2012 DODGE CHALLENGER SRT clock

SCANbutton again. During Scan mode, pressing the
<< SEEK andSEEK >> buttons will select the previ-
ous and next tracks.
•RND button (available on sales code RES radio only):
Pressing this button toggles between Shuffle ON and
Shuffle OFF modes for the iPod or external USB
device, or press the VR button and say Shuffle ONor
Shuffle Off.IftheRND icon is showing on the radio
display, then the shuffle mode is ON.
List Or Browse Mode
During Play mode, pressing any of the buttons described
below, will bring up List mode. List mode enables
scrolling through the list of menus and tracks on the
audio device.
•TUNE control knob: The TUNEcontrol knob functions
in a similar manner as the scroll wheel on the audio
device or external USB device.
•Turning it clockwise (forward) and counterclock-
wise (backward) scrolls through the lists, displaying
the track detail on the radio display. Once the track
to be played is highlighted on the radio display,
press the TUNEcontrol knob to select and start
playing the track. Turning the TUNEcontrol knob
fast will scroll through the list faster. During fast
scroll, a slight delay in updating the information on
the radio display may be noticeable.
•During all List modes, the iPod displays all lists in
“wrap-around” mode. So if the track is at the
bottom of the list, just turn the wheel backward
(counterclockwise) to get to the track faster.
•In List mode, the radio PRESETbuttons are used as
shortcuts to the following lists on the iPod or
external USB device.
•Preset 1 – Playlists
4
UNDERSTANDING YOUR INSTRUMENT PANEL 235

Removing The Button
1. The ENGINE START/STOP button can be removed
from the ignition switch for key fob use.
2. Insert the metal part of the emergency key under the
chrome bezel at the 6 o’clock position and gently pry the
button loose.
NOTE:The ENGINE START/STOP button should only
be removed or inserted with the ignition in the OFF
position.
Normal Starting
Using The ENGINE START/STOP Button –
Automatic Transmission Only
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal. To start the engine, the transmission must be in PARK or
NEUTRAL. Press and hold the brake pedal while press-
ing the ENGINE START/STOP button once. The system
takes over and attempts to start the vehicle. If the vehicle
fails to start, the starter will disengage automatically after
10 seconds. If you wish to stop the cranking of the engine
prior to the engine starting, press the button again.
Using The ENGINE START/STOP Button –
Manual Transmission Only
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal.
To start the engine, press and hold the clutch pedal while
pressing and holding the ENGINE START/STOP button.
Release the button when the engine starts. If the vehicle
fails to start within 15 seconds, release the button,
wait 10 to 15 seconds, then repeat the “Normal Starting”
258 STARTING AND OPERATING

Front/Rear Side Marker Lamp
1. Remove the front/rear side marker. Use a fiber stick or
similar tool to gently pry the lamp on the outboard side
to disengage the clip.
NOTE:
•If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
2. Rotate the bulb’s socket counterclockwise, and remove
the bulb and socket assembly from the housing.
3. Pull the bulb out of the socket and insert the replace-
ment bulb.
4. Install the bulb and socket assembly into the housing,
and rotate the socket clockwise to lock it in place.
5. Reinstall the front/rear side marker.
Tail/Turn And Stop Lamp
1. Open the trunk.
2. Using a screwdriver, remove the tail lamp retainer.
7
MAINTAINING YOUR VEHICLE 409

3. Remove the fasteners from the back of the tail lamp
assembly.
4. Pull back the trunk liner.
5. Remove the remaining fasteners from the back of the
tail lamp assembly.6. Pull the tail lamp assembly clear from the vehicle to
access the bulbs.
7. Push the electrical connector locking tab to the side.
8. Disconnect the electrical connector.
9. Turn the appropriate bulb and socket assembly coun-
terclockwise to remove it from the tail lamp assembly.
410 MAINTAINING YOUR VEHICLE

10. Disconnect the bulb from the socket assembly and
install the replacement bulb.
11. Reinstall the bulb and socket assembly into the tail
lamp assembly, and then turn it clockwise.
12. Reinstall the tail lamp assembly, fasteners, electrical
connector, and trunk liner.
13. Reinstall tail lamp retainer.14. Close the trunk.
7
MAINTAINING YOUR VEHICLE 411

Brightness, Interior Lights.................. 145
Bulb Replacement ..................... 407,408
Bulbs, Light .......................... 84,407
Calibration, Compass ..................... 200
Capacities, Fluid ........................ 413
Caps, Filler Fuel .............................. 334
Oil (Engine) ........................ 372
Power Steering ...................... 284
Radiator (Coolant Pressure) ............. 386
Car Washes ............................ 394
Carbon Monoxide Warning ...............81,333
Cargo (Vehicle Loading) ................... 335
Cellular Phone ........................ 93,241
Center High Mounted Stop Light ............ 412
Certification Label ....................... 336
Chains, Tire ............................ 317
Chart, Tire Sizing ........................ 302 Check Engine Light
(Malfunction Indicator Light)
............... 368
Checking Your Vehicle For Safety ............. 80
Checks, Safety ........................... 80
Child Restraint .................... 70,72,75,77
Child Restraint Tether Anchors .............74,75
Clean Air Gasoline ....................... 329
Cleaning Wheels ............................ 396
Windshield Wiper Blades ............... 379
Clock ............................. 208,217
Cold Weather Operation ................... 261
Compact Disc (CD) Maintenance ............. 241
Compass .............................. 200
Compass Calibration ..................... 200
Compass Variance ....................... 201
Computer, Trip/Travel .................... 193
450 INDEX

Sentry Key Replacement................... 17
Service Assistance ....................... 439
Service Contract ......................... 441
Service Engine Soon Light
(Malfunction Indicator) .................... 187
Service Manuals ........................ 443
Setting the Clock ..................... 208,217
Settings, Personal ........................ 202
Shift Indicator Light ...................... 266
Shift Lever Override ...................... 359
Shift Speeds ........................... 265
Shift Speeds, Manual Transmission ........... 265
Shifting ............................... 267
Automatic Transmission ................ 267
Short Message Service (SMS) ................ 115
Shoulder Belts ........................... 45
Side Airbag ............................. 64
Side Window Demisters (Defrosters) .......... 248
Signals, Turn ...................... 84,143,180Slippery Surfaces, Driving On
............... 279
Snow Chains (Tire Chains) ................. 317
Snow Tires ............................ 319
Sound System Kicker ............................ 238
Spark Plugs ............................ 414
Specifications Fuel (Gasoline) ...................... 414
Oil ............................... 414
Speed Control (Cruise Control) .............. 150
Speedometer ........................... 178
Sport Mode ............................ 278
Starting ............................. 27,255
Automatic Transmission ................ 256
Cold Weather ....................... 261
Engine Fails to Start .................. 261
Remote ............................ 27
Starting and Operating .................... 255
Starting Procedures ...................... 255
10
INDEX 463