1. Drive the vehicle 20 miles (30 km) or until it reaches normal operating
temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer toIdentifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be in
the operating range for normal operating temperature.
Low fluid level
Do not drive the vehicle if the fluid
level is at the bottom of the dipstick
and the outside temperatures are
above 50°F (10°C).
Correct fluid level
The transmission fluid should be checked at normal operating
temperatures 185°F-200°F (85°C-93°C) on a level surface. The normal
operating temperature can be reached after approximately 20 miles
(30 km) of driving.
The transmission fluid should be in
the zone, identified by the arrow in
this figure, if at normal operating
temperature 185°F-200°F
(85°C-93°C).
High fluid level
Fluid levels above the zone,
identified by the arrows in this
figure, may result in transmission
failure. An overfill condition of
transmission fluid may cause shift
and/or engagement concerns and/or possible damage.
High fluid levels can be caused by an overheating condition.
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
Maintenance and Specifications
317
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
Checking and adding manual transmission fluid (if equipped)
1. Park the vehicle on a level
surface.
2. Engage the parking brake fully –
put in first gear.
3. Ensure the vehicle cannot move.
4. Clean the filler plug.
5. Remove the filler plug, located on
the lower, forward driver side of the
transmission, and inspect the fluid
level.
6. Fluid level should be at bottom of the opening.
7. Add enough fluid through the filler opening so that the fluid level is at
the bottom of the opening.
8. Install and tighten the fill plug securely.
Use only fluid that meets Ford specifications. Refer to theMaintenance
product specifications and capacitiessection in this chapter.
AIR FILTER
Refer toscheduled maintenance informationfor the appropriate
intervals for changing the air filter element.
When changing the air filter element, use only the air filter element
listed. Refer toMotorcraftpart numbersin this chapter.
WARNING:To reduce the risk of vehicle damage and/or
personal burn injuries do not start your engine with the air
cleaner removed and do not remove it while the engine is running.
Maintenance and Specifications
319
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
Item CapacityFord part name or
equivalentFord part number /
Ford Specification
Windshield washer fluid Fill as requiredMotorcraftPremium
Windshield Washer
Concentrate (US)
Premium Quality
Windshield Washer Fluid
(Canada)ZC-32-A (US)
CXC-37-(A, B, D, and F)
(Canada) /
WSB-M8B16-A2/- -
Fuel tank17.5 gallons
(66.2L)——
1Add the coolant type originally equipped in your vehicle.2Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the
requirements of Ford specification WSS-M2C945-A and the API Certification mark.3The power transfer unit is lubricated for life with synthetic lube. Lubricant levels are not to be
checked or changed unless a leak is suspected or repair required. Replace power transfer unit
lubricant with specified synthetic lubricant anytime the unit is submerged in water.4Fill to 1/4 inch to 9/16 inch (6 mm to 14 mm) below bottom of fill hole.54X4 vehicles exposed for prolonged periods to temperatures less than -40°F (-40°C) should
change out the rear axle fluid to MotorcraftSAE 75W-140 Synthetic Rear Axle Lubricant, Ford
part number XY-75W140-QL meeting Ford specification WSL-M2C192-A.6Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and
if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set
by the indication on the dipstick’s normal operating range.7Automatic transmissions that require MERCONLV should only use MERCONLV fluid. Refer to
scheduled maintenance informationto determine the correct service interval. Use of any fluid
other than the recommended fluid may cause transmission damage.8Service refill capacity is determined by filling the transmission to the bottom of the filler hole with
the vehicle on a level surface.
Maintenance and Specifications
326
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
The Vehicle Identification Number (VIN) contains the following
information:
1. World manufacturer identifier
2. Brake system / Gross Vehicle
Weight Rating (GVWR) / Restraint
Devices and their location
3. Make, vehicle line, series, body
type
4. Engine type
5. Check digit
6. Model year
7. Assembly plant
8. Production sequence number
TRANSMISSION CODE DESIGNATIONS
You can find a transmission code on
the Safety Compliance Certification
Label. The following table tells you
which transmission each code
represents.
Description Code
Five-speed manual 3
Six-speed automatic 6
Maintenance and Specifications
329
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
Owner checks and services
Certain basic maintenance checks and inspections should be performed
by the owner or a service technician at the intervals indicated. Service
information and supporting specifications are provided in this owner’s
guide.
Any adverse condition should be brought to the attention of your dealer
or qualified service technician as soon as possible for the proper service
advice. The owner maintenance service checks are generally not covered
by warranties so you may be charged for labor, parts or fluids used.
Engine oil/coolant change intervals
Engine oilAs indicated by the message center: do not
exceed one year or 10,000 miles (16,000 km)
Engine coolant,
initial change6 years or 100,000 miles (160,000 km)
(whichever comes first)
Engine coolant, after
initial changeEvery 3 years or 50,000 miles (80,000 km)
Check every month
Engine oil level
Function of all interior and exterior lights
Tires for wear and proper pressure, including spare
Windshield washer fluid level
Check every six months
Battery connections; clean if necessary
Body and door drain holes for obstructions; clean if necessary
Cooling system fluid level and coolant strength
Door weatherstrips for wear; lubricate if necessary
Hinges/latches/outside locks for proper operation; lubricate if necessary
Parking brake for proper operation
Safety belts and seat latches for wear and function
Safety warning lamps (brake, ABS, airbag, safety belt) for operation
Washer spray/wiper operation; clean or replace blades as necessary
Scheduled Maintenance
339
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
Multi-point inspection
In order to keep your vehicle running right, it is important to have the
systems on your vehicle checked regularly. This can help identify
potential issues and prevent major problems. Ford Motor Company
recommends the following multi-point inspection be performed at every
scheduled maintenance interval to help ensure your vehicle keeps
running great.
