2012 FIAT DUCATO Seat

38
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0229mfig. 35
Stacked position
Proceed as follows:
– remove the head restraints from the easy entry
position;
– raise txhe lever B-fig. 35 (located beneath the lever
A-fig. 34) with your right hand;
– turn the backrest 5° to the rear;
– fold the backrest forward with your left hand.
F0N0228mfig. 34
Tilting middle seat backrest
(2nd–3rdrow) fig. 33
Lift the lever C and fold the backrest forwards.
A hard surface on the back of the middle seat is for use
as an armrest and table with cup holders.
Operate the lever to reposition the backrest.
To lower the backrest of the middle seat in the second
row, remove the head restraint to make it easier to
adjust the backrest of the middle seat in the first row.
COMBI VERSIONS
Easy Entry position
Lift lever A-fig. 34 and tilt the backrest forwards.

39
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0230mfig. 36
Do not travel with passengers seated in
the 3rdrow with the 2ndrow bench
folded over. Do not place objects of any type
on the backrest of the 2
ndbench with the row
folded over: in the event of impact or sharp
braking they could be thrown against the
occupants of the vehicle casing serious injury.
For more information, see the contents of the
adhesive plate located under the bench.
WARNING
Removing the bench
IMPORTANT At least two people must be present to
remove the bench.
F0N0231mfig. 37
Proceed as follows to remove the bench:
– from the stacked position, operate levers C and
D-fig. 36 , turning them forward (as specified on the
adhesive plate located on the lower crossmember);
– lift seat base forward;
– bring the seat to an upright position;
– from the upright position, operate the levers E and
F-fig. 37, turning them upward;
– raise the bench from the floor and remove it.
When refitting the bench, ensure it is
correctly locked to the floor guides.
WARNING

45
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 44
F0N0322m
HEATING AND VENTILATION SYSTEM
1. Upper fixed vent – 2. Adjustable centre vents – 3. Fixed side vent – 4. Adjustable side vents – 5. Lower vents for
front seats.

48
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0500mfig. 48
Window demisting
In the event of considerable external moisture and/or rain
and/or large differences in temperature inside and outside
the passenger compartment, perform the following
preventive window demisting procedure:
❒turn the ring nut A to the red section;
❒switch off the air recirculation by turning the knob D
to
Ú;
❒turn the ring nut C to -or to ®if the windows
do not demist;
❒turn the knob B to the 2ndspeed.
HEATED REAR WINDSCREEN AND DOOR
MIRRORS DEMISTING/DEFROSTING fig. 49
(for versions/markets where provided)
Press the button A to activate this function; when this
function is on the warning light in the button comes on.
This function is timed and will turn off automatically
after 20 minutes. Press the button A again to switch the
function off.
IMPORTANT Do not apply stickers to the inside of the
rear window over the heating filaments to avoid damage
that might cause it to stop working properly. FRONT WINDOW FAST
DEMISTING/DEFROSTING (WINDSCREEN
AND SIDE WINDOWS)
Proceed as follows:
❒turn the ring nut A to the red section;
❒switch off the air recirculation by turning the knob D
to
Ú;
❒turn the ring nut C to -;
❒turn the knob B to 4 -(max. fan speed).
IMPORTANT To ensure fast demisting/defrosting,
if a supplementary heater is present (under the front or
rear seat for Panorama and Combi versions), if on, turn
off using button F (LED off) located on the control panel
fig. 48.
After demisting/defrosting, operate the controls to
restore the required comfort conditions.

52
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0500mfig. 51
Window demisting
In the event of considerable external moisture and/or rain
and/or large differences in temperature inside and outside
the passenger compartment, perform the following
preventive window demisting procedure:
❒turn the ring nut A to the red section;
❒switch off the air recirculation by turning the knob D
to
Ú;
❒turn the ring nut C to -or to ®if the windows
do not demist;
❒turn the knob B to the 2ndspeed.
IMPORTANT The climate control system is very useful
for preventing the windows misting up in presence of
high humidity since it dehumidifies the air introduced
into the passenger compartment. IMPORTANT to ensure fast demisting/defrosting, if an
additional heater/air conditioner is present (under the
front or rear seat on Panorama and Combi versions),
if it is activated, turn it off using the button F (LED off)
located on the control panel fig. 51.
After demisting/defrosting, operate the controls to
restore the required comfort conditions.
IMPORTANT The climate control system is very useful
for speeding up the demisting because it dehumidifies the
air. Adjust the controls as described above and press the
button E to switch the climate control system on; the
LED in the button will light up.

