e. upshifts and downshifts may be restricted. Direction
changes do not occur.
Refer to your transmission operator’s manual for more information.
Diesel exhaust fluid (diesel
engine only):Illuminates when the
diesel exhaust fluid level falls below
0.5 gallon (1.9L) in the 5 gallon
(19.0L) tank or 1 gallon (3.8L) in
the 9 gallon (34.0L) tank. Refill the
tank or, at a minimum, add at least
1 gallon (3.8L) to the 5 gallon
(19.0L) tank or 2 gallons (7.6L) to the 9 gallon (34.0L) tank.
Instrument Cluster
22
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
Diesel particulate filter (diesel
engine only):Illuminates when the
soot level in the DPF has reached a
point where it requires operator
assistance. Refer toDiesel
particulate filterin the
Maintenance and Specifications
chapter and your engine operator’s
manual, for more details.
Do not shift (Allison automatic
transmission only):Illuminates
while driving if a problem has been
detected and shifting may be
restricted. Depending upon the
severity of the problem, the
read-out digit on the shifter display
may be blank. Operation may
continue in order to reach service assistance. The ECU may not respond
to shift selector requests, since operating limitations are being placed on
the transmission, i.e. upshifts and downshifts may be restricted.
Direction changes do not occur.
Refer to your transmission operator’s manual for more information.
Electronic locking differential
(if equipped):Displays when using
the electronic locking differential.
Engine oil pressure (gasoline
engine only):Illuminates when
engine oil pressure is low.
High beams:Illuminates when the
high-beam headlamps are turned on.
Instrument Cluster
23
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
5.Fuel gauge:Indicates approximately how much fuel is left in the fuel
tank (when the ignition is in the on position). The fuel gauge reading
may vary slightly when the vehicle is in motion or on a grade. Refer to
Filling the tankin theMaintenance and Specificationschapter for
more information.
6.Speedometer:Indicates the current vehicle speed.
Odometer and trip odometer:The odometer is displayed on the lower
line in the message center and registers the total accumulated distance
the vehicle has traveled. For trip odometer information, refer toMessage
centerin this chapter.
Base instrument cluster for gasoline engine with standard
measure shown; metric similar
1.Engine oil pressure gauge:Indicates engine oil pressure. The
needle should stay in the normal operating range (between L and H). If
the needle falls below the normal range, stop the vehicle, turn off the
engine and check the engine oil level. Add oil if needed. If the oil level is
correct, have your vehicle checked at your authorized dealer.
2.Engine coolant temperature gauge:Indicates engine coolant
temperature. At normal operating temperature, the needle will be in the
normal range (between H and C).If it enters the red section, the
engine is overheating. Stop the vehicle as soon as safely possible,
switch off the engine and let the engine cool.
WARNING:Never remove the coolant reservoir cap while the
engine is running or hot.
1234
56
Instrument Cluster
29
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
3.Transmission fluid temperature gauge:If the gauge is in the:
Normal areaThe transmission fluid is within the normal operating
temperature (between H and C).
Yellow areaThe transmission fluid is higher than normal operating
temperature. This can be caused by special operation conditions (i.e.
snowplowing, towing or off road use). Refer toSpecial operating
conditionsin thescheduled maintenance informationfor instructions.
Operating the transmission for extended periods of time with the gauge
in the yellow area may cause internal transmission damage.
Altering the severity of the driving conditions is recommended to lower
the transmission temperature into the normal range.
Red areaThe transmission fluid is overheating. Stop the vehicle to allow
the temperature to return to normal range.
If the gauge is operating in the yellow or red area, stop the vehicle and
verify the airflow is not restricted such as snow or debris blocking airflow
through the grill. If the gauge continues to show high temperatures, see
your authorized dealer.
4.Fuel gauge:Indicates approximately how much fuel is left in the fuel
tank (when the ignition is in the on position). The fuel gauge may vary
slightly when the vehicle is in motion or on a grade. The fuel icon and
arrow indicates which side of the vehicle the fuel filler door is located.
Refer toFilling the tankin theMaintenance and Specifications
chapter for more information.
5.Speedometer:Indicates the current vehicle speed.
6.Tachometer:Indicates the engine speed in revolutions per minute.
Driving with your tachometer pointer continuously at the top of the scale
may damage the engine.
Odometer and trip odometer:The odometer is displayed on the lower
line in the message center and registers the total accumulated distance
the vehicle has traveled. For trip odometer, refer toStandard message
centerorOptional message centerin this chapter.
MESSAGE CENTER
The message center monitors many vehicle systems and alerts you to
potential vehicle problems and various conditions with an informational
message followed by a long indicator chime.
The message center display is located in the instrument cluster and the
controls are located on the instrument panel.
Instrument Cluster
30
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
Selectable features
Press INFO repeatedly to cycle through the following features:
Info (information menu)
TRIP A/BRegisters the distance of individual trips. Press
and release INFO until TRIP A/B appears in
the display.
Press RESET to switch between English and
metric. Press and hold RESET for two seconds
to reset the trip odometer.