Multi-point inspection – Recommended each visit
Accessory drive belt(s) Half-shaft dust boots (if equipped)
Battery performance Horn operation
Clutch operation (if equipped) Radiator, cooler, heater and A/C hoses
Engine air filter Suspension component for leaks or
damage
Exhaust system Steering and linkage
Exterior lamps and hazard
warning system operationTires for wear and proper pressure,
including spare
Fluid levels*; fill if necessary Windshield for cracks, chips or pits
For oil and fluid leaks Washer spray and wiper operation
*Brake, coolant recovery reservoir, manual and automatic transmission
(with an underhood dipstick), power steering (if equipped) and
window washer
Be sure to ask your dealership service advisor or technician about the
multi-point vehicle inspection. It’s a comprehensive way to perform a
thorough inspection of your vehicle. It’s your checklist that gives you
immediate feedback on the overall condition of your vehicle. You’ll know
what’s been checked, what’s okay, as well as those things that may
require future or immediate attention. The multi-point vehicle inspection
is one more way to keep your vehicle running great!
Scheduled Maintenance
340
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
A
Accessory delay ..........................72
Active Park Assist .....................232
AdvanceTrac ..............................215
Airbag supplemental restraint
system ........................138, 147, 150
and child safety seats ............140
description ..............138, 147, 150
disposal ....................................153
driver airbag ............140, 148, 151
indicator light .........146, 149, 153
operation .................140, 148, 151
passenger airbag .....140, 148, 151
side airbag ...............................147
Air cleaner filter .......319, 321, 323
Air conditioning
automatic temperature
control system ..........................49
manual heating and air
conditioning system .................46
All Wheel Drive (AWD),
driving off road .........................238
Ambient mood/lighting ...............59
Ambulance packages ....................6
AM/FM .........................................28
Antifreeze
(see Engine coolant) ................297
Anti-lock brake system
(see Brakes) ..............................213
Anti-theft system ......................108
Audio system (see Radio) .........28
Automatic transmission ............224
driving an automatic
overdrive .................................224
fluid, refill capacities ..............324
fluid, specification ..................324Auxiliary input jack (Line in) ....37
Auxiliary power point .................70
Axle
lubricant specifications ..........324
refill capacities ........................324
B
Battery .......................................295
acid, treating emergencies .....295
jumping a disabled battery ....265
maintenance-free ....................295
replacement, specifications ...323
servicing ..................................295
Belt-Minder.............................134
Blind spot mirror ......................237
Booster seats .............................168
Brakes ................................212–213
anti-lock ...................................213
anti-lock brake system (ABS)
warning light ...........................213
fluid, checking and adding ....316
fluid, refill capacities ..............324
fluid, specifications .................324
lubricant specifications ..........324
parking ....................................214
shift interlock ..........................222
Bulbs ............................................59
C
Capacities for refilling fluids ....324
Car2UHome Automation
System .........................................79
Cargo area shade ........................88
Cargo management system ........88
CD ................................................28
Cell phone use ..............................9
Index
355
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)
Changing a tire .........................254
Child safety seats ......................158
attaching with tether straps ..165
in front seat ............................159
in rear seat ..............................159
LATCH .....................................162
recommendations ...................156
Child safety seats - booster
seats ...........................................168
Cleaning your vehicle
engine compartment ..............279
instrument panel ....................282
interior .....................................283
plastic parts ............................281
washing ....................................278
waxing .....................................278
wheels ......................................279
wiper blades ............................281
Climate control (see Air
conditioning or Heating) ......46, 49
Clock ............................................28
Clutch
fluid ..........................................316
operation while driving ..........226
recommended shift speeds ....227
Compass, electronic ....................68
calibration .................................69
set zone adjustment .................68
Console ........................................69
overhead ....................................67
Controls
power seat ...............................116
steering column ........................76
Coolant
checking and adding ..............297
refill capacities ................300, 324
specifications ..........................324Cruise control
(see Speed control) ....................74
Customer Assistance ................245
Ford Extended Service
Plan ..................................332, 335
Getting assistance outside
the U.S. and Canada ..............274
Getting roadside assistance ...245
Getting the service you
need .........................................270
Ordering additional owner’s
literature .................................276
Utilizing the
Mediation/Arbitration
Program ...................................274
D
Daytime running lamps
(see Lamps) ................................55
Dipstick
automatic transmission
fluid ..........................................316
engine oil .................................291
Driving under special
conditions ..................226, 239, 242
sand .........................................240
snow and ice ...........................243
through water .................241, 244
E
Electronic message center .........20
Emergencies, roadside
jump-starting ..........................265
running out of fuel .........264, 308
Emergency Flashers .................246
Emission control system ..........313
Engine ........................................327
cleaning ...................................279
Index
356
2012 Escape(204)
Owners Guide, 1st Printing
USA(fus)