2012 CITROEN C6 DAG radio

7.38
sound quality between the different audio sources (radio, CD,CD changer...).
Check that the audio settings (Volume, Bass, Treble, Ambience, Loudness) are adapted to the sources listened to. It is advisable to set the AUDIO functions (Bass, Treble, Front-Rear Balance, Left-Right Balance) to the middle position, select the musical ambience "None"and set the loudness correction to the "Active" position in CD mode or to the "Inactive" position in radio mode.
For optimum sound quality, the audio settings (Volume, Bass, Treble, Ambience, Loudness) can be adapted to the different sound sources, which may result in audible differences when changing source (radio, CD,CD changer...).
The CD is ejectedautomatically or is notplayed by the player.

The CD is protected by an anti-pirating protectionsystem which is not recognised by the audio equipment.
The CD is inserted upside down, is unplayable, does not contain any audiodata or contains an audio format which the player cannot play.
The CD player sound is poor.
Insert good quality CDs and store them insuitable conditions.
The CD used is scratched or of poor quality.

The audio equipment settings (bass, treble, ambiences) are unsuitable. Set the treble or bass level to 0, without selectingan ambience.
The table below groups together the answers to the most frequently asked questions.
QUESTION SOLUTION
RESPONSE

FREQUENTLY ASKED QUESTIONS


- Check that the CD is inserted in the player the right way up.

- Check the condition of the CD: the CD cannot be played if it is too damaged.

- Check the content in the case of a recordedCD: consult the advice in the Audio section.

-The audio equipment's CD player does not play DVDs.

- Due to inadequate quality, certain recordedCDs will not be played by the audio system.

- The CD changer does not play MP3 CDs.

7.39
SOLUTION RESPONSE

The environment (hills, buildings, tunnels, basement car parks...) blockreception, including in RDS mode.

The aerial is absent or has been damaged (for example when going through a car wash or into an underground car park).
This phenomenon is normal and does notindicate a failure of the audio equipment.

Have the aerial checked by a CITROËN dealer.
Sound cut-outs of 1 to 2 seconds in radiomode.

During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station.
Deactivate the RDS function if the phenomenon is too frequent and always on the same route.

With the engine off,the audio equipment switches off after a fewminutes of use.

When the engine is switched off, the audio equipment operating timedepends on the battery charge.

The switch-off is normal: the audio equipment switches to economy mode and switches off to prevent discharging of the vehicle's battery.
The stored stations do not function (nosound, 87.5 Mhz is displayed...)
.
An incorrect waveband is selected.
Press the BAND AST button to return to the waveband (AM, FM1, FM2, FMAST) on which the stations are stored.

Start the vehicle's engine to increase the battery charge.

The quality of reception of the radio station listened to gradually deteriorates or thestored stations do not function (nosound, 87.5 Mhz is displayed...).

The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area through which the vehicle is travelling.
Activate the RDS function to enable the system to check whether there is a more powerfultransmitter in the geographical area.

7.43
11
223344
55
6677
1010
111
1212131314141515
88
99
01 FIRST STEPS
1. On/Off and volume adjustment.
2. Selection of the display on the screen from the modes:AUDIO, trip computer (TRIP), air conditioning (CLIM) and hands-free kit (TEL). The TEL button is not active if the hands-free kit option is not fi tted.
3. Selection of the source: radio, CD and CD changer.
4. Displaying of the general menu.
5. Cancellation of the current operation/return to the previous screen.
6. Confi rmation.
7. Automatic search for a lower/higher frequency. Selection of previous/next CD or MP3 track.


8. TA (Traffi c Announcement) function on/off.Long press: access to the PTY(radio Programme TYpes) mode.


9. Displaying of the list of local stations, of the tracks on the CD or of the MP3 directories.


10. CD eject.


11 . Buttons 1 to 6: Selection of a stored radio station. Selection of a CD in the CD changer. Long press: storing of a station.


12. Selection of the FM1, FM2, FMast and AM wavebands.


13. Selection of a lower/higher radio frequency. Selection of the previous/next CD. Selection of the previous/next MP3 directory.
14. Setting the audio options: front/rear balance, left/rightbalance, loudness, sound ambiences.
15. The DARK button changes the screen display for greater driving comfort at night.1st press: lighting of the upper banner only.2nd press: black screen display.3rd press: return to the standard display.

7.44
02GENERAL MENU
AUDIO FUNCTION:radio, CD, options.
TRIP COMPUTER: distance entering,warnings, status of functions.

TELEPHONE:hands-free kit, pairing, management of a communication.

PERSONALISAT ION-CONFIGURATION:vehicle parameters, display, languages.


> COLOUR DISPLAY C
AIR CONDITIONING:on/off and dual zone control(according to equipment).


For a detailed overall view of the menusavailable, refer to the "Display fl ow charts" part of this Audio system section.

7.45
11
22
33
44
22
44
33
11
03AUDIO
Press the SOURCE button several times in succession and select theradio.

Press the BAND AST button to select a waveband: FM1, FM2, FMast, AM.