60
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
IMPORTANT To ensure rapid demisting/defrosting,
if there is an additional heater/air conditioner (under the
front or rear seat on Panorama and Combi versions),
if activated, deactivate it by pressing button F (LED off)
located on the control panel fig. 54.
Switching off the system OFF (E)
The climate control system is switched
off by pressing button E and
the display switches off as a result.
The following climate control conditions will be present
when the system is off:
❒display off;
❒set temperature not shown;
❒air recirculation on, passenger compartment isolated
from the outside (recirculation LED on);
❒air conditioner compressor off;
❒fan off.
Press the AUTO button to switch the climate control
system back on in full automatic mode.
F0N0500mfig. 54
ADDITIONAL HEATER
(for versions/markets where provided)
On some versions, an additional heater is also present
beneath the driver’s seat. The fan for this heater is
operated by means of the button F located on the
control panel fig. 54.

66
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
IMPORTANT Before switching the device on, check
that the fuel level is higher than the reserve level.
Otherwise the device could lock and require the
assistance of a Fiat Dealership.
❒Always turn off the heater when refuelling and near
service stations to avoid the risk of explosion or fire
hazards.
❒Do not park the vehicle on inflammable material
such as paper, grass or dry leaves: fire hazard!
❒The temperature near the heater should not exceed
120 °C (e.g. during stove painting in a body shop).
The electronic control unit components may be
damaged at higher temperatures.
❒Whilst the heater is operating with the engine
switched off, it absorbs energy from the battery; the
engine should therefore be left running for a while to
make sure that the battery is properly recharged.
❒To check the coolant level, follow the instructions in
the “Vehicle maintenance” chapter in the “Engine
coolant system fluid” paragraph. The water in the
heating circuit must contain a minimum percentage
of 10% antifreeze.
❒For maintenance and repairs, only contact Fiat
Dealerships and only use genuine spare parts.
F0N0233mfig. 61
MAINTENANCE
Have the additional heater checked regularly at a Fiat
Dealership (and always at the start of every winter).
This will guarantee safe and economic operation of the
heater as well as a long duration.
ADDITIONAL REAR HEATING
(Panorama and Combi)
(for versions/markets, where provided)
The Panorama and Combi versions have a main heating
system plus an additional one (on request) with the
controls in the roof lining above the second row of
seats, fig. 61.

67
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
Operation must be enabled using the button F-fig. 62 in
the control panel.
❒Turn the knob D to the maximum cold position (ring
nut at blue sector) and air at ambient temperature
will come out of the rear footwell vents (located
under the seats in the 2
nd–3rdrow for Panorama
versions and the grille on the left wheel arch side for
Combi versions);
❒Turn the knob D to the maximum heating position
(ring nut at red sector) and warm air will emerge
(with the engine warmed up), from the rear footwell
outlets (located under the seats in the 2
nd–3rdrow
for Panorama versions and the grille on the left wheel
arch side for Combi versions).
F0N0500mfig. 62
ADDITIONAL REAR CLIMATE CONTROL
(Panorama and Combi)
(for versions/markets, where provided)
The Panorama and Combi versions are equipped with
a main heating/air conditioning system plus an additional
system (available on request) with controls in the roof
lining above the second row of seats, fig. 61.
Button F-fig. 62 in the control panel must be enabled for
operation; the air conditioning only works if the main air
conditioner is on.
❒When the knob D is placed in the fully cold position
(ring nut in blue sector) cold air comes out of the
vents in the ceiling.
❒Turn the knob D to the maximum heating position
(ring nut at red sector) and warm air will emerge
(with the engine warmed up), from the rear footwell
outlets (located under the seats in the 2
nd–3rdrow
for Panorama versions and the grille on the left
wheel arch side for Combi versions).
❒When the knob D is in an intermediate position, air
will be distributed between the vents in the roof and
the rear footwell outlets to alter the temperature.
IMPORTANT If the compressor on the main air
conditioner control is turned on (operation of button
E), even if the additional air conditioner fan is in position
0, the 1
stspeed will automatically be activated to
prevent ice formation, with possible damage to the
component.