2012 FORD EXPLORER bulb

4. Rotate the bulb socket
counterclockwise and remove it
from the lamp assembly.
5. Pull the bulb straight out of the
socket.
Reverse steps to reinstall bulb(s).
Replacing turn/backup lamp bulbs
The turn/backup lamp bulbs are located in the same area of the tail lamp
assembly, one below the other. Follow the same steps to replace these
bulbs:
1. Make sure the headlamp switch is
in the off position, then open the
liftgate to expose the lamp assembly
bolts.
2. Remove the two bolts covers
using a standard flat tip screwdriver.
3. Remove the two bolts from the
lamp assembly.
4. Carefully remove the lamp
assembly away from the vehicle by
pulling the assembly straight out to expose the bulb socket.
Lights
83
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

5. Disconnect the electrical
connector (1) from the lamp
assembly. Disconnect the bulb
socket (2) from the lamp assembly
by squeezing the two tabs at the top
and bottom of the socket.
6. Pull bulb straight out of socket and install the new bulb.
7. Install the bulb socket (2) by pushing it directly into the lamp
assembly until the top and bottom tabs snap into place. Reconnect the
electrical connector
8. Carefully install the tail lamp assembly on the vehicle by securing the
lamp assembly with two bolts. Reinstall bolt covers.
Replacing tail/brake lamp bulbs
For bulb replacement, see your authorized dealer.
2
1
Lights
84
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

Replacing fog lamp bulbs
1. Make sure the headlamp switch is
off.
2. Remove the bulb socket from the
fog lamp by turning it
counterclockwise.
3. Disconnect the electrical
connector.
Reverse steps to reinstall bulb(s).
Replacing license plate lamp bulb
1. Carefully release the spring clip
(1).
2. Remove the lamp (2).
3. Remove the bulb (3).
Reverse steps to reinstall bulb.
Replacing high-mount brake lamp bulb
Your vehicle is equipped with an LED center high-mount stop lamp
located in the spoiler. It is designed to last the life of the vehicle. If
replacement is required, see your authorized dealer.
3
2
1
Lights
85
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly closing the fuel fill inlet or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the service engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If the service engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with the service engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the service engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If the service engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer toOn-board
diagnostics (OBD-II)in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If the service engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if the service engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Maintenance and Specifications
394
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

idle speed control ...................373
lubrication specifications .......402
refill capacities ........................402
service points ..................366, 368
Engine block heater .................270
Engine oil ..................................370
checking and adding ..............370
dipstick ....................................370
filter, specifications ................401
refill capacities ........................402
specifications ..........................402
Event data recording ....................7
Exhaust fumes ..........................270
F
Fail safe cooling ........................381
Fleet MyKey programming ......127
Floor mats .........................117–118
Fluid capacities .........................402
Fog lamps ....................................72
Four-Wheel Drive vehicles
driving off road .......................313
preparing to drive your
vehicle .....................................283
Fuel ............................................383
calculating fuel economy .......389
cap ...........................................385
capacity ...................................402
choosing the right fuel ...........386
detergent in fuel .....................388
filler funnel .............................388
filling your vehicle with
fuel ...........................383, 385, 389
filter, specifications ........383, 401
fuel pump shut-off ..................324
improving fuel economy ........389
octane rating ...........................405
quality ......................................387running out of fuel .........342, 388
safety information relating to
automotive fuels .....................383
Fuses ..................................324–325
G
Garage door opener ..................111
Gas cap (see Fuel cap) ............385
Gas mileage
(see Fuel economy) .................389
Gauges .........................................19
H
Hazard flashers .........................323
Headlamps ...................................71
aiming ........................................74
autolamp system .......................71
bulb specifications ....................79
daytime running lights .............73
flash to pass ..............................73
high beam .................................72
turning on and off ....................71
Heating
heating and air conditioning
system ...........................60, 63, 65
Hill descent mode .....................280
Hill start assist ..........................290
Hood ..........................................365
I
Ignition ...............................264, 405
Illuminated visor mirror .............89
Infant seats
(see Safety seats) .....................212
Index
435
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)

Inspection/maintenance (I/M)
testing ........................................394
Instrument panel
cleaning ...................................360
cluster ........................................12
lighting up panel and
interior .......................................73
Intelligent Access Key ..............126
Intelligent Access with push
button start ...............................137
J
Jack ............................................334
positioning ...............................334
storage .....................................334
Jump-starting your vehicle ......343
K
Keyless entry system
autolock ...................................134
keypad .....................................146
locking and unlocking doors ..147
programming entry code .......146
Keys ...................................126, 148
positions of the ignition .........264
L
Lamps
autolamp system .......................71
bulb replacement
specifications chart ............78–79
daytime running light ...............73
fog lamps ...................................72
headlamps .................................71
headlamps, flash to pass ..........73
instrument panel, dimming .....73
interior lamps ...........................77
LATCH anchors .........................218Liftgate ......................119–120, 139
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........273
Loading instructions .................257
Load limits .................................251
Locks
autolock ...................................134
childproof ................................136
doors ........................................133
Lubricant specifications ...........402
Luggage rack .............................124
Lug nuts ....................................342
Lumbar support, seats .....157, 159
M
Message center .....................22, 26
warning messages ...............26, 36
Mirrors ...................................94–95
automatic dimming rearview
mirror ........................................95
fold away ...................................96
heated ........................................96
programmable memory ..........139
side view mirrors (power) .......95
signal .........................................97
Moon roof ..................................110
Motorcraftparts ..............363, 401
MyFord Connect™ system ........59
MyFord Touch™ system ............59
MyFord™ system ..................48, 59
MyKey ........................................127
O
Oil (see Engine oil) ..................370
Overdrive ...................................285
Index
436
2012 Explorer(exp)
Owners Guide, 1st Printing
USA(fus)