MILES (km) TO E*•Displays an estimate of how far you can
drive with the fuel remaining in your tank
under normal driving conditions. Remember to
turn the ignition off when refueling to allow
this feature to correctly detect the added fuel.
•DTE is calculated using a running average
fuel economy, which is based on your recent
driving history of 500 miles (800 km). This
value is not the same as the average fuel
economy display. The running average fuel
economy is re-initialized to a factory default
value if the battery is disconnected.
XX.X MPG
(L/100km)Average fuel economy displays average fuel
economy in miles/gallon (liters/100 km).
MPG (L/km)
This displays instantaneous fuel economy as a
bar graph ranging from↓poor economy to↑
excellent economy.
Note:Your vehicle must be moving to
calculate instantaneous fuel economy. When
your vehicle is not moving, this function shows
↓, one or no bars illuminated. Instantaneous
fuel economy cannot be reset.
Instrument Cluster
31
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
Info (information menu)
TIMERTimer displays the trip elapsed drive time.
To operate, do the following:
1. Press and release RESET to start the timer.
2. Press and release RESET to pause the
timer.
3. Press and hold RESET until the timer
resets.
*Available on vehicles with single fuel tank only.
Press SETUP repeatedly to cycle through the following features:
System check and vehicle feature customization
RESET FOR
SYSTEM CHECKWhen this message appears, press RESET and
the message center cycles through different
systems and provides a status if needed.
UNITSDisplays the current units in English or Metric.
Press RESET to switch between English and
Metric.
LANGUAGE =
ENGLISH /
SPANISH / FRENCHDisplays the message center readout in
English, Spanish or French.
Waiting four seconds or pressing RESET
cycles the message center through each of the
choices. Press and hold RESET for two
seconds to set the choice.
Note:When returning to the SETUP menu and a non-English language
has been selected, HOLD RESET FOR ENGLISH is displayed to change
back to English. Press and hold RESET to change back to English.
Instrument Cluster
32
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
System warnings
PARK BRAKE
ENGAGEDDisplays when the parking brake is set, the
engine is running and vehicle speed is higher
than 3 mph (5 km/h). If the message stays on
after the parking brake is released, contact
your authorized dealer as soon as possible.
CHECK BRAKE
SYSTEMDisplays when a fault is detected by the ABS
module.
CHECK CHARGING
SYSTEMDisplays when the electrical system is not
maintaining proper voltage. If you are
operating electrical accessories when the
engine is idling at a low speed, turn off as
many of them as soon as possible. If the
warning stays on or comes on when the engine
is operating at normal speeds, contact your
authorized dealer as soon as possible.
BRAKE FLUID
LEVEL LOWIndicates the brake fluid level is low and the
brake system should be inspected immediately.
Refer toBrake fluidin theMaintenance and
Specificationschapter.
System warnings alert you to possible problems or malfunctions in your
vehicle’s operating systems.
In the event multiple warnings exist, the message center cycles the
display to show each one for four seconds.
The message center displays the last selected feature if there are no
more warning messages.
Types of messages and warnings:
•Some messages appear briefly to inform you of something you may
need to take action on or be informed of.
•Some messages appear once and then again when the vehicle is
restarted.
•Some messages reappear after clearing or being reset if a problem or
condition is still present and needs your attention.
•Some messages can be acknowledged and reset by pressing RESET.
This allows you to use the full message center functionality by clearing
the message.
Instrument Cluster
33
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)
2.(Phone):If your vehicle is
equipped with SYNC, press to
access SYNC PHONE features. For
further information, please refer to yourSYNCsupplement.
If your vehicle is not equipped with SYNC, the display reads NO
PHONE.
3.MENU:Press MENU repeatedly
to access to the following settings:
Setting the clock:Press MENU until SET HOUR or SET MINUTES is
displayed. Use
//SEEK, SEEKto adjust the
hours/minutes.
SATELLITE RADIO MENU (if equipped):Press MENU when satellite
radio mode is active to access. Press OK to enter into the satellite radio
menu. Press
/to cycle through the following options:
•CATEGORY:Press OK to enter category mode. Press
/to
scroll through the list of available SIRIUSchannel Categories (Pop,
Rock, News, etc.) Press OK when the desired category appears in the
display. After a category is selected, press SEEK to search for that
specific category of channels only (i.e. ROCK). You may also select
CATEGORY ALL to seek all available SIRIUScategories and channels.
Press OK to close and return to the main menu.
•SAVE SONG:Press OK to save the currently playing song title in the
system’s memory. (If you try to save something other than a song,
CANT SAVE appears in the display.) When the chosen song is playing
on any satellite radio channel, the system alerts you with an audible
prompt. Press OK while SONG ALERT is in the display and the
system takes you to the channel playing the desired song. You can
save up to 20 song titles. If you attempt to save a song when the
system is full, the display reads REPLACE SONG? Press OK to access
the saved songs and press
/to cycle through the saved songs.
When the song appears in the display that you want to replace, press
OK. SONG REPLACED appears in the display.
Entertainment Systems
37
2012 F-650/750(f67)
Supplement, 2nd Printing
USA(fus)