2012 Citroen DS4 lock

Deactivate the interior volumetric and anti-tilt
monitoring to avoid unwanted triggering of thealarm in certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle,
- changing a wheel,
- havin
g your vehicle towed,
- transpor t by sea.
Locking the vehicle
with exterior
perimeter
monitoring only

Deactivation of the interior volumetric and anti-tiltmonitoring
)
Switch off the ignition. )
Within ten seconds, press the button until
the indicator lamp is on continuously. ) Get out of the vehicle. )
Press the locking button on the remotecontrol immediately.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button flashes once per second.
To be effective, this deactivation must be carried out each time the ignition isswitched off.


Reactivation of the interior volumetric and anti-tilt monitoring
)Press the unlocking button on the remotecontrol to deactivate the exterior perimeter monitoring.)Press the locking button on the remote control to activate all the monitoringfunctions.
The indicator lamp in the button again flashes
once per second.

111Access

Tr iggering of the alarm


This is indicated by sounding of the siren and
flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times insuccession.
When the vehicle is unlocked using the remote control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.

Failure of the remote control
To deactivate the monitoring functions:
Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key
in the driver's door lock.

)
unlock the vehicle using the key in the
driver's door lock,
) open the door; the alarm is triggered,)
switch on the ignition; the alarm stops;the indicator lamp in the button goes off.


Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the s
ystem.
Have it checked by a CITROËN dealer or a qualified workshop.

Doors
Opening
From out side
)After unlocking the vehicle completely using the remote control or the key, pull the door handle.





From inside
)
Pull the interior control lever of a front door;
this unlocks the vehicle completely.

Closing

When a door is not closed correctly:


-
when the engine is running,this warning lamp comes
on, accompanied by an aler t
message for a few seconds,
-when the vehicle is moving(speedhigher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an alert message for a few seconds.

When the selective unlocking isactivated, the first press of the remotecontrol unlocking button permitsunlocking of the driver's door only.
With the selective unlocking activated:- opening the the driver's door unlocks the driver's door only (if thevehicle has not already beencompletely unlocked).- opening one of the passenger doors unlocks the rest of thevehicle.

113Access
System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
Emergency control

Locking the driver's door
)Inser t the key in the door lock, then turn it
to the rear.
You can also apply the procedure describedfor the passenger doors.


Unlocking the driver's door
)Inser t the key in the door lock, then turn it
to the front.
Locking the front and rear passenger doors
) Open the doors.)
On the rear doors, check that the child lock
is not on (see Child Safety).) Remove the black cap, located on the edge
of the door, using the key.) Insert the key in the socket without forcing
it, then without turning it, move the latch sideways towards the inside of the door.) Remove the key and refit the cap.)
Close the doors and check that the vehicle
has locked correctly from the outside.



Unlocking the front and rear passenger doors
)
Pull the interior door opening control.

Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Tailgate release
Unlocking
)Fold back the rear seats to gain access to
the lock from inside the boot.)Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )Move the latch to the left.

)After unlocking the boot or the vehicleusing the remote control or the key, press
the opening control, then raise the tailgate.

Opening

Closing
)
Lower the tailgate using the interior grab
handle. ) If necessary, press down on the tailgate to fully close it.


-
when the engine is running,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,

-
when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal andthe display of an aler t message for a fewseconds.



Locking after closing

If the fault persists after closing again, the boot
w
ill remain locked. If the tail
gate is not closed correctly:

115
Access
1.Driver's electric window control.2.Passenger's electric window control.

-
manual mode)
Press or pull the control gently.The window stops when the control is
released.

- automatic mode)
Press or pull the control firmly.
The window opens or closes fully when
the control is released.) Pressing the control again stops themovement of the window.


The electric window controls remain operational for approximately45 seconds after the ignition is switched off or until the vehicle islocked after a door is opened.
If the passenger 's window cannot be operated from the driver's door controlpanel, carry out the operation from the passenger's door control panel,and vice versa.















Electric windows
Fitted with a safety anti-pinch system.
One-touch electric
windows
There are two options:
After approximately ten consecutivecomplete opening/closing movements of the window, a protection function is activated which only authorises closingof the window to prevent damage to theelectric window motor. Once the window is closed, the controls will become available again after approximately 40 minutes.

129Visibility
Welcome lighting
The remote switching on of the passenger compar tment lighting makes your access to the vehicle easier in poor light. It is activated depending on the light level detected by the sunshine sensor.


Switching on
Switchin
g off
On the outside, the welcome lighting switchesoff automatically after a set time, when the ignition is switched on or on locking the vehicle.
On the inside, the welcome lighting switches off
automatically after a pre-determined time or onopening one of the doors.
)
Press the open padlock on the
remote control; your vehicle isunlocked.

On the outside, the sidelamps and dippedbeam headlamps, as well as the side spotlamps, located under the door mirrors, come on.
On the inside, the footwell and courtesy lampscome on.
Activation or deactivation, as well as
the duration of the lighting duration for the exterior welcome lighting can
be set via the vehicle configuration menu.


Programming

1.Front courtesy lamp
2.Front map reading lamps3.Rear courtesy lamp4.Rear map reading lamps











Courtesy lamps
In this position, the cour tesy lamp comes on gradually:


Front and rear courtesy lamps



- when the vehicle is unlocked,

- when the key is removed from the ignition,

- on opening a door,

- when the remote control locking button is used to locate your vehicle.
It switches off
gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is closed.
Permanently o
ff.
Permanent li
ghting.
In permanent lighting mode, the lighting time varies according to thecircumstances:



- with the ignition off, approximately ten minutes,

- in energy economy mode,approximately thirty seconds,

- with the engine running, unlimited.
When the cour tesy lamp is in the"permanent lighting" position, the rear courtesy lamp also comes on, except if it is in the "permanently off" position.To s w i t c h off the rear cour tesy lamp, put it in the the "permanently off" position.


Front and rear map reading
lamps
)
With the ignition on, press the corresponding switch.

Take care not to put anything in contact with the courtesy lamps.