Page 38 of 358

ZEV mode *
(all electric)
Zero emissions vehicle operation is assured10 0 % by electric drive.
This mode forces silent running
at moderate speeds.
It
can be activated when therequired conditions are met, particularly if the state of charge of high voltage battery is sufficient (from 4 bars).
Auto mode
It automatically manages the operation of theDiesel engine and the electric motor, according
to inherent vehicle parameters, traffic conditions and driving style so as to optimise
the vehicle's fuel consumption.
In particular, this mode activates "zero emissions" electric runningwhen theconditions allow.
In auto mode, the electric motor:
- can drive the vehicle on its own up
to around 36 mph (60 km/h) in "zeroemissions" electric running, dependingon the state of charge of the battery, if the conditions specific to the vehicle are met
and if acceleration is moderate,
- supplements the Diesel en
gine
when
moving off and changing gear, duringacceleration and when traction from the front wheels is inadequate (it automatically adds4 wheel drive),
- is no longer active above 70 mph (120 km/h).
*
ZEV: Z
ero Emissions Vehicle.
This standardmode to use in preference
is activated automaticallyon starting the hybrid system.
Page 44 of 358

Automatic restarting of the Diesel engine or ZEV mode NOT available
Maintaining the performance of
the system
- When the vehicle exceeds 18 mph(30 km/h) after moving off (if the internal
combustion engine has not already star ted since the vehicle was last star ted).
- If the high voltage battery is not sufficiently charged. A minimum of 4 barsin ZEV mode so as to ensure operationover a cer tain distance (in AUTO, electricoperation is accessible for a shor ter period with a lower level of charge).
- When the fuel level enters the reservezone (where rate of consumption of this reser ve is high, ZEV inhibition may continue for some time after refuelling).
- During regeneration of the particleemissions filter, which occursautomatically for 5 to 10 minutes,approximately every 300 miles (500 kms)(or less in extended urban running).
The internal combustion engine may restar t or
ZEV mode may not be available in the variousconditions presented below. The internal combustion engine can beswitched off automatically as soon as these
conditions are lifted. When the conditions described below causethe vehicle to come out of ZEV mode andthe Diesel engine to restar t, the vehicle automatically changes to AUTO mode.
Your vehicle is fitted with the most effective emissions control systems, in par ticular the Particle Emissions Filter (PEF).
At regular intervals your Diesel engine will produce energy for the self-cleaning of this filter.During this PEF regeneration phase, electric running is purposely made unavailable.
Action by the driver
- Moving the gear selector to position M
. - Action on steering mounted control paddles to change gear.- Sustained and sharp acceleration. - Use of demisting.- Use of air conditioning.
Diffi cult weather conditions and
circumstances
- If cer tain conditions or engine temperature requirements make it necessary (such as
an engine temperature that is too low for the ambient conditions).
- When the battery is close to maximumcharge (for example: when going down a long hill), because engine recoverybeing no longer possible, the internalcombustion engine restar ts automatically just to provide engine braking.
- If the vehicle encounters a steep slope(car park ramp, ...).
- If the vehicle has been parked in the sunfor a prolonged period.
- When driving in mountainous conditions(altitude).
Page 46 of 358

Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2emissions.
Optimise the use of your
gearbox
Use automated mode A
as much as possible
as this optimises gear changes to suit thecircumstances.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather than the brake pedal, and press the accelerator progressively. These practices contribute towards a reduction in fuel consumption and CO2 emissions and also helps reduce the
background traffic noise.
If your vehicle has cruise control, make use of the system at speeds above 25 mph (40 km/h) when the traffic is flowing well.
Before moving off, if the passenger compartment is too warm, ventilate it byopening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents open.
Remember to make use of equipment that canhelp keep the temperature in the passenger compartment down (sun roof and windowblinds...). Switch off the air conditioning, unless it has automatic digital regulation, as soon as thedesired temperature is attained. Switch off the demisting and defrostingcontrols, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglampswhen the level of light does not require their use.
Avoid running the Diesel engine when stationary, par ticularly in winter; your vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices (film, music, videogame...), you will contribute towards limitingthe consumption of electrical energy, and soof fuel.
Disconnect your por table devices beforeleaving the vehicle.
Control the use of your electrical equipment
Page 47 of 358