Briefl y press one of the buttons to carry out an automatic search of the radio stations.

Press one of the buttons to carry out a manual search of the radio stations.

Press the LIST REFRESH button todisplay the list of stations receivedlocally (30 stations maximum).
To update this list, press for more than two seconds.



Select ACTIVATE FREQUENCY FOLLOWING (RDS) then press OK. RDS appears on the display.


Select the FM WAVEBANDPREFERENCES function thenpress OK.
Select AUDIO FUNCTIONS then press OK.

Press the MENU button.
FM WAVEBAND PREFERENCES
ACTIVATE FREQUENCY FOLLOWING (RDS)

The external environment (hills, buildings, tunnels, basement car parks) may block reception, including in RDS mode. This is a normal effect of the way in which radio waves are transmitted and does notindicate any failure of the audio equipment.
RDS
The RDS, if displayed, enables you to continue listening to the samestation by automatic retuning to alternative frequencies. However, in certain conditions, coverage of an RDS station may not be assuredthroughout the country as radio stations do not cover 100 % of the territory. This explains the loss of reception of the station duringa journey.


RADIO


SELECTING A STATION

7.52
11
22
11
11
22
33
22
YES

RECEIVING A CALL

An incoming call is announced by a ring and a superimposed display on the multifunction screen. Initiate the pairing between the telephone and the vehicle. This pairing can be initiated fromthe vehicle's telephone function menu or via the telephone's keypad. See steps 1 to 10 on theprevious pages. During the pairing phase, the vehiclemust be stationary with the key in the ignition.
Select the telephone to be connected from the telephone function menu.The audio system connects to a newly paired telephone automatically.
Select the YES tab on the display using the buttons and confi rm bypressing OK.

Press the steering wheel control OK to accept the call.

From the Bluetooth telephone function Audio menu, select Manage the telephone call then Call, Call list or Directory.

Press the end of the steering wheel control for more than two seconds to gain access to your directory. Or To dial a number, use your telephone's keypad,with the vehicle stationary.


MAKING A CALL
BLUETOOTH AUDIO STREAMING
(AVAILABLE DURING THE YEAR)

Wireless transmission of the telephone's music fi les via the audio equipment. The telephone must be able to manage the appropriatebluetooth profi les (Profi les A2DP/AVRCP).
*

In certain cases, playing of the Audio fi les must be initiated fromthe keypad. **

If the telephone supports the function.
Activate the streaming source bypressing the SOURCE button * . Thetracks to be played can be controlled as usual via the buttons on the Radio control panel and the steering wheel controls
** . The contextual information can be displayed on the screen.

7.53
07CONTROL SHORT-CUTS
STEERING WHEEL CONTROLS
RADIO: selection of the next stored station. CD CHANGER: selection of the next CD.Selection of the next item on a menu.
RADIO: selection of the previous stored station.CD CHANGER: selection of the previous CD.Selection of the previous item on a menu.


RADIO: automatic search for a higher frequency. CD/CD CHANGER/MP3: selection of the next track. CD/CD CHANGER: continuous press: fast forward play.
Selection of the previous item.
RADIO: automatic search for a lower frequency.CD/CD CHANGER/MP3: selection of the previous track.CD/CD CHANGER: continuous press: backward play.Selection of the next item.


Volume increase.
Volume decrease.
Mute: by pressingthe volume increaseand decrease buttonssimultaneously.
Restore the sound bypressing one of the two volume buttons.
- Change of sound source. - Confi rmation of a selection. - Pick up/Hang up the telephone. - Press for more than 2 seconds: access to the telephone menu.

7.55
123
23
1
2
3
4
3
4
3
4
2
3
4
3
4
3
3
3
2
1
2
2
1
2
3
2
3
4
4
4
4
4
4
09
3
3
3
2
3
3
3
3
3
date and time adjustment
day/month/year adjustment

hour/minute adjustment

choice of 12 h/24 h mode
py
DISPLAY FLOW CHART display C
TRIP COMPUTER
MAIN FUNCTION

*

The parameters vary according to vehicle (refer to the "Multifunction displays" section).


CHOICE A

choice A1

choice A2


CHOICE B...


track random play (RDM)

activate/deactivate


FM BAND PREFERENCES


alternative frequencies (RDS)

activate/deactivate


regional mode (REG)
activate/deactivate


radio-text information (RDTXT)

activate/deactivate


AUDIO CD PREFERENCES
CDchanger repeat (RPT)
activate/deactivate
ENTER DISTANCE TO DESTINATION
distance: x km

WARNING LOG
diagnostics

video brightness adjustment

normal video

inverse video

brightness (- +) adjustment
STATUS OF FUNCTIONS *
functions activated or deactivated
PERSONALISATION-CONFIGURATION
DEFINE THE VEHICLE PARAMETERS
*
DISPLAY CONFIGURATION


CHOICE OF LANGUAGE


Deutsch


English

Espanol

Français


Italiano


Nederlands


Portugues

Portugues-brasil