2012 FIAT IDEA fuses

144
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
WHEN NEEDING TO
CHANGE A BULB
GENERAL INSTRUCTIONS
❒When a light is not working, check
that it has not fused before changing
the bulb. For the location of the fuses,
refer to “If a fuse blows” in this chap-
ter;
❒Before replacing a bulb that does not
work, check that the contacts are not
oxidised;
❒Burnt bulbs must be replaced by oth-
ers of the same type and power;
❒Always check the height of the head-
light beam after changing a bulb. For versions with alloy rims
❒Make sure that hub contact surfaces
are clean;
❒Refit the standard wheel fitting it on
the pins, refit the fastening bolts and
tighten them using the wrench pro-
vided;
❒Lower the car and remove the jack;
❒Using the wrench provided, tighten
the bolts in the sequence shown pre-
viously for the space-saver spare
wheel fig. 16;
❒Refit the snap-fitted wheel hub cap.
When you have finished
❒Stow the spare wheel C-fig. 11in the
space provided in the boot;
❒Insert the jack partially open in its con-
tainer B-fig. 11forcing it lightly to
prevent it from vibrating when trav-
elling;
❒Put the tools back into their places in
the container;
❒Stow the container complete with
tools on the spare wheel and secure
everything with the clamping device
A-fig. 11;
❒Correctly re-position the stiff cover.
Modifications or repairs to
the electrical system carried
out incorrectly and without bearing
the features of the system in mind can
cause malfunctions with the risk of
fire.
WARNING
Halogen bulbs contain pres-
surised gas which, if broken,
may cause small fragments of glass to
be projected outwards.
WARNING
Only touch the metal part
when handling halogen bulbs.
If the transparent bulb is
touched it reduces the intesi-
ty of the light emitted and can also re-
duce the life of the bulb. If you touch
the bulb accidentally, rub it with a
cloth moistened with alcohol and leave
it to dry.
IMPORTANT The headlight inner surface
may be lightly misted over: this is not a
fault but a natural fact due to low tem-
perature and the level of air humidity. It
will disappear as soon the headlights are
turned on. The presence of drops inside
the headlights means water infiltration,
therefore contact Fiat Dealership.
133-160 idea GB 1 ed 10-07-2008 8:30 Pagina 144

154
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
F0H0720m
FUSE LOCATION
Fuses are grouped into two fuse boxes to
be found respectively on the left side of
the dashboard and in the engine com-
partment near the battery.Fuse box on the dashboard
To gain access to the fuses in the control
box on the dashboard fig. 38, remove the
protective trim A-fig. 39-40.
fig. 39 - Left-hand drive versionsF0H0719m
fig. 40 - Right-hand drive versionsF0H0198m
fig. 38
133-160 idea GB 1 ed 10-07-2008 8:30 Pagina 154

155
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
F0H0720mfig. 42 fig. 41
F0H0201m
Fuse box near the battery
To gain access to the fuses fig. 42in the
fusebox on the battery post, remove the
protective cover B - fig. 41.
133-160 idea GB 1 ed 10-07-2008 8:30 Pagina 155

201
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
DASHBOARD
AND CONTROLS
INDEX
Dipped beam headlights
– bulb replacement ................. 148
– control .................................. 59
Direction indicators ................. 59
– bulb replacement ................. 148
– control .................................. 59
Door pockets ............................. 69
Doors ........................................ 17-134
Emergency device for locking
doors from the outside ...... 17-134
Dualdrive
(electric power steering) ...... 87
EBD (electronic brake force
distributor) ................................. 83
Emergency device for locking
doors from the outside ......... 17
Engine
– fuel feed ................................. 187
– identification code ............... 184
– injection/ignition ................. 187– technical data ....................... 185
Engine coolant gauge................. 19
Engine coolant level ................ 170
Engine oil
– checking level........................ 169
– consumption ......................... 169
– technical specifications ....... 195
EOBD (system) ......................... 84
External lights ............................. 58
Fiat CODE (system) ............... 9
Fix &Go (tyre repair kit) ......... 136
Flashing the headlights ............. 58
Fluids and lubricants ................ 196
Follow me home (device) ....... 59
FPS (fuel cut-off switch) .......... 67
Front fog lights
– bulb replacement ................. 149
– control button ...................... 66Fuel
– consumption ......................... 198
– fuel cut-off switch ................ 67
– level gauge ............................ 19
Fuel cut-off switch ..................... 67
Fuel filler cap............................... 91
Fuses ............................................. 153
Gearbox (use). .......................... 115
Glass/can holders ....................... 69
Handbrake ................................. 114
Hazard lights
– control .................................. 66
Head restraints ......................... 41
Headlights ................................... 82
(electric adjusting device) ..... 82
Heated rear window ............... 44
Heating and ventilation............. 45
Identification data .................... 182
Ignition switch ........................... 18
200-208 idea GB 1 ed 10-07-2008 10:58 Pagina 201