45
Hybrid system
Limit the causes of excess
consumption
Spread loads throughout the vehicle; place the heaviest items in the bottom of the boot,as close as possible to the rear seats.Limit the loads carried in the vehicle and reduce wind resistance (roof bars, roof rack, bicycle carrier, trailer...). Use a roof box inpreference.Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly, when cold, referring to the label in the door aper ture, driver's side.Carry out this check in par ticular:- before a long journey,- at each change of season,- after a long period out of use.
Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) and obser ve the schedule of operations recommended by the manufacturer.
When refuelling, do not continue after the3 rd
cut-off of the nozzle to avoid any over flow.
At the wheel of your new vehicle, it is only after the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settledown to a consistent average.
Page 51 of 358

49Hybrid system
The high voltage battery must not in anycircumstances be charged from an externalsource and must only be handled by a
workshop technician.
There is the risk o
f serious burns, as well as electric arcs that could cause serious injury or
even death.
A used Ni-MH (Nickel Metal Hydride) type
high voltage battery must be removed in an
appropriate manner by a repair workshop,so that its recycling presents no risk to the environment.
High voltage
The voltage used for the operation of theelectric motor is in the range 150 to 270 Volts.
Be sure to take account of the warning labels
fitted to the vehicle.
Ta k e great care regarding the high voltage and high temperatures of components carrying thecurrent.
Emergency cut-off
In the event of an accident, a cut-off system
blocks the high voltage current and cuts off
the fuel pump; your vehicle can no longer be started.To restar t the hybrid system, contact aCITROËN dealer.
High voltage cables are routed under the
vehicle
(sills); take care not to damage them
when the vehicle is used for off-road activity(such as covering rough ground).
Be
fore doing any work on
the vehicle, switch off the
ignition (Readylamp off). y
Battery precautions
Hi
gh voltage cables
Take care to position lifting equipment (jack, hoist, ...) at the locations provided to avoid damaging the cables.
Never touch, dismantle, remove or replace the high voltage par ts, orangecables or connectors, even in the eventof an accident.
Page 52 of 358
Underbonnet precautions / warnings
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Alwa
ys ensure that theignition is switched off ( Readylamp off) before
opening the bonnet.
Also ensure that the ignition is switchedoff when refuelling to avoid the enginerestarting.
Page 56 of 358
Instrument panel
1.
Energy consumption / generation indicator (available power as a percentage).
For more information refer to the "H
ybrid
system" section.2. Fuel gauge.3.Engine coolant temperaturegauge.4.
Speedometer (mph or km/h).5.
Cruise control or speed limiter
settings.A
.Main lighting and controls dimmer.
B.- Successive shor t presses: under-inflation
detection, recall servicin
g information, alert log.
- Long press: reset the function selected to
zero (service indicator or trip recorder). 6
. Gear engaged.
7.Instrument panel screen: electrical flow,
trip recorder, aler t messa
ges or state of functions (e.g.: oil pressure, battery, door open, ...), trip computer, media, satellite
navigation.8. Digital speedometer (mph orkm/h).9.Ready lamp: indicates that the vehicle is
ready to drive.
Dials and screens
Control buttons
Page 64 of 358

Warning / indicator lampStateCauseAction / Observations
Dynamic stability control(DSC/ASR)
flashing. The DSC/ASR regulation is
operating. The system optimises traction and improves the
directional stability of the vehicle.
fixed. Unless it has been deactivated(button pressed and its indicator lamp
on) the DSC/ASR system has a fault.Have it checked b
y a CITROËN or a qualified
workshop.
Engine autodiagnosis system
flashing.The engine management system hasa fault. Risk of destruction of the catalytic conver ter.
Have it checked by a CITROËN dealer or a qualified
workshop.
fixed. The emission control system has afault. The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or
qualified workshop without delay.
Low fuel levelfixed with the two last
bars flashing.When it first comes on there remainsapproximately 6 litres offfuelin thetank.You must re
fuel as soon as possible to avoid runningout of fuel.This warning lamp will come on every time the ignition
is switched on, until a sufficient addition of fuel is made.
Fuel tank capacit
y: approximately 60 litres.
Never continue to drive until you run out of fuel as
this could damage the emission control and injectionsystems.
Anti-lock
Braking System(ABS)
fixed. The anti-lock braking system has a
f
ault. The vehicle retains conventional brakin
g.
Drive carefull
y at reduced speed and contact a CITROËN dealer or a qualified workshop without delay.