Page 44 of 396
Approaching the maximum engine speed,
the bars are displayed in red and flash,
to indicate to you the need to change up a gear.
Rev counter
Choice of sounds
This menu allows you to choose a family of polyphonic sounds from the four available.
These sounds are grouped together in a familyand are adapted to suit the situation andcontext (alert, confirmation, rejection, direction
indicators, lighting left on, key in ignition...).
Display confi guration
This menu is used to configure:
- the display language of the central screen,
from a pre-defined list,
- the units: temperature
(°Celsius or °Fahrenheit) and fuel consumption(l/100 km, mpg or km/l),
- the graphical presentation of the central
screen, from a pre-defined list.
Page 76 of 396

A few definitions…
This value may vary following a changein the style of driving or the relief,resulting in a significant change in thecurrent fuel consumption.
If dashes are displayed continuously while driving in place of the digits, contact a CITROËN dealer or a qualified workshop.
This function is only displayed from 20 mph (30 km/h).
The fuel consumption of your vehicle will be higher than the official figures obtainedby CITROËN during the first 3 000 miles(5 000 km) of the vehicle's life.
Range
(miles or km)This indicates the distancewhich can still be travelled with the fuelremaining in the tank in relation to the average
fuel consumption over the last few miles(kilometres) travelled.
When the ran
ge falls below 20 miles (30 km),
dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (10 0 km).
Current fuelconsumption
(mpg or l/100 km or km/l)
This is the average fuel consumption during the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
This is the average fuel consumption since the last trip computer zero reset.
Average speed
(mph or km/h)This is the average speed calculatedsince the last trip computer zero reset (ignition on).
Distance travelled
(miles or km)This indicates the distancetravelled since the last trip computer zero reset.
Stop & Start time counter
(minutes/seconds or hours/minutes)
If your vehicle is fitted with Stop & Star t, a timecounter calculates the time spent in STOP mode during a journey.
It resets to zero every time the ignition isswitched on with the key.
Page 219 of 396

217Driving
Lane departure warning system
System which detects the involuntary crossing
of longitudinal traffic lane markings on the ground (solid or broken line).
Sensors, fitted below the front bumper, trigger a
warning if the vehicle drifts over a lane marking (speed higher than 50 mph (80 km/h)).
This system is par ticularly useful on motor waysand main roads.
Activation
)Press this button, the indicator lamp comes on.
The lane depar ture warning systemcannot, in any circumstances, replacethe need for vigilance and responsibility on the par t of the driver.
Deactivation
You are warned by the vibration of the driver's seat cushion:
- on the right-hand side, if the marking on theground has been crossed on the right,
- on the left-hand side, if the marking on the ground has been crossed on the left.
No warning is transmitted while the direction indicator is active and for approximately 20 seconds after the direction indicator is
switched off.
A warning may be transmitted if a direction
marking (e.g. arrow) or non-standard marking(e.g. graffiti) is crossed.
Detection
Operatin
g fault
The detection may be impeded:
- if the sensors are dir ty (mud, snow...),
- if the markings on the ground are worn,
- if there is little contrast between themarkings on the ground and the road surface.
)
Press this button again, the indicator lampgoes off.
The status of the system remains in the
memory when the ignition is switched off. In the event of a malfunction,
the ser vice warnin
g lamp comes
on, accompanied by an audible signal and a message in the screen.
Contact a CITROËN dealer or a qualified
workshop.